Question about 2002 Buick Century

Open Question

How to replace gear shift bulb for buick century 2002

Gear shift indicator bulb replacement

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jeffk14
  • 16 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

TRY THIS. Good luck!

Posted on Nov 22, 2008

Ad
Papa Chan
  • 56 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Posted on Jan 04, 2009

emissionwiz
  • 76164 Answers

SOURCE: Need to replace tail light bulb on 1996 Buick Century

Inside the trunk, under the carpet behind the tail lights will be a whole bunch of small plastic nuts, running from one side of the car to the other. Take all of these plastic nuts off, and the whole tail light assembly will come off in one large piece. Find the bulb you need to replace, and reassemble

Posted on Apr 06, 2009

  • 548 Answers

SOURCE: how do i replaced the dashboard light for the

this is a process and I would reccomend you get the manual either from your local library or that you buy one from your local autoparts or book store. you have to take the dash apart to do this and it is rather complicate and has many connectors hidden and othwerwise and the manual will help greatly

Posted on Aug 26, 2009

  • 1986 Answers

SOURCE: How do I replace broken 2002 buick century passenger side mirror?

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 buick lacrosse console gear indicator bulb


Transmission Floor Shift Control Indicator Lamp Replacement

Remove the front floor console. Refer to Front Floor Console Replacement.
Rotate the floor shift control indicator lamp socket (2). Pull the socket from the trim bezel.
Remove the bulb from the socket.

Front Floor Console Replacement

Preliminary Procedures
Remove the rear floor console. Refer to Rear Floor Console Replacement.
Remove the instrument panel lower trim plate. Refer to Instrument Panel Lower Trim Plate Replacement.
Set the parking brake, then shift the transmission into drive and push the shift indicator down until it locks, to allow clearance to remove the console.
1
Front Floor Console Screw (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Tighten
2 N·m (18 lb in)
2
Front Floor Console Bolt (Qty: 2)
Tighten
10 N·m (88 lb in)
3
Front Floor Console Assembly
4
Front Floor Console Retainer Clip (Qty: 2)

Feb 24, 2017 | 2009 Buick LaCrosse

1 Answer

I have 2002 buick centry and the odometer, trip meter, gear shift indicator light is out. How can this be fixed? Is there a recall on this problem?


I had this same problem with mine. Dealer wants $500.00 for a new instrument panel. realI only need to replace four resistors in the panel. parts $1.25. Time? about an hour if you already have parts and a sottering iron or gun. I found a video on youtube shows how to do it. It was easy.

https://www.youtube.com/watch?v=ebTS25sNOHQ&list=PLC83D60B4A4D42DE2&index=3&feature=plpp_video

Nov 05, 2012 | 2002 Buick Century

1 Answer

Cluster light for gear shift is out. 2000 Buick Century. How to repair?


well if this is a clomun shift u need to pull the dash cluster out u may need to pull some dash trim panels off to get at screws or small bolts most trim panels are held in with clips then make sure u pull the small bolts or screws that hold the whole dash cluster in carefully pull cluster and unplug any wire harness as thier should not be any speedo cable on a 2000 model on back side of cluster u will find bulb hold in tabs find the one for shift indicator and replace installation is in reverse mode hope this helps

Jan 02, 2012 | Buick Dawn Centercockpit Ketch Cars &...

1 Answer

On my 2000 buick century custom, the light behind the odometer and gear shift is out, is there a bulb to replace or does the whole cluster need to be replaced? and any tips as to how to get at it.


There is a bulb that you can replace and to get at it there are two screws if i remember right that you need to take out for the actual cluster unit and the rest you can pop off with a screw driver.

Have a good one!

Feb 24, 2011 | 2000 Buick Century

1 Answer

Dash indicates transmission is always in Drive. Transmission shifts through all gears but indicator does not change. Vehicle will not start.


You have a electronic Shift indicator switch on your transmission this is also called th NSBU switch. This is what tells your instrument cluster what gear you have selected. This may be your problem. or you may have a loose or bad connection. NSBU stands for neutral safety Back up switch.

Feb 06, 2011 | 2002 Buick Century

1 Answer

I replace the back-up bulbs for the my 1999 buick century but no lights are coming on when i back-up


Hi if you have replaced the bulbs and you still have no reversing lights then this is a good indication that the revers light switch on the gear box needs replacing, get this replaced and this should then solve your problem

Apr 25, 2010 | 1999 Buick Century

1 Answer

Instrument cluster panel


Not a Fuse. There are Small Bulbs on the Back of the Guage Cluster that Burn out Occassionally. You will need to Disassemle the Dash and Remove the Guage Cluster to get to these Mini-Bulbs for Replacement. Please Rate my Solution, I need all the Help that I can Get! Thanks!

Jan 29, 2009 | 2002 Buick Century

Not finding what you are looking for?
2002 Buick Century Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...