Question about Cars & Trucks

Open Question

Wireing a Pass & Seymour switch TM811-WCC6

How do I wire these in? I have 1 main feed coming into the box, and need tohook up two Pass & Seymour (TM811-WCC6) switches into it.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: radio conector problem

Try halfords they do a lot of car audio conectors.You give them the name of of the product your fitting and the car you want to fit it in.usually a universal plug is offered.plug it in your radio then into your loom and away you go.No additional wiring no mess.Usually costa around £7.Hope this helps.

Posted on Jun 27, 2008

Ad
danny_murray
  • 55 Answers

SOURCE: fuel cut off switch for 1990/91 ford escort 1.9

The "inertia switch" which shuts off fuel to the engine in the event of a collision or jolt on a 1991 through 1996 models, as well as on 1998 coupes, is located in the rear of the vehicle, near the right (passenger's side) strut tower. On sedan and coupe models, open the trunk and remove the right-sided trim panel. On sedan and coupe models, open the trunk and remove the right-side trim panel. On hatchback and wagon models, there may be an access door secured by clips. On some models you may need to remove the lower quarter trim panel on the right side, however it is easier to cut an access hole directly above the switch.

Posted on Dec 04, 2008

  • 840 Answers

SOURCE: need wiring dig. for 2005 chevy venture window switch

call any gm parts dept they can print one up for you just give them your vin Please rate my response thank you very much

Posted on Feb 02, 2009

  • 334 Answers

SOURCE: 1999 ford expedition: Removal of dash/headlight switch?

yes you can. the head light switch come out real ez it un plug on the back side .and the cluster come out in one pices

Posted on Mar 22, 2009

roy7777
  • 109 Answers

SOURCE: 1995 Volvo 940 turbo wagon AC compressor will not

YOU MUST HAVE COMPLETE KNOWLEDGE OF THE ECC/CLIMATE CONTROL SYSTEM TO PROPERLY FIX IT

Posted on Jul 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have no park lights or dash lights head lights work and turn signals work


1. Check the Violet/White (VT/WH) wire of the headlight switch for hot-at-all-times power from fuse #20 (15 amp) of the Battery Junction Box (BJB). Also check the switch itself for power feeding park lights coming out of the switch.

2. Check the #20 fuse holder for a missing, blown, or poorly connected fuse.

3. If the fuse is OK, inspect the wiring harness on the driver side front corner where the main loom wraps from the BJB to the inner fender for corroded or broken wires

May 31, 2015 | 1999 Ford Taurus

1 Answer

PASS.SEAT SENSOR AIR BAG LIGHT ON


It is illegal to bypass the airbag circuit. Check for broken wire under or beside passanger seat. these have a tendancy to brake cause the seat gets moved back & forth especially if the wireing has been routed incorrectly. air bag wireing will be identified by yellow plugs & normally yellow condute as well.

Oct 09, 2012 | Cars & Trucks

1 Answer

95 mercury marquis ignition switch pin b5 is missing 12 volts- where does it come from?


B5 - 276 Brown - Switch Feed

Fuse 1 (15 amp) & Fuse 10 (10 amp) in the IP fuse box.

And, 50 amp Fuse in engine compartment fuse box. behind batery

please rate, thanks

Jun 27, 2011 | 1995 Mercury Grand Marquis

1 Answer

Wiper motor stopped working. I need a wireing diagram for the wiper motor , switch and relay


Wiper motors usually do not have a relay, they are operated directly from the switch. Before you look at wiring, check the fuse, wiper motors are notoriously reliable and something like a switch will go long before the wiper motor. The fuse must be in the main fuse box. The position and function of the fuses is normally marked on the inside of the fuse box cover and also in the owner's handbook. If you don't come right with these, work your way through the fuses looking for a blown one. To ease your search the wiper fuse it should be around 15 to 20 amps.

Mar 15, 2011 | Chevrolet Corvette Cars & Trucks

1 Answer

Oyxgon no.1 sensor replaced 2 time With code P0031


could be a fuse for the heater,check all fuses because some fuses feed other fuses and are not labeled as such

May 29, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Cab brake light dont come on need wireing scem for cab. chevy up


think brake switcjh it is a dule part switch.. if bulb good then switch next culprit

Sep 04, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

I need a fuse box diagram for a 1992 Ford Ranger. Any idea where I could find one?


owner manual.

here's the big ones for 1994 ranger. all i have
Section 18-01: Wiring and Circuit Protection 1994 All Ranger, Explorer and Aerostar Vehicles Workshop Manual
SPECIFICATIONS Specifications

High Current Fuses And Circuit Breaker — Ranger 2.3L, 3.0L And 4.0L
Circuit Size Location Electric Fuel Pump 20 Amp Fuse Power Distribution Box Headlamp Switch Feed 40 Amp High
Current Fuse Power Distribution Box #36 Circuit Alternator Output #2 15 Amp Fuse Power Distribution Box Fuse Panel 60 Amp High
Current Fuse Power Distribution Box Power Locks 20 Amp High
Current Fuse Power Distribution Box #38 Circuit Alternator Output #1 12 Ga Fusible
Link Integral with 14305 W/A Powertrain Control Module and Power Relay 30 Amp High
Current Fuse Power Distribution Box 4x4 Electric Shift 20 Amp High
Current Fuse Power Distribution Box Ignition Switch Feed 60 Amp High
Current Fuse Power Distribution Box High Beams and High Beam Indicator 22 Amp C.B. Integral with Headlamp Switch Front Wiper and Washer 6 Amp C.B. In Fuse Panel Power Windows 30 Amp C.B. In Fuse Panel Cigarette Lighter, Flash to Pass and Power Lumbar 20 Amp C.B. In Fuse Panel


29af2f7.gif
e4cf291.gif

May 13, 2009 | 1992 Ford Ranger

1 Answer

Wireing diagram


have you test the fuse and tried to by- pass the switch on the trans to see if the lights will work and as allways are the bulbs good

Apr 06, 2009 | 1993 Dodge Dakota

1 Answer

I am trying to install a amp and sub in my 08 gmc


dont need a diagram,, most amps have a speaker level input...dont mix this up with line level....connect your wires from back of factory speakers to speaker level input on amp...then if your amp has a low pass switch select lowpass setting now you have punch

Mar 29, 2009 | 2008 GMC Sierra 1500

1 Answer

Need wireing diagram to change 72 nova over to hei distributor


Hey , just take the positive wire from the coil you are removing and feed it to the + terminal on the HEI dist. cap.the other terminal under there is for your tachometer. If you are mounting a master kill switch in the bumper for drag racing- attatch the kill wire to the tach terminal also.
Thats it you just plug the three wire pigtail from the dist. base(pickup) to the cap and you are off.
Remember firing order is 18436572 in a clockwise direction. to find #1 remove #1 plug and have someone"bump" the engine over while holding your finger over the hole-carefull. then line up the slotted mark on the crank pulley with the big notch on the timing indicator. Good luck

Aug 31, 2008 | Chevrolet Chevy Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...