Question about 2003 Honda Civic
So let me ask...you have one end hooked up to the neg. on the battery,and are wondering where to connect the end that grounds to the engine?as you know the battery needs both pos. and neg. to be able to allow voltage to pass thru.is your question .where does the other end go?
Posted on Feb 10, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: I want to replace brake
Yes you can,dont forget to open the master cylinder cover as the fluid will go back to the cylinder,just watch out for the sensor near the caliper it looks like a black cable pointing at the back of the rotor,if this helps please vote me a fix ya
Posted on Jul 15, 2008
Its easy, look down behind the headlight assembly and where the wires go into the back of the headlight is the bulb. Its been a while, but you just unplug the connector and the bulb is held in by a locking ring or clip, I can't remember which.
The bulb is removed from the rear. Simply remove the bulb and install the new one and reconnect the connector.
Just don't touch the glass on the new bulb, because the oils in skin can create hot spots on the bulb.
Posted on Dec 31, 2008
go to an auto parts store and purchase a repair manual it will clearly tell you how to remove the radio . read and understand the directions carefully if you have questions ask the partscarrier they often can assist you
Posted on Jun 22, 2009
SOURCE: oil filter in civic 97
If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))
Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.
Please don't forget to rate:)
Posted on Jul 29, 2009
Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.
Pop out the door handle, and unplug the power lock plug,
Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.
next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)
Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)
Unplug power window connector (big green plug)
Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas
Posted on Apr 03, 2010
Tips for a great answer:
May 16, 2013 | Honda Cars & Trucks
on Jan 28, 2011 | Honda Civic Cars & Trucks
Jan 26, 2011 | 2003 Honda Civic
Apr 22, 2010 | 2003 Honda Civic
Nov 29, 2009 | 2003 Honda Civic
Jun 28, 2009 | 2003 Honda Civic
Mar 19, 2009 | 1991 Honda Civic
Jan 24, 2009 | 1983 Honda Civic
Oct 23, 2008 | 1997 Honda Civic
Jun 04, 2008 | 1998 Honda Civic
101 people viewed this question
Usually answered in minutes!