Mondeo mk3 airbag light flashes 5 times then 2 times?

Question edited for three uses of the word 'booth', changed to 'boot. As it is a Mondeo, I presume you are in the UK?

Look for a button in the glove compartment that is a child lock and stops the boot being opened from inside the vehicle. The fuse box doesn't show fuses or relays for it. Sometimes there is a slide switch on the inner side of the lock.

Ford Mondeo (2000 - 2007) - fuse box diagram - Auto ...

https://www.autogenius.info > ford-mondeo-mk3-fuse-...
May 25, 2015 - Ford Mondeo (2000 - 2007) - fuse box diagram. Year of production: 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007 ...

2000-2007 Ford Mondeo MK3 Fuse Box Diagram

https://knigaproavto.ru > shemy > 477-2000-2007-ford...
Dec 4, 2017 - Fuse Box Layout Ford Mondeo with engine: 1.8L, 2.0L, 2.2L, 2.5L and 3.0L (Mk3 - saloon, liftback, estate; 2000, 2001, 2002, 2003, 2004, 2005 ...

..

The light will only quit flashing if there is no problem, So you must have a problem. Do this get to the diagnostic mode only this time count the flashes these are codes, it will look like this example a flash followed by Two fast flashes is code 12, Three long flashes followed by Three short or fast flashes is code 33. When you get the code use the testimonial to tell me what they are. It will show up in my email. I hope this helps. Take care.

images for Mondeo Mk3 Duratec 2 ltr plug wiring
Google it

Hub to lower arm bolt torque: 70Nm

Brake caliper 80Nm

Please follow link and read about code Airbag flash 24

REPAIR PROCEDURE FOR AIRBAG FAULT CODE 24 Security Safety Mk3 Mondeo

Replace the airbag lamp in the cluster, and get the LFC ( Light Flash Code ) to figure out what the problem is with the SRS.
The 5x5 beeping is an indication that there is a SRS problem waiting and the airbag light cannot give the LFC. Page 105 in the owners manual.

Once you replace the airbag light, you will get a LFC that is a 2 digit number presented by the flashes.
Example is a LFC of 42, the airbag light would flash 4 times, pause flash 2 times pause and repeat.

Once you have the LFC, either start a new problem, or add a comment to this problem with the number for further diagnoses.

Mine came on when my car hit 120K mi. I also reset it using a sequence within the car.

Problem Scenerio: turn car motor on, car conducts self test, during which time airbag light stays on for 5-second (or 5 or 6-beeps)..it turns off for a second then flashes 'off and on'...and annoys the hell out of you as you drive...especially at night.

Solution 1: put black electrical tape (band-aid) over airbag light indicator...annoying problem gone.

However, in VA the airbag light can't be flashing to pass the annual car inspection, so....

Solution 2: Reset the Airbag light using the following sequence I discovered and heard about:

1. Turn key / ignition to 'ON' (Do Not Start). and await for the self-testing procedure to end (Air Bag Light stays on for about 5-seconds or '6-beeps')
2. As soon as the Airbag light turns off - turn the ignition to OFF position and count 5-Mississippi's (that's 5-seconds).
3. Then turn ignition back to 'ON' Position and repeat step 1 & 2 again.

Conduct Steps 1 & 2 - Three times in a row.

After the 3rd or successful timed sequence, allow the car to go through it's complete self testing stage and as soon as its done the airbag light will flash...but at a slower pace (That is good!) That means the cpu is resetting. Once you observe the slow flashing airbag light, turn the car off, then start it normally and the airbag light 'should' reset (not flashing and bugging the **** out of you).

Then, take the black electrical tape off the dash panel and throw it away.

This is no joke and it really works!! if you have any questions, contact me. [email protected]

Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.


Just push it together properly and it should clear the AirBag fault

Try to change washer between compressor and compressor clutch. This is very often problem in Mk3. After the time the clutch is thinner and needs also thinner washer. Hope it helps

when the airbag light is on it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called th clock spring contact, a coiled up ribbon electrical contact that turns with the wheel.