Question about 2007 Chevrolet Equinox LS New Cars

Open Question

Where are the fuses on a 2007 equinox

Where are fuses located for door chimes,turn indicators sound and drivers door speaker.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 57 Answers

SOURCE: 2007 HHR Radio and chimes not working

Check the radio fuse. As unusual as it seems, GM has started having the radio (even though not turned on) generate the chimes and turn signal sounds. If the radio fails, all the chimes fail too.

This applies to other vehicles besides the HHR. My 2003 Silverado had the door chimes fade down so I could barely hear them. The fix was to replace the radio (under warranty, fortunately...).

Posted on Mar 22, 2010

csmock132
  • 4669 Answers

SOURCE: Door chime stays on

The door ajar switch on the side of the dash needs to hit the door panel to shut off the chime and dome light.Pull the switch from the dash and unplug it.

Posted on May 15, 2009

  • 1 Answer

SOURCE: 2007 silverado Radio sound And door chimes quit

Taking mine in tomorrow for the same thing. The arm on the parking brake rubs, very abrasively, against a binding of wires going from the cab to the door. If you can wiggle underneath your dash and take a look you might be able to see if the wires have been severed over time. I live in a hilly area and always use the parking break so it was just a matter of time. It is not recalled, but I am going to get the repairs under the extended warranty.

Posted on Dec 29, 2010

weekspena
  • 375 Answers

SOURCE: front door speakers not working.no

check your fuses, under dash and under hood!

Posted on Jan 10, 2011

dttech
  • 4803 Answers

SOURCE: trying to locate the fuse

Before continuing with your power sreering problem, please review these articles:
Where's The Fuse?
What Else Could Be Wrong?

The fuse for the Electronic Power Steering (EPS) is marked "EPS" and is located in the underhood fuse block on the left side of the engine compartment. It is an 80 Amp fuse. If this fuse was blown as a result of jump-starting the engine, something must have gone terribly wrong! Like - maybe the cables got hooked up backwards or something? You probably have some serious computer system damage...I would get prepared to spend some BIG BUCKS!

Posted on Apr 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My aftermarket radio is not working in my 2005 Chevy equinox. Do anyone know why? It's a new radio and all of the wires are connected properly. The chimes stopped working as well. Fuse are new as well


The chimes work through the factory radio , come out driver door speaker . There is a interface module you need to hook up on GM vehicles so aftermarket radios will work . With these newer vehicles your better off taking to someone or place that does this on a daily basis . Does it start an run ? If it does i'm surprised , factory radio is also hooked to the vehicle serial data network , class 2 . Suggest you google that .

Battery positive voltage is provided to the radio from the Radio (15A) fuse in the fuse block. The radio is grounded through a braided cable case ground. The radio is enabled/disabled by Class 2 messages from the body control module (BCM). The entertainment system on this vehicle is configured with a base and uplevel system. The base and uplevel systems contain a radio, antenna, speakers, and on some vehicles an audio amplifier.

The audible warnings alert the driver of a system concern or a critical vehicle condition. The radio generates the audible warnings. The BCM receives audible warning requests via the class 2 serial data line or the controller area network (CAN) data line. If the BCM receives multiple audible warning requests, the warning with the highest priority sounds first. The following lists the audible warning priority and the pulse rate:
Fast rate chime--200 pulses per minute
Medium rate chime--150 pulses per minute
Slow rate chime--50 pulses per minute
Single chime

Mar 15, 2017 | Cars & Trucks

2 Answers

Got in my 09 Impala after work & no display or sound from my radio. Went to the gas station stopped opened the door no door chime? I have no clue what the problem is, the dash indicators work?


It seems to me you should check your fuses, they burn all the time. There inside your car most of the times under or near the steering wheel somewhere in that erea

Sep 23, 2016 | 2009 Chevrolet Impala

2 Answers

My sister has a 2000 chevy cavalier b4 the door chime and the interior dome light worked now they both dont, we replaced the bulb and fuse to no avail and I have no clue what's wrong with the chime.


the chime actually is done with the radio. the front drivers door speaker. so if the radio works and the front left speaker works. then more then likely you have a defective door switch. located in the door jam that controls the dome light

Apr 20, 2015 | 2000 Chevrolet Cavalier

1 Answer

I have a 2007 equinox and the drivers side front speakers stopped working.


Pop the cover off,pull the speaker,and make sure the wires are plugged on to the terminals.Simple fix.

Apr 14, 2014 | 2007 Chevrolet Equinox

1 Answer

No sounds coming speakers


see if the speakers are not blown,,, been there done that.. door chimes work through drivers side door...

Oct 24, 2013 | GMC Cars & Trucks

6 Answers

2008 Cobalt - Front speakers not working and no audible turn signal. Both stopped working at the same time.


In my 2008 Cobalt, the front speaker in the driver door went inoperative - no turn signal noise, no warning chimes for door open with key in, seatbelt chime, low fuel chime, and of course, no music. All of those sounds come through the speaker. I switched the driver door speaker and the passenger door speaker, and now I have all of those noises back.

If you have manual roll down windows, you'll have to buy a special tool to remove a little clip that's behind the roller handle. This tool was included in a kit for about $7 that I bought at Harbor Frieght, but you might be able to find the kit at other auto parts stores. Google "removing window crank" and you should be able to locate a video that shows how to get it off.

Anyway, I switched the speakers and now we just don't have music coming out of the passenger door speaker, but at least we have all of the warning chimes and turn signal clicking noise again.

The dealer wanted almost $200 for a new speaker and to replace it (labor). Rediculous.

Jul 20, 2010 | 2008 Chevrolet Cobalt

1 Answer

2007 HHR Radio and chimes not working


Check the radio fuse. As unusual as it seems, GM has started having the radio (even though not turned on) generate the chimes and turn signal sounds. If the radio fails, all the chimes fail too.

This applies to other vehicles besides the HHR. My 2003 Silverado had the door chimes fade down so I could barely hear them. The fix was to replace the radio (under warranty, fortunately...).

Mar 10, 2010 | 2007 Chevrolet Tahoe

1 Answer

1997 venture keyless remote programming


SYSTEM OPERATION

System warning lamp located on top of the instrument panel
Press UNLOCK button once , turns on interior lamps and deactivates alarm (if fitted)
Press UNLOCK button twice w/in 5 seconds unlocks all doors, turns on interior lamp and deactivates alarm (if fitted)
To activate alarm system (if fitted):
Switch ignition OFF
Open driver's door
Press Lock button on remote
Close Driver door
warning lamp will flash when system is activated
Press remote power sliding door button will open sliding door (if fitted) only if unlocked first
Pressing remote panic button:
*Sounds horn intermittently
*Flashes exterior lamps
*Turns on interior lamps
**Pressing panic for the second time OR switching ignition ON deactivates alarm.


PROGRAMMING
Remobe key from ignition switch
Remove the "BCM PRGRM" fuse, from the fuse box
Close all doors
Turn ignition switch to the ACC position
With in 1 SECOND , turn the ignition switch to OFF then back to 'ACC'
(really, with in one second)
Open and close the driver's door. A chime will sound, indicating programming mode activated
Press and HOLD LOCK and UNLOCK SIMULTANEOUSLY untill a chime sounds 2 times ( about 15 seconds)
Repeat this exact procedure for all remotes to be programmed
Remove key from ignition
Refit 'BCM PRGRM' fuse.

4 REMOTES MAXIMUM CAN BE PROGRAMMED

Aug 24, 2008 | 2000 Chevrolet Venture

Not finding what you are looking for?
2007 Chevrolet Equinox LS New Cars Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...