Question about 1992 Subaru Loyale

Open Question

Where is the oxygen sensor located on a 92 subaru loyale

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 51 Answers

SOURCE: Where is the location of

You have 2 converters on that vehicle (front and rear). The 02 sensor in front of the FRONT converter is directly in front of the converter. The other sensor is behind the FIRST converter.

Chris

Posted on Aug 02, 2008

Ad
  • 107 Answers

SOURCE: TIMING TEST MODE CONNECTORS 92 SUBARU LOYALE

under the hood near master cylinder

Posted on Mar 09, 2009

Rebgagnon
  • 382 Answers

SOURCE: I have a check engine light ON on my 1992 Subaru Loyale.

The black is a ground connection electrical. Usually they get pulled out by someone messing with dash like radio or something.

Posted on Jul 12, 2009

  • 50 Answers

SOURCE: I have a 92 Subaru Loyale wagon. It will not

replace your fuel filter and fuel pump if you are getting power to the fuel pump check your fuse first it may be blown

Posted on Oct 26, 2009

ZJLimited
  • 17970 Answers

SOURCE: The hazard lights on my 1993 subaru loyale are not

Both the turn signal and hazard warning flashers are mounted on the fuse panel.

REPLACEMENT
To remove a relay, simple pull the relay out. When installing a relay, make sure the terminals on the relay line up with the terminals in the fuse panel.
Most of the replaceable fuses for the electrical system are located on the fuse panel under the instrument panel, to the left of the steering column. In addition to the plastic fuses installed in the fuse box, there are 1 or more circuit breakers and a flasher relay.

For access to the fuse panel, remove the fasteners from the lower edge of the cover, then pull the cover downward until the spring clips disengage from the instrument panel. On the base models, the cover simply snaps on and off.

The locations of various fuses are illustrated in the owner's manual, and in some cases, on the cover of the fuse panel (in the pic check inside the circle).

5a08647.gif

Hope that helps.

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

92 subaru loyale new distributor and coil still no spark


Had the exact same problem and went through the whole dance. Traced problem to relay under the dash , combination ignition/fuel pump relay. The relay was "clicking" but was internally bad, it would not engage circuit for the ignition. Power was indicated at coil and fuel pump would run but the circuit was not complete through the computer to power the ignition sensor in the distributor. I actually had to "gang" 2- 12 vdc coil automotive relays to replace the original relay. Caution... if you decide to gang 2 relays be sure to separate the two circuits, one relay for ignition, one for fuel pump and tie the coil wires together.

Feb 17, 2014 | 1992 Subaru Loyale

1 Answer

92 Subaru Loyale Hood cable busted


Someone with skills/tools to enter a car with the keys locked in it may be able to get you in there.Ask a locksmith(they will probably charge less if you bring the car to them).The various vehicle entry tools to open a door might also work to open the hood.

Dec 30, 2012 | 1992 Subaru Loyale

1 Answer

My 1992 Loyale recently started acting up. The normal engine idle after warming up went from its usual 900 rpm to around 2200 rpm. The engine runs a little rough with some hesitation occasionly and is...


no
the next step is to have the fault codes read
indicates a problem idle sensor
running rich is heated oxygen sensor in the exhaust manifold or problem dirty injectors causing a problem in the air /fuel mixture settings

Sep 07, 2017 | Subaru Loyale Cars & Trucks

1 Answer

How do i open my gas tank to my 92 subaru loyal


There is a lever on the floor, driver's side inside next to the seat. Just pop it up.

Nov 05, 2010 | 1992 Subaru Loyale

3 Answers

Where is the fuel pump located on a '91 Subaru Loyal Wagon


Welcome to FixYa.com,
Fuel pump is in the tank, Regards, Lee Davidian
2bf95ba.png

May 31, 2010 | 1991 Subaru Loyale

1 Answer

Where is the flasher relay on a 92 Subaru Loyale wagon?


Front seating area, driver side, under dash, above brake pedal, mounted in steering column support bracket

i hope this helps you

Apr 10, 2010 | Subaru Loyale Cars & Trucks

1 Answer

92 loyale engine light is on. it will not flash a code for me with the test cunector pluged in


Your model is a 92 model which uses OBD 1 technology, is your diagnostic tool suitable for ob1. After 1997 vehicle uses obd2 which is different..so check your diagnostic tool before looking further

Nov 05, 2009 | 1993 Subaru Loyale

1 Answer

TIMING TEST MODE CONNECTORS 92 SUBARU LOYALE


under the hood near master cylinder

Mar 09, 2009 | 1992 Subaru Loyale

Not finding what you are looking for?
1992 Subaru Loyale Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Brandon Johnson
Brandon Johnson

Level 2 Expert

251 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...