Question about Cars & Trucks

1 Answer

Colors of wires of MAF sensor in 2001 VW golf gti vr6

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,874 Answers

2001 VW Golf GTi VR6
On the MAF sensor connecting plug you will see 5 pin numbers. Each pin number correspond to a wire color:
Pin no.# 1 = violet/green, is comming from pin no.# 26 of ECM. ECM = Engine Control Module.
Pin no.# 2 = blue/yellow, is comming from fuse no.# 43 = 10 Amp. (battery plus is comming through a blue wire from pin no.# 23 of fuel pump relay).
Pin no.# 3 = green, is comming from pin no.# 27 of ECM.
Pin no.# 4 = red/violet, is comming from pin no.# 53 of ECM.
Pin no.# 5 = black, is comming from pin no.# 29 of ECM.

Wiring diagram:

colors of wires of MAF sensor in 2001 VW golf gti  - 2_11_2012_8_32_32_am.jpg

Posted on Feb 11, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2001 VW GTI VR6 alarm goes off randomly... make it

could possibly be a faulty latch. door latch, trunk latch, hood latch. something sporadically not recognizing a closed latch to cause it to go off sporadically. a scan with a vw scan tool or a vag com should detect a fault in the convenience system.

Posted on Nov 09, 2009

  • 8 Answers

SOURCE: I want to put turbo to my Golf GTI VR6 98'

the amount of money and time it would require to turn your N/A (naturally aspirated) into a forced induction car(turbocharger, or supercharger), you would require the buttom end to be built, fueling, exahust, ecu(computer) forged rods/pistons/ then the turbo or super charger, also alot more, if you go to vwvortex.com and click on the forums and look around, you can see the different setups people are running on their VW's AUDI's

Posted on Jan 22, 2010

  • 88 Answers

SOURCE: i need a wiring diagram for a 96 vw golf gti vr6

http://www.the12volt.com/installbay/alarmdetail/2180.html

Posted on Apr 06, 2010

  • 271 Answers

SOURCE: Oxygen sensor for vw golf gti 1.8T 2001

There is four wires-two of them is white for the heater and another two is grey and black for the sensor.Zirconia or titania doesn.t matter.

Posted on Apr 29, 2010

  • 27 Answers

SOURCE: Hello I have the emission workshop light on my vw

that is engine management light.you need a diagnostic test

Posted on Jun 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 VW Golf GTI, Drivers side parking lights stay on when key is removed


I have same problem with my 95 Vr6 Golf, check that indicators are in 'neutral' position. If my indicator is still on when I switch off ignition then the lights on that side stay on - nuisance!

Jan 20, 2011 | 1995 Volkswagen Golf

1 Answer

I have a 2000 Golf GTI VR6 and I am trying to find the fuse for the oxygen sensor, I was told the fault, Found code for O2 sensor heater Bank 1 sensor 1 open circuit. Front O2 sensor failed. Might be the...


if you dont get the o2 sensors replaced it will cause the car to overheat cause im having the same problem with my golf gti vr6 had it dionosed and both my o2 sensors are out nothing else is bad and now it overheats due to the o2 sensors

Aug 28, 2010 | Volkswagen GTI Cars & Trucks

1 Answer

I have a 2000 VW GTI VR6.I'm trying to connect a performince chip


do not cut into these wires. any real performance programmer will not require you to do this. these ones that tell you to cut into the IAT will ruin a $700 mass air flow meter, and do not do anything. all they do is try to trick the computer into thinking it is colder then it actually is, and to richen the fuel mixture, which will actually HURT performance and emissions because the air density does not match what the temp sensor is reading. the temp sensor is there for a reason!

Jun 05, 2010 | 2000 Volkswagen GTI

1 Answer

Oxygen sensor for vw golf gti 1.8T 2001


There is four wires-two of them is white for the heater and another two is grey and black for the sensor.Zirconia or titania doesn.t matter.

Apr 28, 2010 | 2001 Volkswagen GTI

1 Answer

I need a wiring diagram for a 96 vw golf gti vr6 ignition switch


http://www.the12volt.com/installbay/alarmdetail/2180.html

Apr 06, 2010 | 1996 Volkswagen GTI

1 Answer

I have a 1987 VW Golf GTI, im trying to reconnect


Green/blue to negative side of the coil, yellow to the positive side of the coil.

Jan 18, 2010 | 1987 Volkswagen GTI

1 Answer

MKIV VW GTI FUEL PROBLEM


Check all vacume lines for cracks. Throttle body cleaning.

Aug 11, 2009 | 1997 Volkswagen Golf

4 Answers

Seller tells me its a GTi non turbo 2 litre petrol


a GTI has to have turbo and intercooler to be called a GTI.
So, all GTI's have turbo

Apr 12, 2009 | 2001 Volkswagen Golf

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,339 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...