Question about Cars & Trucks

1 Answer

LOCATION OF INPUT TURBINE SPEED SENSOR FOR FORD LASER 1999

WHERE IS ITS LOCATION

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,381 Answers

Try google images may find it there

Posted on Jan 02, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Molson02536
  • 3854 Answers

SOURCE: turbine input speed sensor

NO the sensor is out side the transmission. And it might just be a bad connection due to being out in the eliments. On the 3.1 your going to have to jack up the car to get to it from underneath and you should see it on the passenger side may be on top, Sorry been awhile and carful not to brake the clips that hold the wire to the sensor when disconnecting.
Good luck and hope this helps

Posted on Apr 09, 2009

  • 316 Answers

SOURCE: input/turbine speed sensor circuit

Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: I have a code p0715, which is the input turbine speed sensor

Have the same problem with the input speed sensor. The part, so far, is only made by Mitsubishi (Part No. 8651A111) and cost about $110 (w/ tax in TX).

Posted on Oct 07, 2009

  • 162 Answers

SOURCE: how do I locate the turbine speed sensor on a ford

its on the front of the transmission below the coil it compares the input shaft/turbine speed against the speed of the output sensor it is checking to see how much slip or diffrenece in shaft speeds the only time the two shafts are spinning at the same time is when torque converter is in lockup

get this sensor from ford dealer for a little more than $100 bucks

Part number F32Z7F040A

Posted on Apr 08, 2010

emissionwiz
  • 76649 Answers

SOURCE: code 715 is reading it

If u go to the link below there u will find a diagram of the transmission, the Turbine speed sensor is part #5 in the diagram, it has an electrical connector going to it.

http://www.justanswer.com/view_image.aspx?href=http%3a%2f%2fww2.justanswer.com/uploads/CTFordTech/2008-08-10_215144_2.0_escort_trans.gif

Posted on Oct 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 mustang v6 input speed sensor code po 715 where is it ?


that is the input/turbine speed sensor circuit malfunction. or turbine shaft speed sensor. it tells the car when to shift.

Dec 24, 2014 | 2010 Ford Mustang

1 Answer

Whats ford windstar error codes p0715 mean


I hope this helps and is what your looking for... good luck

http://www.fordobdcode.com/p0715-ford

Ford P0715 OBD-II Trouble Code Definition:
P0715 Input Shaft Speed Sensor Circuit Malfunction
P0715 Ford OBD-II Trouble CodeDescription:
OBD Trouble Code P0715 Input/Turbine Speed Sensor "A" Circuit What does the code mean? OBD-ii Code P0715 definition:
The input speed sensor detects the primary pulley revolution speed and sends a signal to the Transmission Control Module (TCM) and Engine Control Module (ECM). Symptoms Sumptoms of OBD code P0715
- Engine Light ON (or Service Engine Soon Warning Light) - Possible shifting problems Causes Causes of the OBD-II code P0715
- Transmission speed sensor circuit is open or shorted. - Poor transmission speed sensor circuit connection - Faulty transmission speed sensor The Error code is generally activated on detection of the following conditions: Diagnostic Trouble Code (DTC) P0715 is detected when TCM or ECM does not receive the proper signal from the sensor. Solutions

Jun 22, 2014 | 1999 Ford Windstar

1 Answer

Input turbine speed sensor location


Hi Mario, I may be behind times, but believe the sensors you're referring to are the turbine pressure sensors. There are usually two, mounted onto he turbo inter-cooler. Regards John.

Apr 21, 2014 | 2002 Honda Odyssey

1 Answer

2000 ford explorer input turbine speed sensor. code po715 was pulled on the obd scanner.does any 1 no were this sensor is located at on my transmission, i beleiv e it has the 55r5e trans but not quit sure....


the is also known as sensoer c it is your pressure control solenoid. if you drop the transmission pan and remove the transmission filter it is on the side of the valve body. DO NOT REMOVE THE VALVE BODY PLEASE12_7_2012_2_21_36_am.gif

Dec 07, 2012 | 2000 Ford Explorer

1 Answer

Were is the input turbine speed sensor located at,and what does it look like.


The turbine shaft speed sensor is located inside the transmission. The transmission will have to be removed and disassembled to access the sensor. The sensor you have now... sound about what it looks like.

Dec 07, 2012 | 2000 Ford Explorer

2 Answers

I HAVE A 2006 FORD FIVE HUNDRED AND A CODE P715 COME UP WHAT DOES THAT CODE MEAN


The P0715 tells you TCM detected a loss of TSS signal during operation. Insufficient input from the turbine shaft speed sensor.

Sep 22, 2010 | Ford Five Hundred Cars & Trucks

1 Answer

How do I locate the turbine speed sensor on a ford escort problem code: P0715


its on the front of the transmission below the coil it compares the input shaft/turbine speed against the speed of the output sensor it is checking to see how much slip or diffrenece in shaft speeds the only time the two shafts are spinning at the same time is when torque converter is in lockup

get this sensor from ford dealer for a little more than $100 bucks

Part number F32Z7F040A

Apr 08, 2010 | 1999 Ford Escort

1 Answer

Troubleshooting code p0715 ford explorer 1999. can you tell me what this is saying and possible solutions


P0715 Input/Turbine Speed Sensor Circuit Malfunction in your transmission.

It indicates one or more of the following:
  • an open or short in O/D direct clutch speed sensor circuit# 1 vehicle speed sensor failure
  • O/D direct clutch speed sensor failure
  • ECM
  • Auto-trans assembly
I would definitely find a qualified transmission repair center for solution.

Sep 11, 2009 | 1999 Ford Explorer

1 Answer

Input/turbine speed sensor circuit


Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.

Apr 19, 2009 | 1997 Ford Escort

1 Answer

Location of speed sensor a for 99 dodge intrepid


The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.

Mar 29, 2009 | 1999 Dodge Intrepid

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...