Question about 2002 Mitsubishi Galant

Open Question

I have a 2002 mitsubishi Galant I add coolant and it leaks out on the pass anger side when the car is not running the hoses are on the drivers side and is not leaking there what is the next area to look

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Ajkill
  • 2035 Answers

SOURCE: 2002 Mitsubishi galant

Remove the drive belts, crankshaft pulley, and timing covers. Align the timing marks on the camshaft and crankshaft and r+r the belt

Posted on May 15, 2008

Ad
  • 2 Answers

SOURCE: car leaks water inside when running A/C

evaporater is clogged

Posted on Sep 07, 2008

  • 120 Answers

SOURCE: service engine light on 2002 mitsubishi galant

it could be the spark plugs, at least that is what it was for mine, if you have over 50k miles without a spark plug change i highly suggest one, also a oil /transmission change would be great for your car too if you haven't done those reciently. I would also suggest using a higher grade gas, sometimes this fixes the trick too.
If you try all those and still experiencing hard transitions please let me know and i'll try a more indepth analysis on your car.
Thanks jyotsna.

Posted on Nov 13, 2008

  • 1 Answer

SOURCE: 1999 mitsubishi Galant - water leaks on the drivers side

I have the same exact problem.....1999 Galant! The water is in the center of the floor board and also under the seat to the back floor board!!

Posted on Nov 17, 2008

  • 2 Answers

SOURCE: 2002 mitsubishi galant

Has it overheated lately?
My wife overheated our Galant and it just stopped working, it cranks but that's it.
I pulled the sparkplugs and found them wrapped in a gewey jelly like substance. Like an oil/antifreeze combo.
I am going to replace the entire motor for $1000 as taking it to the mechanics to theorize and practice may cost more.

Posted on Dec 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Coolant is leaking. Was told it was the water pump, but a mechanic said that it was one of the smaller hose in the back beyond the engine. What is he talking about?


That hose goes to the heater core,their are 2 hoses,one going to it and the other leaving it,could be just the clamp is loose,tighten it and wipe up the coolant and check again after awhile,will need to add coolant to your reservoir.Here's a link to your heater core's hoses,it's number 9 on the picture. GET 35 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS

Sep 27, 2015 | 2002 Mitsubishi Galant

3 Answers

Galant overheating


water pump and head gasket is giving problem......the cooling fan is working?

Jul 15, 2014 | 1999 Mitsubishi Galant

1 Answer

Coolant leak


check hose clamps on the heater radiator. Check for cracked hoses or leaking heater radiator. Best way is to have a radiator pressure yest done and check for leahs as the pressure drops

Feb 01, 2013 | 2000 Mitsubishi Galant

1 Answer

Car overheated and lost all power. how do I get it to start?


ENGINE NOT GOING TO START IF GET TOO HOT FIRST THING I WOULD REPLACE THERMOSTAT AND RADIATOR PRESSURE CAP THEN ADD COOLANT UNTIL COOLANT LEVEL CORRECT THATS WHEN THERMOSTAT OPEN UP AND TOP HOSE HOT.CHECK FOR LEAKING RADIATOR HOSES CHECK TOP RADIATOR HOSE CHECK BOTTOM RADIATOR HOSE.CHECK FOR LEAKS AROUND THE RADIATOR LOOK DOWN BELOW COOLANTS FANS CHECK FOR LEAKS AT RADIATOR CORES OR LEAKS AT THE RADIATOR PLASTIC SIDE CONTAINERS. CHECK FOR LEAKS AT WATER PUMP WEEP HOLE AND CHECK FOR LEAKS AT THE HEATER HOSES AROUND ENGINE BLOCK TO THE HEATER CORE HOSES. THERE IS A REASON CAR OVERHEAT.IF CAR OVERHEAT WHILE DRIVING YOU HAVE FAULTY THERMOSTAT OR LEAKING OUT COOLANT OR BLOWN HEAD GASKET.IF ENGINE OVER HEAT WHILE SITTING DURING A LONG IDLING PERIOD.YOU COULD HAVE FAULTY COOLANT TEMPERATURE SENSOR OR FAULTY COOLING FAN FUSE OR RELAY.HOT WIRE COOLANT TO SEE IF IT RUNS IF NO REPLACE FAN MOTOR. IF YES FAN MOTOR COULD HAVE FAULTY WIRE OR PCM FAILURE. CHECK ENGINE CRANKCASE IF OIL LOOKS LIKE MILK SHAKE ENGINE HEAD GASKET LEAKING.

Nov 26, 2010 | 2002 Mitsubishi Galant

1 Answer

Coolant is leaking into the car


Check the evaporator drain, its possible that are clogged (under carpet, under dash passenger side).

Good luck.

May 25, 2010 | 2000 Mitsubishi Galant

1 Answer

Change the thermostat in the galant.


1. Raise the front of your Mitsubishi Galant with a jack and lower onto jack stands, or use wheel ramps. Disconnect the negative cable from the battery. Drain the coolant into a suitable container by opening the drain plug on the bottom of the radiator.
2. Step 2 Follow the upper radiator hose to where it meets the engine at the thermostat housing. Loosen the clamp at the engine end of the radiator hose and pull the hose off the thermostat housing.
3. Step 3 Remove the two bolts on the thermostat housing cover and pull off the cover. Note the position of the old thermostat and remove it from the thermostat housing. Place a rag in the thermostat housing and scrape any gasket residue from the inside of the thermostat housing cover.
4. Step 4 Take out the rag and insert the new thermostat in the same position as the old one, with the spring-side facing into the engine. Install the new gasket or o-ring, depending on the type of thermostat you are installing. Note that most late 1980s and early 1990s Galant models use a thermostat gasket.
5. Step 5 Replace the thermostat housing cover and tighten the bolts. Re-attach the radiator hose and tighten the clamp. Fill the radiator with new coolant, or use the coolant drained from your Galant earlier if it's relatively new and clean.
6. Step 6 Start your Mitsubishi Galant and run with the heater on high until it reaches operating temperature. Make sure the heater is blowing warm air to ensure the thermostat is working properly. Check for leaks and tighten the radiator hose clamps if you detect any.

Oct 25, 2009 | 2000 Mitsubishi Galant

1 Answer

2002 Mitsubishi Galant has water draining into the


the ac drain is more than likley stopped up, they tend to get clogged with debri not allowing the condensation from the evap. core to drain properly, thus allowing it to leak into the floorboard.

Sep 16, 2009 | 2002 Mitsubishi Galant

3 Answers

01 Galant leaks water on the driver?s side floor boards


the ac drain is clogged up,so it does not drain outside,check pass.side-pull carpet away from fire wall and padding should be wet

Jul 30, 2009 | 2001 Mitsubishi Galant

1 Answer

My 2002 Galant is leaking water inside my car on the drivers side


Your heater core is leaking. I'm guessing that when you turn on the vents for heat or a/c, you are probably getting vapor/steam inside the car. If this is the case, you need to have your heater core replaced.

May 09, 2009 | 2002 Mitsubishi Galant

Not finding what you are looking for?
2002 Mitsubishi Galant Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...