Question about Ford Five Hundred

Open Question

How do i change the keypad code for a 2005 ford five hundred?

I bought a used 2005 Ford five hundred and it didn't come with the keypad code for the door. is there any way to change the code myself without taking it to the dealership?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 93 Answers

SOURCE: how to reset factory code on keyless entry ford five hundred

if you do not already know the factory code, the only way it can be obtained is by your local ford dealer. the proprietary computer equiptment they have can access the code that is programed in vehicles security module. if you purchased it used..it is often that the keyless entry code id card is still withe the owners manual..it is a 5 digit code printed on an credit card sized card that is white in color..i hope this helps you...good luck

Posted on Jun 09, 2009

  • 154 Answers

SOURCE: Cold cranking amps - 05 Ford Five Hundred

You can buy a battery with as many cca as you like as long as the battery fits your battery box. The cca is how long you can crank motor befor you run out of power If you can get a 700-750 cca battery you will be fine. But you could do with a 450-500cca battery if you want. But I wouldn't go less than that especially if your running the v8

Posted on Jul 25, 2008

  • 2 Answers

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

Posted on Mar 16, 2009

roniecon
  • 6826 Answers

SOURCE: = 07 ford five hundred ac problems

First off,is the ac compressor turning?If so are the large line,near where you put freon in,cold?If the low side lines(large lines)are cold and sweating,and the evaporator box is dripping water on the ground,then the ac is most likely fine.There is a temp door in the ac blower box,that moves for hot,or cold when you select these comfort levels.This door is most likely controlled by a actuator motor.This motor is most likely bad.If it is control by vacuum,look for a broken vacuum hose,or one that has come loose under hood.

Posted on Aug 26, 2009

  • 1 Answer

SOURCE: I have a 2005 Ford five hundred and the

You need to have the transmission serviced. The wrench indicates that the fluid in your transmission is out of spec or you have an out of spec pressure condition.

Posted on Oct 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why won't it idle above 1000 rpm?


no supposed to idle higher than that , usually even less .

Sep 24, 2015 | 2006 Ford Five Hundred

1 Answer

I need keypad entry code to 05 ford five hundred


mine was on a little card in the flap of my owners manual.. I purchased my car 10 months ago and it was in there when I was thumbing thru the manual

Jan 02, 2014 | 2005 Ford Five Hundred

1 Answer

2005 ford five hundred flasher


According to the book, the relay is incorporated into the smart junction box. There may not be an actual relay you can replace.

Jul 11, 2013 | 2005 Ford Five Hundred

1 Answer

005 ford five hundred with code po942


You have a shop with no data base such
as Alldata,Mitchell or Identifix !!

Mar 06, 2013 | 2005 Ford Five Hundred

1 Answer

Can i get code from a ford five hundred with out a tester


No---- not on any OBD2 System (1996 thru 2013)

A code reader is $60 & up ---everyone needs one

Nov 25, 2012 | 2005 Ford Five Hundred

1 Answer

I have a 2005 Ford Five Hundred and the ''wrench'' warning light came on. It is a AWD. What does it mean and what could the probable cause be?


It simply means that its time for routing service and maintenance on your car. This will normally be reset when you take it in for an oil change. 1. Ford has issued a Special Service Message (SSM), stating that the owner's manual procedure is incorrect, and giving a revised procedure. The following is the text of the SSM:

18562 2005 FREESTYLE/FIVE HUNDRED/MONTEGO - OIL LIFE RESET PROCEDURE
THE 2005 FREESTYLE, FIVE HUNDRED, AND MONTEGO VEHICLE OWNER'S GUIDE OIL LIFE RESET PROCEDURE IS INCORRECT. TO RESET OIL LIFE ON VEHICLES WITHOUT MESSAGE CENTER, USE THE TRIP/RESET BUTTON TO TOGGLE THE ODOMETER DISPLAY TO 'OIL LIFE XX%'. THEN PRESS AND HOLD THE BUTTON FOR 10 SECONDS TO RESET TO 100%. THE INSTRUMENT CLUSTER WILL BEEP WHEN THE OIL LIFE IS RESET.
FOR VEHICLES WITH A MESSAGE CENTER, PRESS 'SETUP' TO DISPLAY 'PRESS RESET FOR SYS CHECK'. PRESS AND RELEASE 'RESET' TO START SYSTEM CHECK. WHILE 'OIL LIFE XX%' IS DISPLAYED, PRESS AND HOLD 'RESET' UNTIL 'IF NEW OIL HOLD RESET' IS DISPLAYED, THEN RELEASE. PRESS AND HOLD 'RESET' AGAIN UNTIL 'OIL LIFE SET TO 100%' IS DISPLAYED. THE INSTRUMENT CLUSTER WILL BEEP WHEN THE OIL LIFE IS RESET.
EFFECTIVE DATE: 04/20/2005

Aug 15, 2012 | 2005 Ford Five Hundred

1 Answer

I need to reset the ani theft system in my ford five hundred 2005, what can i do??


Sometimes jus using your keypad unlock and lock your doors with it if that don't work try your manual perhaps a code could be entered into your radio to disable the theft system!!

Dec 21, 2011 | 2005 Ford Five Hundred

1 Answer

2005 Ford Five Hundred 3.0L Hesitational take off cleaned throttle plate and codes p2111 and p2104 still set. Looked in Mitchells and they're telling me to replace PCM. Any other solutions?


You have one bad COP Igniton Coil

The coil is not grounding out in the PCM

A signal is coming back to the TPS Sensor
& you loose it's signal

The PCM then doesn't know throttle position %
and sets a 2104 & 2111 & you think that you have
a bad Throttle Body Motor (TACM)

A dealer will charge you $1000.00 & fix nothing

Buy one coil for $35 to $50.00 & install yourself
You may have to walk the new coil around a few times
& drive the car 30 miles each time, until you get the bad coil

Repair shops are not good with Fords & Dealers are useless

You should have other Misfire Codes & lots of them

Give them to me

Jul 21, 2011 | 2006 Ford Five Hundred

2 Answers

CLICKING NOISE FROM RIGHT DASH ON A 2005 FORD FIVE HUNDRED?


Air/Blend Door Actuator Modual is defective: See info below
Description : Temperature Actuator Attributes : Controls the blend of hot & cold air Make : Ford Brand : Dorman - OE Solutions
Application Notes:
Please select Detailed Applications
for Application Note information. 604-203-007.jpg

Mar 14, 2011 | 2005 Ford Five Hundred

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...