Question about Cars & Trucks

Open Question

Install temp door actuator in 04 envoy xuv - Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
MrScary66613
  • 1990 Answers

SOURCE: Changing Oil '04 GMC Envoy XUV

Guessing that this Truck has the V8???? Slide up underneath. The Drain plug is the Bold Closest to the Front and will be at a Slight Angle. There is one farther back But, This one is the Tranny. The Filter is Right around the Same area as the Drain Plug for the Oil. Just look up and you will see it.

Posted on Jan 24, 2009

Ad
techprogrami
  • 57 Answers

SOURCE: No sound comming from the left side speakers in my 04 Envoy XUV.

first> road vibrations can cause cable connections to come loose so you can start by taking out your radio and making sure all of the questions in the back are connected as they should be.
Second> if this doesnt seem to work then the next step is to check the wires going to the speakers that arnt working (this will b quite a job, but if you can do it, it will save u quite a bit of money) .. checking the wires your checking for >bad connection to the speakers >cuts in the wire or if any part of the wire is touchin any other metal object

Was This Helpful ?

Posted on May 29, 2009

  • 42 Answers

SOURCE: 2004 Envoy Xuv tailgate does not open.

pull the plastic off of the tailgate and make sure the small wire looking controls are still hooked up. sometimes they will pop out after alot of use. other thing is make sure the rear actuator is actually working (it could be bad)

Posted on Jun 20, 2009

  • 94 Answers

SOURCE: 04 GMC ENVOY XUV The window on the midgate made a

take inside door skin off, everything now a days is plastic, prob the arm to lift window or a plastic gear broke, really easy to do....

Posted on Jan 04, 2010

  • 1 Answer

SOURCE: 2004 Envoy xuv 6 cyl stalls with A/C on at idle

2004 Envoy xuv 6 cyl when I turn on the A/C the truck stalls but as long as I keep my foot on the gas it will continue to run

Posted on Jun 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the heater control valve located on a 2004 Gmc Envoy XUV with a 4.2 liter 256 cubic inch engine


There isn't a heater control valve in the hoses, it controls the heat in the vehicle with a temp blend door which has an electric actuator.

Aug 19, 2017 | GMC Cars & Trucks

1 Answer

Tailgate actuator on 2005 envoy xuv won't unlock


have you look in drivers hand book to see if there is a fuse for the tailgate actuator

Sep 25, 2014 | 2005 GMC Envoy

1 Answer

Where is the engine coolant temp sensor on gmc envoy 2004 xuv


More than likely the thermostat is stuck open. You should replace the thermostat and the temp sensor. See picture below for location.

ec0f2967-0847-4f84-ae44-ae8852926baf.jpg

Apr 04, 2013 | 2003 GMC Envoy

1 Answer

Gmc envoy 04, the gear shift slides up and down but the gear did not engage. another word, the xuv won't move


The shift cable probably has broken, usually the ring at the end breaks. Below is a diagram that shows the cable (it is item #7)

freddyboy61_16.gif

Aug 30, 2011 | 2004 GMC Envoy

1 Answer

04 GMC Envoy XUV midgate window fell won't come back up; motor runs ,window won't move


The same thing happened to my '04 XUV. Discovered broken white nylon/plastic that retains the end of the lift cable. Ordered a new lift gate motor/mechanism assembly ($250) online and replaced it myself. Be sure to buy a new limit switch ($13) also. I did not and regretted it because you must remove the old limit switch from the old motor assembly so you can re-assemble it to the new motor assembly. While removing the old switch from the old assembly, I broke it. Had to then order a new switch. The cost to ship the switch separately was more than the switch. The whole thing did not really take that long and was surprisingly easy. It works great now.

Dec 13, 2010 | 2004 GMC Envoy

1 Answer

04 Envoy xuv 4 wh. drv. stays in 4 wh drv. HI


Try putting your transmission in neutral and slowly shifting the 4wd selector to each position but you have to wait a few seconds between selsctions as it has to go through your vehicles computer, shifting to fast will cause your symptoms. I hope this helped you out. Roger

Feb 08, 2010 | 2004 GMC Canyon

1 Answer

2004 GMC Envoy XUV mid-gate window won't roll up


be sure the gate is fully closed or it will not roll up if it is firmly in place and still does not go up you will have to remove the cover and see if the actuator plastic has broken off from the switch, it also could be a bent rod and or the switch is bad. Check fuses as well just to be sure before going to all the other work to pull cover off. Hope this is helpful and thanks for using Fix-ya.

Jan 19, 2010 | 2004 GMC Envoy

2 Answers

Air flowing thru front vents


I just changed my battery as well in my 04 Envoy XUV and the air on the passenger side would not blow. The air has since returned after I restarted but the flow on the bottom has been out for some time even before the battery change.

Jul 23, 2009 | 2004 GMC Envoy

1 Answer

2004 Envoy Xuv tailgate does not open.


pull the plastic off of the tailgate and make sure the small wire looking controls are still hooked up. sometimes they will pop out after alot of use. other thing is make sure the rear actuator is actually working (it could be bad)

Jun 20, 2009 | 2004 GMC Envoy

2 Answers

Back door will not open from the side.


You will need to pull off the back panel to access the handle and rod. You either have a broken handle, or the rod that goes to the actuator has fallen off.

Mar 13, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...