Question about 1999 Dodge Durango

Open Question

1999 dodge durango wont shift out of first gear

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 170 Answers

SOURCE: wont shift out of 1st gear 2001 dodge durango 5.9

Could be a bad speed sensor which screws into the trans. You have the 46RE trans which should be serviced every 30-40k mills and also have its bands adjusted.

Posted on May 10, 2010

justuscc
  • 360 Answers

SOURCE: 1999 Dodge Durango

the humming noise is the front drive shaft u joints as far as the shifting ??????? check the fluid level in the tranny........ fully warm and in neutral..... set the park brake..... it should be in the "hot" area or just under

Posted on Oct 15, 2008

  • 217 Answers

SOURCE: getting rear gears out of the difential case 1999 dodge durango

  1. Raise and support vehicle. Ensure that the transmission is in neutral.
  2. Remove wheel and tire assembly.
  3. Remove brake drum. Refer toBrakes, for proper procedure.
  4. Clean all foreign material from housing cover area.
  5. Loosen housing cover bolts. Drain lubricant from the housing and axle shaft tubes. Remove housing cover.
  6. Rotate differential case so that pinion mate gear shaft lock screw is accessible. Remove lock screw and pinion mate gear shaft from differential case
  7. Push axle shaft inward and remove axle shaft C - clip lock from the axle shaft
  8. Remove axle shaft. Use care to prevent damage to axle shaft bearing and seal, which will remain in axle shaft tube.
  9. Inspect axle shaft seal for leakage or damage.
  10. Inspect roller bearing contact surface on axle shaft for signs of brinelling, galling and pitting. If any of these conditions exist, the axle shaft and/or bearing and seal must be replaced

Posted on Feb 11, 2009

  • 1 Answer

SOURCE: all the sudden my 1999 dodge durango wont shift into reverse?

My 1999 Durango stalls when it’s cold and I shift into reverse. Once the motor is warm reverse works fine.

Posted on Apr 17, 2009

MNfisherman
  • 11896 Answers

SOURCE: 1999 Dodge Intrepid...shift lever wil shift gears

I believe that the cable has to be adjusted. Most cases, the cable adjustment is off. Worst case senario, is the bushing in tranny is worn out.

Posted on Jun 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Dodge Durango transmission


that sounds like it went into limp mode . take it to a dealer

Mar 11, 2015 | 1999 Dodge Durango

1 Answer

My 1999 dodge durango will not shift gears it wants to stay in first gear


you could have an internal mechanical problem with the transmission or the transmission has gone into what is called backup mode and will have to have the tcm checked for codes to check out the problem.

Oct 27, 2011 | 1999 Dodge Durango

1 Answer

Transmission wont shift into 3rd gear


this might be a simple problem with your gear linkage, your rubber bushes might be worn out, get them replaced... or your gearbox might have broken its synchronizer which actually shifts the gear in the gear box... i prefer u go see a mechanic

Oct 10, 2011 | 1999 Dodge Durango

2 Answers

All the sudden my 1999 dodge durango wont shift into reverse?


YES SOUNDS LIKE IT IS THE SOLENOID NOT SHIFTING INTO REVERSE OR TRANSMISSION CONTROL MODULE NOT SENDING SIGNAL TO VALVE BODY SOLENOID

Apr 06, 2009 | 1999 Dodge Durango

1 Answer

2000 durango vibrates when auto transmision shifts


check the motor and tranny mounts for the vibrations if the motor shakes a lot when in park while idling you may need to replace the mount(s)

Apr 01, 2009 | 1999 Dodge Durango

1 Answer

Why will my 99 durango not shift out of low gear


poss trans. problem make sure not stuck in 4wheel low if equipped w/4wd. does speedo work.

Nov 16, 2008 | 1999 Dodge Durango

1 Answer

1999 Dodge Durango


the humming noise is the front drive shaft u joints as far as the shifting ??????? check the fluid level in the tranny........ fully warm and in neutral..... set the park brake..... it should be in the "hot" area or just under

Oct 15, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...