Question about 1995 Mitsubishi Galant

1 Answer

I have a 1995 mitsubushi galant turns over but dosent start can you help

In the passed some times id have to jiggle the key to get it to start

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Could be an old security system interfering with the ignition module,but lets start with the basics. you need three things to make a internal combustion engine run 1. AIR.. you have to have a good supply of fresh air. its just like you , it needs oxygen...2. FUEL.. if your not feeding the combustion chambers you will not have combustion....3. SPARK.. if you dont have spark to ignite your AIR..AND . FUEL. you just wind up with wet spark plugs. check these simple things and let me know.. ill look later to see if you found anything..see if i can help u farther then....just a side note if you have a security system on this vehicle..try this.Lock all the doors make sure no-one is still in the car then unlock the drivers side door with the key. this resets alot of them

Posted on Feb 09, 2012

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 91 Answers

SOURCE: 1995 mitsubushi galant cranked and started. I

Put it on a scanner, it may be a crank sensor, timing positioning sensor,may have a bad timing belt.

Posted on Feb 25, 2011

emissionwiz
  • 80668 Answers

SOURCE: Multiple times during this week,

Here is what you need to do 1st, go to your local auto parts store or hardware store and buy a tube of powdered Graphite lock cylinder lubricant, u then spray the dry lube into the ignition lock cylinder and insert key and turn the lock cylinder to run and off again and do this at least 3 or 4 times, then repeat, clean up the excess powder and u should be good to go, if the problem continues you will need the ignition lock cylinder replaced and the security system programmed for the new key and cylinder, so that will be a dealer job.

Posted on Sep 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 toyota .my dashlights and intreior light do not work.had starter replaced .problem started then


assuming the battery is good. if none of the dash light come on while the key is in the ignition and it turn to on position, check fuse and relay and ignition systems. see if you can play with with ignition systems by jiggle and wiggle turning the key back and forth start the engine and see if you get any contact. all dash light has to come on when the key is turn to on position, if not you have no power to ECU. ecu turn on everything from your fuel pump and the sparks. hope that help some

Sep 30, 2009 | 1995 Toyota Pickup

3 Answers

ECU Location on 2001 Galant ES


i think it is under the dash at the side passenger

Jun 05, 2009 | 2001 Mitsubishi Galant

1 Answer

Ignition problem


You've tried pulling steering wheel hard from one side to the other while turning key? Always try to avoid shutting vehicle off with wheels turned, keep straight when turning off. Are you parking on a sloped drive by chance? If yes, press hard on brake pedal when trying to turn key, if no luck, try rocking car forward ,back, while trying to turn key.

May 10, 2009 | 2000 Alfa Romeo 156

3 Answers

95 chevy caprice pass key fault.


WELL I HAD THE SAME PROB. ON A 95 CHEVY CAPRICE.I REMOVED THE IGNITION AND THE WIRE WAS BROKE.WHEN U TURN THE KEY THE PASS KEY WIRE TURNS WITH THE IGNITION,WHAT A FAULTY DESIGN.ANY HOW BUY A NEW IGNITION AND KEY THAT SHOULD SOLVE THE PROB. GOOD LUCK

Feb 25, 2009 | 1995 Chevrolet Caprice Classic

1 Answer

Mitsubishi Galant 1995 ignition problem


its probably ign swich - located on end of ignition cylinder - round with 5 maybe 6 male terminals harness plugs into

Dec 22, 2008 | 1989 Mitsubishi Galant

Not finding what you are looking for?
1995 Mitsubishi Galant Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...