Question about 2002 Ford Expedition

1 Answer

Code po335 check engine light on - traced to code po335

Posted by on

  • Steve Allison
    Steve Allison May 11, 2010

    I don't know why but that P0335 does not come up under generic OBDII or Ford??


    Are you interpreting a dashboard display or a scanner readout? 

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Po335, engine ligt on, slip and vdc brake light on 2005 armada


Error Code: P0335
Description:
Crankshaft Position (CKP) Sensor - Circuit Malfunction
Possible Cause:
Wiring.
Crankshaft position (CKP) sensor.
Engine control module (ECM).

Mar 25, 2014 | 2005 Nissan Armada

1 Answer

My 2003 Nissan pathfinder codes po725 &po335 showed up on scanner, in addition the check engine light is on. Truck is stalling out periodically while driving


there is a very common problem with nissan distributor. in my shop i see a lot of them with dirtributor problem

Nov 07, 2012 | Cars & Trucks

4 Answers

Car dies while driving


Your fuel pump needs cleaning, I had same problem

Feb 24, 2012 | 2002 Cadillac Seville

1 Answer

Car runs and drives,but po335 code crankshaft is on.check engine light is ON.


Thanks for choosing FixYa and welcome to the site. If that is the code your computer gave you, change the crank sensor. It can eventually cause your vehicle to quit running if it goes bad.

Apr 25, 2011 | 2000 Suzuki Vitara

1 Answer

Check engine light is on in my 2005 altima 2.5 got it scanned and the codes i got were P0335 /P0725/P0420 also car keeps stalling


po335 and 725 bad crank sensor and this is also reason for stalling.po 420 catalyst has lost efficiency....needs new catalytic converter ...covered under 8year 80000 mile emmisions warranty.

Feb 08, 2011 | 2005 Nissan Altima

1 Answer

Codes


PO725 = Engine Speed Input Circuit
PO335= Crankshaft Position Sensor A Circuit

Apr 19, 2010 | 2002 Nissan Altima

1 Answer

Service Engine Light On


It has to do with the cps, crankshaft position sensor. Take it to Autozone and ask them to pull the codes to verify them. They will then sell you, if you want it, the correct part - this service is free at autozone!!

Apr 19, 2010 | 2002 Nissan Altima

1 Answer

Throwed a code po335 crank sensor , i changed the crank sensor cleared the codes and 30 miles later check engine light came back on


Are you sure it was the crank sensor that you replaced? The cam and crank sensors look identical. Was the engine hard or slow to start? If so, this will sometimes set this code.

Nov 09, 2009 | 2006 Nissan Altima

1 Answer

OBD malfunction indicator light status on stored diagnostic trouble codes po325, po335, p1336 . Car will not pass OBD test.


CODE PO325 - KNOCK SENSOR. CODE PO335 -CRANK SHAFT POSITION SENSOR. CODE PO336 - I DID NOT SEE CODE PO336.

Aug 28, 2009 | 1997 Nissan.5 Altima

1 Answer

Ck engine light on code po335 p1336 also location of sensor?


P0335 and P0336 Engine crank sensor malfunction
To test this code, have a visual inspection of the location and wirings of the crank sensor. If the engine has a cam sensor, you might mistook it as the crank sensor (it is a good idea to contact ATS that can research this for you). Check the sensor wires for insulation making sure it is getting a voltage signal as shown in the wiring diagram. Sometimes, the wires itself is soaked with dirty oil causing the sensor to fail. If OK, check the engine timing belt system for any slack which can also cause the sensor to throw in the code. If all of these prove OK, remove the crank sensor and check it for resistance as compared to the standard specs. Lots of times, if the sensor probe end is contaminated with oil or cracked, this can only be revealed after the crank sensor is removed

Jun 02, 2009 | 1999 Pontiac Montana

Not finding what you are looking for?
2002 Ford Expedition Logo

Related Topics:

572 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...