Question about 1999 Infiniti.5 QX4

1 Answer

1999 infiniti QX4 hazard lights, flash went the weather gets damp and there is noise close to the car...the doors keep locking during this time

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Infiniti Master
  • 76,848 Answers

This needs to go the dealer to have the Body Control module (BCM) scanned for function problems, all these systems are computer controlled.

Posted on Feb 11, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1998 infiniti QX4 break squeeling

some times it might be that it just needs to be sanded down or there is too much break dust. so just spray it down with a power wash and if it doesn't work try to sand down the roaters. but be carefull.

Posted on Jun 28, 2008

hiseyj
  • 99 Answers

SOURCE: how many catalitic converters are on the 2001 infiniti QX4

There are only to Catalysts monitored by the ECM. There is a wide pipe near the front of the exhaust system that looks like it houses a catalyst, but it doesn't. Look for the rear O2 sensor, that is where the catalyst is. If the bolts that hold it on are not badly rusted, and depending on your mechanical aptitude you could replace them, otherwise take it to a shop. Have you checked the warranty coverage with the dealership?

Posted on Nov 26, 2008

  • 14036 Answers

SOURCE: were can i locate knock sensor on infiniti qx4

located on the bottom side of engine.

Posted on Apr 25, 2009

  • 5 Answers

SOURCE: how much oil does the 1999 infiniti qx4 hold (when

5 quarts

Posted on Aug 06, 2009

  • 312 Answers

SOURCE: Pls where is Swirl Control Solenoid Valve located in Infiniti QX4

This link shows the location of the SCV, If your motor is different the location should be similiar. http://img510.imageshack.us/img510/5687/vacuumdiagramuh3.jpg

There's a vaccuum line that runs off the SCV to the SCV check switch.

P0442: Have you inspected the lines, charcoal cannister etc? Make sure the fuel cap is tight. The easiest way to check the system is to have someone perform a smoke test. I had a DTC on my car which indicated a EVAP problem, it turned out to be the Fuel tank evaporator Control Solenoid.

Posted on Sep 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mercedes a class 140 1999. Rear passenger door won't close or lock also turning ignition on hazard warning lights are flashing


Might be the harnes that is fixed to the boot lid hinge .Take a look at the cable running up inside it if its broken or damaged .Or the location of the wires, that go from the door to the body they are in a type of rubber concertina on most doors.

Aug 06, 2016 | Mercedes-Benz Cars & Trucks

1 Answer

I have a 2002 qx4 and the alarm goes off for no apparent reason. If you shut it off it will just go off again. All doors and windows are closed and locked. It just alarms for the heck of it. Bought a new...


Check the hood pin switch for the alarm, you could of pushed it down a bit when installing the battery so that when the hood is closed it barely opens the switch. Any amount of moisture will make it have contact...also, check the door switch in the door jam. one of them could be bad. if you walk around the car and push on each door individually, you might be able to manipulate it into messing with the alarm or door ajar light. Or just open the door and press it with your finger and see if you find the bad one---I hope this helps.

Jul 06, 2011 | 2004 Infiniti QX4

1 Answer

1999 Infinity QX4. Door Open warning light


usually on post where door closes, or in jamb by hinge area. Open door & try pushing any button/pin like object or may be a lever style too, with thumb or finger.When interior light goes out, you found it

May 03, 2009 | 1999 Infiniti.5 QX4

1 Answer

Remote locks the doors but will not unlock doors or trunk Battery


It is entirely possible that the unlock button on the remote is worn such that it is not making contact. I've seen this happen many times, as the unlock button is pressed so much more than lock. You might try to reprogram the remote first before you look into getting a new remote. The procedure goes like this. Close and lock all doors Key in and out of the ignition 6 times, hazard lights should flash twice Turn key into accessory or on position Unlock and lock doors with drivers switch Press lock or unlock on remote Hazards should flash again to verify recognition turn key off  manually unlock door and then open and shut it.  you should then be able to test remote. 
The key to the procedure is doing step two quickly Hope this helps, if not you may need another remote or see dealer.

Apr 11, 2009 | 2004 Infiniti I35

1 Answer

1999 NISSAN ALTIMA KEYLESS REMOTE PROGRAMMING


1999-2003
Enter vehicle, close and lock all doors.
slowly insert and remove key from ignition 6 times within 10 seconds. The tail lamps will flash to indicate original code has been erased. Turn ignition to the ACC position.
Press any button on 1st transmitter.
Hazard lamps will flash to confirm programming.
TO enter additional transmitters, unlock then lock the doors using the power lock switch located on the driver door.
Press any button on additional transmitter (up to 4 tansmitters total possible). Hazard lamps will flash to confirm programming.
open the driver's door.
Turn ignition off.

You must re-program all existing transmitters as this process erases codes from car.

Jun 25, 2008 | 1999 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...