Question about Land Rover Freelander

Open Question

Hi i have a 2002 freelander and i have noticed a clunking noise comming from rear end of the car when i am changing up the gears! could anyone give me any helpful advice please Thank you

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1779 Answers

SOURCE: Clunk noise from rear of truck

How about the U joint? If it's shot, you will hear a clunk when u start up. You probably already know, but jack up the back of the truck (both wheels off the ground) make sure u blocked front wheels front and back so it can't roll, use jack stands so u don't get squished, truck in neutral, e- brake off, climb under, grab driveshaft and twist back and forth to see if there is slop or play in the rear universal joint. Let me know what u find. Good Luck, and don't get squished (or squashed). countrycurt0

Posted on Sep 30, 2008

  • 4 Answers

SOURCE: rear end thumping noise

its your tyre, if it sounds like a flat when you drive your tyre has warped very difficult to see on a normal inspection, we get it a lot in spain.

Posted on Nov 11, 2008

Landyman
  • 89 Answers

SOURCE: HOW TO CHANGE THE TIMING BELT ON A 2002 LAND ROVER FREELANDER

Engine ?

Posted on Nov 16, 2008

  • 653 Answers

SOURCE: 2002 ford Ranger 3.0 v6 (auto) rear end noise when accelerating on curves.

Grab the bed of the truck and vigorously rock the vehicle from side to side. If you hear clunking in the axle, you probably need to check the carrier bearings in the differential. I had the carrier bearings, wheel bearings, and seals replaced in my mother-in-law's 1991 Ranger for $280, and it rides like a new truck. Well, ok, it rides like an 18 year old truck with a new rear end. I provided the wheel bearings and seals to the shop, and they provided the carrier bearing, lube, and labor. While the axles are out, check the surface where the axles ride on the bearings. If they are worn, there are undersized bearing available, but it is usually cheaper and easier to just by new axles.

Posted on Feb 12, 2009

  • 6982 Answers

SOURCE: clunking in rear end Jeep Liberty 3.7 automatic

Nearly impossible to tell you what it is without actually hearing and seeing it. I recommend that you check the rear universal joint, pinion bearing and wheel bearing assemblies for looseness. If it's that loud it shouldn't be too hard to find.
Good luck!!! If you need help doing the repair or have other questions just ask!!!

Posted on Mar 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is there strut and axle noise in rear?


2005 TrailBlazer Clacking and Clunking From Rear End ...

? 4:10
https://www.youtube.com/watch?v=HIA151KxImM
Mar 14, 2013 - Uploaded by sameasiteverwas122
2005 TrailBlazer Clacking and Clunking From Rear End ...Trailblazer clunking noise over bumps (the number 1 and 2 ... How To Find Suspension Noises 101 - EricTheCarGuy - Duration: 23:57. by EricTheCarGuy 1,497,067 views ... How to Install a Water Pump: 2002 - 2009 Chevrolet Trailblazer 4.2L L6 ...

Trailblazer Driveline Noises Discovered - YouTube

? 2:27
https://www.youtube.com/watch?v=GLhTUoHWdNM
Nov 4, 2013 - Uploaded by Roland Caston
the Trailblazer has developed some nasty noises. ... loose in thedifferential and the right front strut has torn through it's bushing.... How To Install Replace Front Axle Disconnect Housing 2002-09 GMC Envoy Chevy Trailblazer ... How Much Abuse Can a Trailblazer Take Part 2 : How to Replace a Rear Axle ...

Noise coming from back on trailblazer - YouTube





Jan 01, 2016 | 2002 Chevrolet TrailBlazer

1 Answer

Have a 2004 polaris ATP 500 when turning there's a clunking noise I changed wheel bearings and noise still there ! Checked u joints not really a lot of play in them!


2011 Sportsman 500 Trans Clunk - ATVConnection.com ATV Enthusiast ...

atvconnection.com/.../polaris/343211-2011-sportsman-500-trans-clunk.h...
Mar 21, 2012 - It is really noticeable when wheel is turned when you get on the gas from a. ... 2011 Sportsman 500 Trans Clunk ... You have to figure from the motor to the clutches,then to the transmission,then to the drive shafts,there is going ... 1999 Sportsman 500,slight clunk from dead stop
Feb 28, 2015
Clunk or pop in the steering on an 07 Sportsman 500 ...
Aug 8, 2008
500 HO, rear end noise
Apr 29, 2006
clunking noise on scrambler 500...
Jan 31, 2000
More results from atvconnection.com

Sep 25, 2015 | Cars & Trucks

1 Answer

Rear knocking noise


I had a similar problem with 03 Dakota Quad Cab. I have the towing package withe positrac rear end. The rear end was giving some pretty good clunks especially noticeable in reverse. Had the rear differential oil service done with recommended additives. Noise is gone. A second problem I had was the lower steering shaft assy u joints were worn. Steering "klunked". Changed out the shaft and klunk disappeared. Good Luck!

Aug 05, 2013 | 2003 Dodge Dakota Club Cab

1 Answer

I have a thud noise sometimes when my freelander td4 2002 changes gear usually going from 1st to 2nd gear.. I think it may be a dif mount, also someone said to me about a fluid that may be low??? Anyone...


Have the u joints, transmission mount and half shafts inspected. These would be the most likely problems. Let me know what you find. I would use a trusted technician in your area to at least inspect it. If this is something you want to tackle, let me know that too.

May 20, 2011 | 2002 Land Rover Freelander

2 Answers

Loud Clunking when jeep starts moving in drive.


may be the gears in the rear end or check your motor mounts, ive had the noise and it was motor mounts

Dec 06, 2009 | Jeep CJ7 Cars & Trucks

1 Answer

Clunking popping noise from rear end when tires


the gears in your rear end are probably chipped and broke or need shims

Oct 25, 2009 | 2002 Chevrolet Silverado

2 Answers

I have a nocking noise from front of my freelander


hi, im not a mechanic but i had similar problem with my freelander and it was the ird unit (or transfer case ). the shims thorned and there was some damage to the gear

Sep 25, 2009 | 2002 Land Rover Freelander

3 Answers

Rear end


clunking or grinding noises, wont accelerate to full potential,

May 07, 2009 | 2001 Ford Ranger Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...