Question about Mitsubishi Montero Sport

1 Answer

Where is the purge soleniod on a 02 montero sport

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mitsubishi Master
  • 76,846 Answers

Under the hood is an emission system sticker, it has a diagram of the vacuum system that shows this valves general location, it is in most cases right next to the Carbon Vapor storage canister.

Posted on Feb 10, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
jingB
  • 19 Answers

SOURCE: Mitsu Montero Sport '02 engine stalls but not when air cond is on.

hi there. the reason that the engine idles good when the air-con is engaged is that ussually all vehicles nowadays have a vacumm advance mechanism. this is triggered mainly by a electric solenoid valve which is also attached parallel to the source supplying power to compressor. a small vacumm hose with a diameter like a common pencil or ballpen case. its made of rubber and it runs from the alternator vacumm pump then to the solenoid valve and to the vacumm advancer unit attached to the injection pump throttle. this system raises the idle a tad higher.

if your montero runs completely normal and you experience no other problems with your engine except for your present problem, then the solution is just raising the idle a little higher. if your montero is equiped with a RPM guage on the dash, try adjusting the idle to around 800 rpms. it would be healthier for your car if the idle raises a bit when you engage the air-con because this would compensate for the added load on your engine.

hope this helps.

Posted on May 31, 2009

  • 1129 Answers

SOURCE: Can i get a quote?

It should cost no more than $80.00 - $100.00 and even that is a little high.

Posted on Jul 08, 2009

johnjohn2
  • 5763 Answers

SOURCE: can't find the canister purge soleniod on my 1993

its located on the left front of engine compartment below the horn. here a picture to help you find it.9a28a12.gif

Posted on Jan 24, 2010

  • 11 Answers

SOURCE: where is the a/t control

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????7

Posted on Jul 28, 2011

  • 1243 Answers

SOURCE: Mitsubishi montero sport 2001 3.0

the purge valve is part of the EVAP system. p0441 is usually set when the ECM can not monitor the purge valve performance. the EVAP system takes the gas fumes out of the tank and purges them into your intake system while you drive the car. if the ECM doesn't see a drop in fuel tank pressure then it sets the code. most common failure is the purge valve malfunctions or loss of power or ground signal to the purge valve.

Posted on Aug 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code p0455 evap system large leak


check for loose hoses. evap purge valve .. Are you fitting a non-vented cap which is what you will be needing. replace the purge valve.

Nov 14, 2013 | 2000 Mitsubishi Montero Sport

1 Answer

Could a bad purge solenoid cause a delay in engaging in drive in an 02 montero?


No all that code does is turn on the check engine light, no symptoms except that.

May 30, 2012 | 2002 Mitsubishi Montero

1 Answer

Mitsubishi montero sport 2001 3.0 litre; problem 0441-Purge flow Can you explane me what`s that mean? and which parts fail is it?... Thks in advance _Jakob


the purge valve is part of the EVAP system. p0441 is usually set when the ECM can not monitor the purge valve performance. the EVAP system takes the gas fumes out of the tank and purges them into your intake system while you drive the car. if the ECM doesn't see a drop in fuel tank pressure then it sets the code. most common failure is the purge valve malfunctions or loss of power or ground signal to the purge valve.

Aug 03, 2011 | Mitsubishi Montero Sport Cars & Trucks

1 Answer

Can't find the canister purge soleniod on my 1993 pontic trans sport 3.8


its located on the left front of engine compartment below the horn. here a picture to help you find it.9a28a12.gif

Jan 24, 2010 | 1999 Chevrolet Silverado 1500

2 Answers

Can i get a quote?


It should cost no more than $80.00 - $100.00 and even that is a little high.

Jul 08, 2009 | 2002 Mitsubishi Montero Sport

1 Answer

Mitsu Montero Sport '02 engine stalls but not when air cond is on.


hi there. the reason that the engine idles good when the air-con is engaged is that ussually all vehicles nowadays have a vacumm advance mechanism. this is triggered mainly by a electric solenoid valve which is also attached parallel to the source supplying power to compressor. a small vacumm hose with a diameter like a common pencil or ballpen case. its made of rubber and it runs from the alternator vacumm pump then to the solenoid valve and to the vacumm advancer unit attached to the injection pump throttle. this system raises the idle a tad higher.

if your montero runs completely normal and you experience no other problems with your engine except for your present problem, then the solution is just raising the idle a little higher. if your montero is equiped with a RPM guage on the dash, try adjusting the idle to around 800 rpms. it would be healthier for your car if the idle raises a bit when you engage the air-con because this would compensate for the added load on your engine.

hope this helps.

May 31, 2009 | 2002 Mitsubishi Montero Sport

2 Answers

4wd indicator light blinking...


4 wheel drive light blinking.same problem on my 2001 montero

Jul 17, 2008 | 2001 Mitsubishi Montero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

192 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...