Question about 2000 Mazda MPV

1 Answer

2000 MAZDA MPV TURNS OVER BUT WONT START. RAN FINE YESTERDAY. GOT IT TO START TODAY AFTER HOLDING GAS PEDAL DOWN BUT NOW ITS PUTTING OUT.

Posted by on

  • 1 more comment 
  • Hope Brown
    Hope Brown Feb 10, 2012

    I CAN SMELL GAS SO I KNOW ITS GETTING FUEL. COULD THIS BE CAUSED BY THE CRANK SHAFT POSITION SENSOR?

  • Hope Brown
    Hope Brown Aug 30, 2012

    oK CHANGED THE MAF SENSOR THAT CLEARED ALL CODES BUT ONE, P1518 WHICH IS THE IMRC STUCK OPEN. TOOK IT APART ALL LOOKED CLEAN BUT WHEN I REV THE VAN TO 4000 RPM"S THE CABLE DONT MOVE. SO... CAN I REPLACE CABLE OR DO I NEED TO BUY WHOLE NEW UNIT? IF I DO IS THERE ANYPLACE I CAN BUY IT USED?

  • louie reyes Dec 26, 2014

    My 2000 Mazda MPV is having starting problem. it cranks, but it wouldn't start at all. did you just changed the MAF sensor to fix it?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Director Badge:

    Uploaded 100 video answers.

  • Mazda Master
  • 286 Answers

Sounds like you possibly got bad gas, or your at the bottom level of your gas tank and got the nasty stuff. Try running a good fuel treatment through the system and fill it up with premium gasoline from Marathon

Posted on Feb 10, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
relaga58
  • 158 Answers

SOURCE: 2002 Mazda MPV won't go over 25 MPH

If it's manual your clutch is slipping.If engine related get it tune.

Posted on May 08, 2009

  • 205 Answers

SOURCE: mazda 2000 mpv does not start

Couple of things it could be.

Try turning it over without touching the gas pedal. Sounds like you flooded it.

Check the coil and engine management sytem. Its probably that.

Posted on Nov 04, 2009

  • 66 Answers

SOURCE: how do I replace alternator in mazda mpv 2000?

It is not a very difficult task, but one that would be better left to a professional for a couple of reasons. First, the system should be tested to be sure this is going to fix your problem. Many times a bad battery is the demon. Second, you will get a warranty with that repair if you have it done at a reputable garage/dealership. Just a couple of things to think about.

Posted on Jan 05, 2009

  • 1 Answer

SOURCE: 2000 Mazda MPV Heating problem

The heater lines that run to the back of the right rear side gets rusty and start to leak anti-freeze. There is a black cover under and above the RR tire that has to be removed so u can see.

Posted on Feb 09, 2009

emissionwiz
  • 76164 Answers

SOURCE: engine light blinking in my Mazda MPV

A BLINKING ENGINE LIGHT INDICATES AN ENGINE CYLINDER IS MIS-FIRING. HAVE THE TROUBLE CODES TESTED TO DETERMINE WHICH ONE. DO NOT DRIVE THIS WAY AT HIGH SPEEDS AS IT MAY OVERHEAT THE EXHAUST SYSTEM AND CREATE A FIRE HAZARD.

Posted on May 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Van cranks but wont start


Hi there:
You wll have to pinpoint what the engine is missing...
- Spark
- Fuel
- Compression

All three of these are tested when the engine is being cranked over. There are two way of checking for fuel. Fuel pressure and fuel trigger. Both are very important and must be present for the engine to start. Fuel pressure is self explanatory. You just hook up the gage and see what the reading is. Fuel trigger is check with a noid light. The injector gets unplugged and the noid light gets plugged in to the injector clip. With the engine cranking over, this light must blink. This is the signal to the injectors from the computer. You can have all the fuel pressure in the world, but it wont matter if the injector is not pulsing gas into the cylinder like it should.

Compression tester, spark tester, fuel pressure gage and noid light are all accessible at your local auto store. All three tests play a very important part in diagnosing a no start condition. Be extremely careful when doing these tests.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 09, 2012 | 2000 Mazda MPV

1 Answer

The engine on my 2000 MPV cuts out and dies when I press the accelerator. After it sits for an hour or so, I can travel for 20 min. or so before the problem starts again. HELP!


if its been a while change the fuel filter and then have the fuel pressure and volume checked.these symptoms are very common for a fuel pump problem.

Feb 07, 2012 | 2000 Mazda MPV

1 Answer

Have a 97 Grand Voyager i just bought yesterday. Started and ran perfectly fine. I got up this morning and now it won't start. Starter turns just fine and fuel pump does come on.


You would need to check the fuel pressure but try turning the key on and off a few times, this will prime the fuel system, if the fuelpump has a bad check valve it will drain the fuel down and then it will take a few trys to start, but if you tried starting it a few times then thats not the problem. you hear the pump but this doesnt mean its putting out enough pressure, try holding the gas pedal down and trying to start it and see, maybe its flooded. good luck.

Feb 13, 2011 | 1997 Plymouth Grand Voyager

1 Answer

Turns over but will not start


Go to Autozone and have the codes scanned. then get back to me. Probably Mass airflow sensor(MAF) or the fuel pump

Apr 24, 2010 | 2000 Volkswagen Beetle

1 Answer

96 mazda mpv minivan 165k mi. Ran fine until one day just died.Had towed home.3 mech.tried diagnose gave up wouldn't start-turns over-no start. Last mech.replaced timing belt&idle pulley. Still no...


step on fuel pedal to the floor, turn it over if it starts sumthing in fuel line, can you hear your feul pump when you turn the key???? is your distributor cap ok, all the wires ok hooked up, mite fuel pump relay, or just a fuse under dash under hood..

Jan 31, 2010 | 1996 Mazda MPV

2 Answers

While my mazda mpv engine is on and warmed and park it would idle to 2500 rpm and stay and make a loud noise from the engine i would have to step on the gas pedal for it to go back to nornal. it would also...


sounds like your throttle cable is sticking or your choke cable spray a good lubricant on the cable where the linkage is, get someone to lightly step on the gas while you are under the hood and watch where the cable turns the linkage spray it there and see if that resolves the problem

Jan 09, 2010 | 2000 Mazda MPV

1 Answer

Mazda 2000 mpv does not start


Couple of things it could be.

Try turning it over without touching the gas pedal. Sounds like you flooded it.

Check the coil and engine management sytem. Its probably that.

Nov 04, 2009 | 2000 Mazda MPV

2 Answers

2004 Mazda Mpv high idle and will not idle down.


Check your throttle position sensor

Mar 19, 2009 | 2004 Mazda MPV

Not finding what you are looking for?
2000 Mazda MPV Logo

485 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...