Question about 1998 Mitsubishi Mirage
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!
Posted on Mar 15, 2009
They should be able to do that. Give them the yr , make, model, enginesize and you mention the rotor cams. I've never heard that term except when speaking of point type ignitions.. Is this a point type? Do not be concerned about pulling the old one unless you need the car. Then, take the car to them and you can do your comparisons ther at the store, Good Luck What is your concern about pulling it out? -Ned
Posted on Jul 14, 2009
i would replace the fuel pump. and the reason your gas gage is not reading what it is supposed to be is because the sending unit is prob bad. both of which are in the gas tank. im not sure on that year but i think you can remove the back seat or a piece of the trunk to get to both of them. if not the gas tank will need to be dropped to get them out
Posted on Nov 28, 2009
Posted on Mar 06, 2010
Testimonial: "It's the fuel pump indeed. Also the gas tank found to be very dirty. The fuel pump was replaced, fuel system cleaned, now the car runs perfectly."
Tips for a great answer:
Mar 23, 2016 | Mitsubishi Cars & Trucks
Mar 26, 2011 | 1998 Mitsubishi Mirage
Apr 10, 2010 | 2001 Mitsubishi Mirage
Mar 17, 2010 | 1998 Mitsubishi Mirage
Nov 19, 2009 | 1995 Mitsubishi Mirage
Aug 22, 2009 | 1993 Mitsubishi Mirage
Jun 22, 2009 | 1998 Mitsubishi Mirage
Apr 24, 2009 | 1998 Mitsubishi Mirage
Feb 25, 2017 | 1998 Mitsubishi Mirage
174 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: