Question about 2005 Kia Amanti

Open Question

How do u clean throttle position sensor kia amanti

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: transmission filter in a Kia Amanti

you have to take the trransmission man off (drain the fluid first) and the rest you will be able to see how to do. i think there are 2 bolts that you have to remove to get the filter out

Posted on Jan 11, 2009

  • 7353 Answers

SOURCE: 2004 Kia Amanti. Does not hold idle. Smoke and gas

Dont trust a wrecker driver. theres a reason they tow cars and not work on them. have a qualified shop check it and recommend repairs. you dont want to waste money guessing.

Posted on Oct 02, 2009

chuckster57
  • 1102 Answers

SOURCE: I have a 2004 Kia Amanti with a "Check Engine"

P0302 is a cylinder misfire detected in cylinder #2. it can be caused by Bad spark plug,failed plug wire or coil pack, or failed injector. these are the most common reasons in most likely order.

Posted on Sep 19, 2011

alicantecoli
  • 22095 Answers

SOURCE: 2005 Kia Amanti dies

Forget the code reader on this car ,the only one that counts is the kia plug under the bonnet and you cannot read this one as encrypted software is used,Use a automotive multimeter to test the O2 sensor on the down pipe and the one after the cat as well ,the two white wires should read 12v with the plug out and from car and with plug out they should show a continuety on the sensor itself then reconnest the sensor and check the voltages on the other two wires and you should see a variation of the voltage as engine is reved up .But on reading your question again and then again i suspect that you may havce a blocked cat which has been caused by the defective O2 sensor or a engine thats been overfilled with oil or even a dodgy valve guide allowing excess oil consumption .If i had my head under the bonnet for a while i would soon work out whats wrong but from afar as you appreciate its a lot more difficult to give a complete diagnosis

Posted on Nov 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car not taking the gas,code p2122 and p2127


check your aps sensor,accelarator position sensor if its bad and make sure all connector and wire from this sensor to ecu is good,.

Mar 09, 2015 | 2004 Kia Amanti

1 Answer

Accelerator pedal sensor


there is no pedal sensor... there is a throttle position sensor located on the throttle body (near the MAF). Replacing it is simple and self explanatory once you locate it.

Feb 07, 2014 | 2004 Kia Amanti

1 Answer

Kia Amanti Ignition failure sensor


Code p0320 refers to crank shaft position (CKP) sensor/engine speed RPM sensor-circuit malfunction===causes---wiring CKP/RPM sensor ---ECM. Get your hands on an aftermarket workshop manual for the car and you should be able to replace the items

Dec 27, 2013 | Kia Amanti Cars & Trucks

1 Answer

Mysterious Electrical Problem


93k is getting close to timing belt replacement. Check engine light comes on when getting close to 90 - 100k. Timing belt needs to be replaced every 90 - 100ks.

Aug 14, 2013 | 2004 Kia Amanti

1 Answer

Where is location of throttle position sensor on ford fusion 2010 eng 2.5


It should be mounted on the throttle body,where the throttles shaft is...

Sep 24, 2012 | 2006 Kia Amanti

1 Answer

Is the tps sensor the same thing as an app sensor


No, your car is a fly by wire. This means there is no throttle cable its all electronic. The tps is the throttle position sensor, and the app is the accelerater pedel positon sensor.

Dec 16, 2010 | 2005 Kia Amanti

2 Answers

Kia Amanti 2004 trouble Codes


the p2127 code is an Accelerator position sensor (low input) as is the p(2138) could be moisture or debris in harness plugs. Try using dielectric grease.

Jan 23, 2009 | 2004 Kia Amanti

Not finding what you are looking for?
2005 Kia Amanti Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...