Question about Cars & Trucks

Open Question

How do you replace the tail light bulb on a 2000 cadillac sts seville car

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 341 Answers

SOURCE: service engine soon light on a 2000 cadillac seville

The service engine soon light indicates you have a problem with the engine management system.The only way to get it to stay off is to lacate and repair whatever is not working correctly. Requires very specialized equipment. Take it to your mechanic.

Posted on Nov 28, 2008

Ad
  • 41 Answers

SOURCE: replace power steering pump and lines 1992 cadillac seville sts

you need to have a pulley puller to get the pulley off if you don't have one most auto zone part stores have a loan a tool program and they can help you with that on most powersteering pumps the high pressure line will be a fitting or bolt on and the return line is usually just a squeeze clamp hope this helps good luck

Posted on Jan 30, 2009

cadman000
  • 607 Answers

SOURCE: I have a 94 cadillac seville sts, end I have a

First thing you have to do is list all the codes, because some some might be stored for a long time. Pushing the OFF and WARM buttons together and holding will ghive you all the stored codes. Then press OFF and HI together to clear all codes. Hold and wait for bars or 0's. Now start your car and let it get up to proper operating temps. Take car for aride that aincludes all phases of driving including highway speeds. Observe SERVICE ENGINE LIGHT for coming on . Assuming it does , repeat steps previously provided, read codes stored and repair accordingly. If need be contact me with new codes and I will try to assist you.

Posted on Mar 16, 2009

  • 55 Answers

SOURCE: How do I change my rear brakes on my 2000 Cadillac

you will need to remove the parking brake cable from the caliper then remove the lower slide pin bolt, flip the caliper up and pull out the old pads and install the new ones. You should get the rotors machined for the best braking performance or replace them.

Posted on May 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace led bulbs on 2008 Cadillac STS??


You need to buy the entire tail light housing or if its the cyclops light in the center, you'll need to replace it as a whole part. You cannot replace individual leds on those parts.

May 25, 2015 | 2008 Cadillac STS

1 Answer

How do I fix my brake lights on a 1998 Cadillac sts seville


Depends on what the problem is.
Do you have power in and out of the brake light switch ?
And in and out of the turn signal switch ?

Apr 06, 2013 | 2000 Cadillac Eldorado

1 Answer

How do I replace the Tail light bulb in my 2005 Cadillac STS


2005 used an LED panel i don't think you can change just a bulb

Sep 12, 2011 | 2005 Cadillac STS

2 Answers

Third tail light inop on 2000 cadillac seville


As long as it isn't an led, It might just be out and the bulb may need to be replaced.

Jun 09, 2011 | 2000 Cadillac DeVille

1 Answer

How do you change the brake light on a 2000 Cadillac Seville STS ?


Open the trunk and locate the screw that hold the lense assembly, remove screws, turn the socket that holds the brake bulb which will releas the socket, pull out the bulb, and replace with new bulb, reinstall in reverse order.

Jul 10, 2010 | 2000 Cadillac Seville

1 Answer

How do I R&R front motor mounts on 2000 cadillac sts


Very easy, just remove front tires and unbolt, BUT I doubt you are asking right question. Not mounts, but mount in dead front center is problem. There are 4 mounts, transmission center back, left center and right center and front center. That takes full torque of motor and heat from exhaust. GM has a shield for exhaust.

Dec 02, 2009 | 2000 Cadillac Seville

1 Answer

1995Sev Rear Tail & Brake Light "Possessed" & Mostly not working


if the hi mount brake lamp lights up then it is not the brake lamp switch, the other brake lamp wiring runs from the brake lamp switch through the turn signal switch. i would check all the light bulbs and sockets first because these cars like to burn out the grounds in the socket. i was a tech at a cadillac dealership for ten years, also had a 95 sts myself with the same problem. if that doesnt work then look toward the turnsignal switch and the wiring.

Feb 21, 2009 | 1994 Cadillac Seville

1 Answer

Replace tail lights


Usually all you have to do is pull back the inside trunk liner behind the tail lights from inside the trunk, or there may be a plastic door that you open to access the tail lights. The wires going to the tail lights connect to a plug that you turn counter clockwise and pull out from the back of the tail light assembly. Once you have removed the connector replace the bulb. Some light bulbs just pull straight out of the connector, others you may have to push in and turn counter clockwise to remove.

Oct 03, 2008 | 2001 Cadillac Seville

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...