Question about 1991 Ford Festiva

Open Question

Child seat anchor point 1991 ford festiva

I have a child and i need to know where are the anchor points to install a child seat in the back of the car. I have been told that it's not the spare wheel anchor point ad i see this as a very common sense thing but i have heard that they are off to the sides "somewhere".. could someone please tell me or pass links to show me where to strap the seat to as i think this would also help a lot of others with this type of car.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 686 Answers

SOURCE: Hi, I have a ford

directions for proper instalation of baby carseat should be on the carseat itself look for them

Posted on Jan 11, 2009

Ad
  • 1 Answer

SOURCE: Wire Gauge Fusible Link

Replace the fusible links with ALF fuses, I put 20 amp on each side and a 30 amp in the center

Posted on May 20, 2009

warlock61
  • 659 Answers

SOURCE: Need help wiring starter relay (aka/solenoid) on 1991 Ford F-150

the starter cable is on one side by itself all the others are on the same side as the battery

Posted on Jun 11, 2009

planet-x
  • 232 Answers

SOURCE: 1991 ford festiva replaced alternator new

it is part of the alternator actually on a lucas unit, a small black box bolted to the rear of the alternator.

You may have a faulty ignition switch or a corroded engine earth cable causing the alternator not to reach charging voltage.

Posted on Jan 13, 2010

  • 20 Answers

SOURCE: have ford focus 1999 1.4 - power loss - car runs

things like the air sensor and idle valve will bring on the engine management light, get someone to rev the car up while you check the pressure at the back of the exhaust to check the cat or back box hasnt collapsed

Posted on Jun 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can anyone help trying to locate Child seat anchor points on a 2005 nissan teana if none do I have to drill thru the parcel tray?


carefully look at the deck covering for impressed lines as that will indicate where the cover has been weakened to allow easy removal for the anchor bolt
depending on the seat in use there could be one directly behind and in the middle of the seat or one on either side of the seat position
look up from in the boot and see if there are nuts welded in place already for seat belt anchor points

Apr 20, 2016 | Nissan Cars & Trucks

1 Answer

1991 ford festiva point setting?


No points used. Its electronic.

Sep 11, 2014 | 1991 Ford Festiva

1 Answer

We're about to buy a Suzuki XL7 2003 model but can't find the child seat anchor points in the middle row of seats. There are 2 hooks on the back of the middle and the LHS (passenger side) seats - are they...


Check for the seat belts under the seats in that row by pulling up on the little leather or plastic handles found on the side of seat or between the top and bottom of seats. Hope that Helps.

Feb 02, 2014 | Cars & Trucks

3 Answers

How to install baby seat in 1988 mazda 121 hatch


Most vehicles built before around 1995 were not equipped with baby seat anchors as standard equipment.
Baby seat anchors are also not something that is normally covered in service and repair information. You need to look in your Owner's Manual. If your Owner's manual does not show any baby seat anchors, then there are kits available at your local parts store or dealer to install some. There shouldn't be any need to "weld" anything.

Please also check out this link:

http://www.thecarseatlady.com/vehicles/the_latch_system_9.html

May 22, 2012 | Cars & Trucks

1 Answer

I need to know where to find the child anchor for a 1996 dodge caravan


There are no child anchors on a 96. This was around the time the latch system was under development. Just went through looking into this for my 1996 van. chico car seat fit well

The newer van seats will not fit either( I do have a 2007 seat for sale now ) as I tried to make one fit in my 1996 van with the latch system and it didnt fit. Wheels right spacing too wide for the anchor points.
Tom K. MN

Nov 11, 2011 | 1996 Dodge Caravan

2 Answers

1991 Ford Festiva fuel not going to carburator need to know where fuel pump is or how the fuse may be the problem


IN THE GAS TANK OR UNDER THE BACK SEAT ,THE SEAT WILL HAVE TO COME OUT IF SO IT THERE ,BUT IF NOT IT,S IN THE GAS TANK

Mar 08, 2011 | 1991 Ford Festiva

1 Answer

Latching system for a child car seat honda accord


IF YOU GO TO A HONDA DEALER THEY SELL A SET OF THREE ANCHORS IN KIT.(JUST ASK FOR REAR CHILD SEAT ANCHORS)THEY RUN ABOUT $25 FOR SET. AT THAT POINT YOU CAN HAVE THEM OR YOUR NORMAL MECHANIC INSTALL FOR YOU OR IF YOU CHOOSE TO INSTALL YOURSELF THEY'RE FAIRLY EASY TO DO.IF YOU OPEN UP TRUNK AND LOOK AT BOTTOM SIDE OF REAR DECK(BEHIND HEADRESTS)YOU WILL NOTICE 3 SPOTS WHERE NOTS ARE WELDED TO DECK SPACED EVENLY ACROSS DECK.ONCE YOU HAVE A BEARING OF THERE LOCATION YOU TAKE A RAZOR BLADE AND MAKE THREE SMALL CUTS FROM TOP SIDE IN DECK FELT WHERE THESE NUTS ARE LOCATED. THIS IS WHERE SEAT ANCHORS BOLT TO.THERE ARE ALSO IN THE CREASE OF SEATS SMALL HOOKS TO ANCHOR LOWER STRAPS OF CAR SEAT TO.YOU KIND OF HAVE TO FEEL AROUND FOR THEM BUT ONCE YOU FIND FIRST TIME YOU LL GO RT TO THEM EVERY TIME. GOOD LUCK! JOEL

May 29, 2009 | 1999 Honda Accord

1 Answer

I can't find a child restraint anchor point in my 1996 Mazda 121.


The rear seat child restraint anchors were not required (by law) until early 2000's. Most likely your car does not have them.

Jan 20, 2009 | 1993 Mazda 323

Not finding what you are looking for?
1991 Ford Festiva Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...