Question about 1996 Ford Thunderbird LX

1 Answer

Brake hi, I wonder if there is a person who can tell me or find (ajuster) hand brake for a T-bird 1996

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,114 Answers

Should be rite under the hand leaver when you pull it up in between console and lever you have to pull it up and lay on drivers set to view it! good luck mustang was the same!!

Posted on Dec 23, 2008

  • singhisen_33 May 23, 2011

    My 96 Tbird doesnt have a handbrake. All it has is a foot actuated Parking Brake located under the dash on the left hand side, but mine is an automatic trans.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GL model. What are the specs for brake lines and fittings


Hi Audrey, Just tell the sales person at the auto parts store you need brake pads for a 1996 gl ford taurus and they'll look up the parts for you, I hope this helps..........CHEERS..

May 07, 2016 | 1996 Ford Taurus

1 Answer

Holden commodore problemsi have a vy commodore brakes just re-knewed but carnt see where to adjust hand break cable mcan u help


most times the hand brake top screws down to adjust the brake but there is normally an adjustment under car where the cables from the rear wheels join the single cable going to the hand brake If the hand brake top has been screwed down all the way loosen it up al the way before adjusting anything

Aug 20, 2014 | Cars & Trucks

1 Answer

How do I tighten the hand brake cable on my 94 Toyota Tercel?


First make sure the rear breaks are ajusted or replaced when worn out drum to be skeemed aswell. Usally whe rear brakes are ajusted hand break will stop car on two to four clicks on hand brake rachet. If brakes is ajusted check cables for wear . Then ajust cable insite car remove hand brake cover and you will see a ajustable screw or nut. Rememeber to put the handbrake on four clicks and dont tighten screw or nut to much the brakes will lock

Feb 12, 2013 | Cars & Trucks

1 Answer

Ajusting hanbrake ford au111 2002 falcon


Hi Shannon, There is an ajustment nut at the base of the hand brake it's self, you pull the cover strait off the end of the handle and it is a 10mm nut on a treaded piece of metal rod/cable. If it's as tight as it can get you may need new brake boots for you handbrake. Just checked ebay and they are $66 plus postage for a set :)

Remember righty tighty lefty loosie :p
hope this helps :)

Nov 17, 2012 | Cars & Trucks

2 Answers

How do i adjustment the handbrake on a rover 75 on a rover 75


should be self ajusting if not there should be a nut conected to the hand breake either remove cowling around hand brake if not i may be underneath the car where hand brake comes out of the floor but most cars now can be ajusted by removing the hand breke trim

Sep 19, 2012 | 1999 Toyota Corolla

1 Answer

Parking brake down to floor but does not hold,otherwise brakes work perfectly.how do you adjust parking brake. mechanic says you have to take brake off.


hes right too! if they dont fit an ajuster then the drums need to have self adjusters in them and they never work very well on an older car or even on a new one,,,,,wip off the drums and wind up the adjusters by hand,,,,also if your the type of person who pull on the parking brake like a ,,,griller on steroids,,,,
you only stretch the cable it dont put the brake on any harder

Aug 28, 2010 | 2004 Kia Amanti

1 Answer

1996 dodge ram 1500 rear brakes locking up any time new braks and no leaks and are clean. acts like more brake pressure on rear than should be the rear brakes are ajusted .it seems like theres to mch press...


if this system has short shoe long shoe set up make sure the short shoe is on front or it will cause this problem also i personally have had to try another set of shoes to remedy this wether there was a issue with lining material or what but parts house was working with us and offered to send another set to try and problem was taken care of also you can bevel leading edges of shoes with a file and may help have seen this correct problem on 05-06 chevy p/u grabbing

Aug 11, 2010 | 1996 Dodge Ram 3500 Club Cab

2 Answers

Parking brake light is on all the time??? i wonder why????


Could be low fluid in the brake fluid bottle, or the wires or sensor are faulty to the brake fluid, or front brake pads are low, or hand brake switch inside the car under the hand brake is faulty or out of alignment.

Hope this helps
Regards
Dan

Feb 11, 2010 | 1996 Honda Accord

2 Answers

I have a 1985 jaguar xj6 low, second and drive all work fine, when I put it in reverse you can hear the motor rpms change but car will not move in reverse. Also the speedometer works sometime and tach not...


It could be the reverse brake band. If you get a Haynes manual for this model, it will tell you where and how to adjust the bands.
Hope this helps

Dec 11, 2009 | 1985 Jaguar XJ6

1 Answer

Replace rear brakes adjust handbrake


The hand brake hardly ever needs ajusting. See your hand brake mechanincly spreads your rear brake shose inside the drum. Therefore just replace your rear shoes and make sure there ajusted right and you should have no more problems with that part of your car. PS make sure you put some 3M paste on the contact points on your backing plate to avoid a squeak in the near future.

May 16, 2009 | 2001 Ford Focus

Not finding what you are looking for?
1996 Ford Thunderbird LX Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...