Question about 2008 Chevrolet Cobalt LT1

Open Question

2008 chevy cobalt headlight wiring diagram

Need to replace or repair wires front headlight

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 109 Answers

SOURCE: 2004 Chevy Tahoe stereo wiring diagram

BLACK-ground
RED-accessorie
YELLOW-power 12v
PURPLE-left rear
GREEN-right rear
WHITE-left front
GREY-right front
BLUE-REMOTE
and the other blue one is for remote antenna..

Posted on Dec 04, 2008

jeff3600
  • 1 Answer

SOURCE: 2006 chevy cobalt headlights.

There are 2 nuts at top of headlight..Loosen those, also remove plastic push in tabs from grill...after that You will need to pry the headlamp out.It will take a few mins.!! Do not repalce the bulbs w/ those "Blue" bulbs they last all of 2 months,Because of the daytime running lights.It takes the life out of the bulb cause they run hotter!

Posted on Sep 06, 2008

  • 1043 Answers

SOURCE: 1990 chevy 350 distributor wiring diagram and firing order

The firing order is 1-8-4-3-6-5-7-2.
The distributor rotates in a clockwise direction. The engine must be on the compression stroke on the #1 cylinder. Line up the timing marks. Remove the cap and the rotor should be pointing to approximately the 5 o'clock position.

Good Luck

Posted on Mar 06, 2009

  • 290 Answers

SOURCE: 1998 Chevy blazer radio wiring diagram

http://www.the12volt.com/installbay/stereodetail/435.html

Posted on Apr 03, 2009

  • 548 Answers

SOURCE: How do you change headlight on Chevy 2008 Cobalt?

Open the hood by pulling the hood release latch located under the instrument panel on the driver's side of the car. Locate the secondary release latch on the front of the hood at the center, slightly towards the driver's side. Slide the latch to the left to release the hood and raise it Locate the headlight assembly and remove the bolts by turning them counterclockwise. Set the bolts aside in a safe place, so you won't misplace them.Remove the plastic fasteners from the headlight assembly molding. Carefully pull back the front fascia, or molding. You may need an extra pair of hands to perform this slightly awkward task.Grab the headlight assembly and pull it towards the radiator at a slight angle to remove it. This should provide easier access to the headlight bulb and wiring harness.Lift the plastic locking tab on the wiring harness to disconnect the bulb base. Then, disconnect the wiring harness from the bulb socket and remove the black retainer by turning it counterclockwise.Disconnect the bulb socket by turning it counterclockwise. Remove the old bulb from the socket by firmly, but gently pulling it straight out.Replace the old bulb with a new 9007 LL halogen headlight bulb. Put your headlight assembly back together by reversing the steps when you disassembled it. Use 89 inch-lb torque when retightening the headlight assembly bolts.

Posted on Sep 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Chevy cobalt parking lights work low and high beam headlights do not what is the problem


Do you know what relay's and BCM's are ! Without testing i would be guessing ! The switch that switches headlamps from low to hi would be a good guess . You know how to do automotive basic electrical testing ? Video's on youtube Electric Testing Techniques You Need to Know And find wiring diagrams so you know which wires you want to test for the headlamp circuits . Free wiring diagrams at http://www.bbbind.com/free_tsb.html

Dec 17, 2016 | Chevrolet Cobalt Cars & Trucks

1 Answer

Where is the Hazzard flasher found in a 2008 Chevy Cobalt?


My searches indicate that it is not in the fuse box where it should be. The flasher relay is shown under the left side of the dash console, but then I found this.

The Chevy cobalt does not have a flasher relay, the cobalt turn signals are fully solid state and run through the PCM (powertrain control module) in the car, the sound comes from your speaker in the front left.
http://www.fixya.com/cars/t26193585-4_ways_flasher_located_in_2008_chevy


http://wiringmanuals.blogspot.ca/2014/08/2008-chevrolet-cobalt-engine.html#more
Wiring Diagrams and Free Manual Ebooks

May 13, 2016 | Cars & Trucks

1 Answer

Chevy cobalt headlight wiring diagram


WHY did everyone give RADIO wire diagrams when he CLEARLY asked for Headlight wiring ****

Feb 09, 2012 | 2008 Chevrolet Cobalt LT1

1 Answer

2008 Chevy Cobalt front right turn signal is not working. Back right signal blinks fast. Left signals work just fine. I tried replacing the bulb and it did not work. Do I need to replace the...


No - headlight ok.
The reason that the Right turn signal blinks fast is that there is half the normal load (resistance)
on the right side, since the Right front turn signal isn't working.
Since you replaced the Right front turn signal bulb, your problem lies in the bulb socket or
the wiring to the socket.
(1) try cleaning out the socket - there's probably a contact problem in the socket. You
may need to squeeze the contacts together to provide good contact to the socket contact.
(2) if contacts inside the socket are ok, try back-probing the socket - to make sure that the
socket is getting 12V DC to light the bulb. Replacing a bulb socket is easy, and commonly done.
Any auto parts dtore should be able to sell you a new socket - its just a matter of cutting out the
old one, and then splicing in the new one. Most shops will use small wire nuts, buried under several
wraps of E-tape (electrical tape).
(3) if bulb AND socket ok, you have the worst problem known to man - a wiring fault. In this case,
you'll want to run a new wire from the flasher module (under the dashboard) to the turn signal.

Jul 29, 2011 | 2008 Chevrolet Cobalt

1 Answer

Cobalt 2005 ls headlight bulb replacement


Instructions Things You'll Need:
  • 9007 LL halogen headlight bulb
  • Wrench
  • Gloves or clean rag
  1. Step 1 Set the parking brake and remove the keys from the ignition to ensure your Chevy Cobalt won't roll while you're replacing the headlight bulb.
  2. Step 2 Open the hood by pulling the hood release latch located under the instrument panel on the driver's side of the car. Locate the secondary release latch on the front of the hood at the center, slightly towards the driver's side. Slide the latch to the left to release the hood and raise it.
  3. Step 3 Locate the headlight assembly and remove the bolts by turning them counterclockwise. Set the bolts aside in a safe place, so you won't misplace them.
  4. Step 4 Remove the plastic fasteners from the headlight assembly molding. Carefully pull back the front fascia, or molding. You may need an extra pair of hands to perform this slightly awkward task.
  5. Step 5 Grab the headlight assembly and pull it towards the radiator at a slight angle to remove it. This should provide easier access to the headlight bulb and wiring harness.
  6. Step 6 Lift the plastic locking tab on the wiring harness to disconnect the bulb base. Then, disconnect the wiring harness from the bulb socket and remove the black retainer by turning it counterclockwise.
  7. Step 7 Disconnect the bulb socket by turning it counterclockwise. Remove the old bulb from the socket by firmly, but gently pulling it straight out.
  8. Step 8 Replace the old bulb with a new 9007 LL halogen headlight bulb. Put your headlight assembly back together by reversing the steps when you disassembled it. Use 89 inch-lb torque when retightening the headlight assembly

Feb 26, 2010 | 2006 Chevrolet Cobalt

1 Answer

2005 Chevy Cobalt lights turn off


automatic headlights are controlled by a photo sensor on the dash located in front of the Instrument cluster. to test the sensor try covering it and see if the headlights come on. faulty wiring in the circuit could also cause this problem. the headlights and the radio are wired together and the "auto" function will cause the radio to get brighter when its dark out, thus the combination of problems.

Dec 28, 2009 | 2005 Chevrolet Cobalt

1 Answer

How do you change headlight on Chevy 2008 Cobalt?


Open the hood by pulling the hood release latch located under the instrument panel on the driver's side of the car. Locate the secondary release latch on the front of the hood at the center, slightly towards the driver's side. Slide the latch to the left to release the hood and raise it Locate the headlight assembly and remove the bolts by turning them counterclockwise. Set the bolts aside in a safe place, so you won't misplace them.Remove the plastic fasteners from the headlight assembly molding. Carefully pull back the front fascia, or molding. You may need an extra pair of hands to perform this slightly awkward task.Grab the headlight assembly and pull it towards the radiator at a slight angle to remove it. This should provide easier access to the headlight bulb and wiring harness.Lift the plastic locking tab on the wiring harness to disconnect the bulb base. Then, disconnect the wiring harness from the bulb socket and remove the black retainer by turning it counterclockwise.Disconnect the bulb socket by turning it counterclockwise. Remove the old bulb from the socket by firmly, but gently pulling it straight out.Replace the old bulb with a new 9007 LL halogen headlight bulb. Put your headlight assembly back together by reversing the steps when you disassembled it. Use 89 inch-lb torque when retightening the headlight assembly bolts.

Sep 05, 2009 | 2008 Chevrolet Cobalt

1 Answer

I need to remove the front headrest of a 2008 chevy cobalt lt


Push the button and pull up on it at the same time

Apr 04, 2009 | 2008 Chevrolet Cobalt

1 Answer

My 2005 chevy equinox- all my interier lights will not power on


its the fuses locate the fusebox and anyone thats burned replace it

Feb 07, 2009 | 2005 Chevrolet Equinox

Not finding what you are looking for?
2008 Chevrolet Cobalt LT1 Logo

Related Topics:

473 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...