Question about Holden Barina
1995 holden barina
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It’s located on the driver’s side of the engine on top /side of the head.. midway.. I don’t think you need to remove the engine cover to see it.. if it is the correct one it will have a dark green top.. the bad version has a black top… but they can all go out to lunch on you if old enough.
To replace.. make sure the car is cool..
You need a hood tool.. or small pair of pliers to remove the retaining clip that holds it in place.
Place a rag under and around it to catch the coolant.. you will lose less than a half a cup.. if that.
Pull the retaining clip back toward you.. try not to drop it.. (another good reason for the rag)
Wiggle the sensor.. pop it out.. and replace with the new green top one make sure you clean the area well.. and when you reinstall the new one that the c clip goes back on straight or it will leak.
Once you see the part out of the box.. you will understand how it works
Start the car.. check for leaks.. run until warm with the heater on.. top up the coolant overflow bottle with distilled water.. (if more than a half a cup.. you should mix the proper anti freeze and distilled water and then top up with that)
Posted on May 06, 2009
SOURCE: Holden Barina 1996 Car is
Hi! Was the thermostat and other items replaced due to this overheating? you say coolant level full? maybe your header tank is full but the system isn't? Try bleeding the system. From cold, start the engine with radiator/header tank cap OFF stay with the vehicle and have some very warm water handy. DON'T look over the filler but watch it as the car gets to operating temperature if the water drops drastically top it up with warm water again stay with the car it may take a long time to level out. If the car is bubbling furiously and doesn't want to settle then possible HEAD GASKET Failure or Water pump.
Does your oil look milky on the dipstick? is there an excessive amount of water coming out of the exhaust? are your hoses swelling with radiator/header tank cap on at operating temp?
Sorry to be the possible bearer of bad tiding if the Gasket has gone, but better to sort it now than cause irreprable damage?
Posted on Dec 03, 2008
located under intake in water crossover pipe,you can access the sensor by removing intake chamber box,then pcv hose connected to the block,the connector is orangeish 2pin,use a 19mmdeep socket on a 3/8 ratchet to get it loose,make sure engine is cool,also make sure there is a new brass washer with your new sensor,sometimes the old washer comes off when removing the sensor,sometimes it sticks to the pipe,some coolant will escape so make sure to top it off
Posted on Jul 14, 2009
Tips for a great answer:
Jul 10, 2017 | Holden Cars & Trucks
Nov 17, 2016 | Holden Barina Cars & Trucks
Apr 05, 2016 | Holden Cars & Trucks
Feb 05, 2016 | Cars & Trucks
Sep 17, 2015 | Holden Cars & Trucks
Sep 06, 2014 | Cars & Trucks
Jul 11, 2014 | Holden Barina Cars & Trucks
Dec 04, 2013 | 1996 Ford Probe
702 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: