Question about 1992 Mitsubishi Mirage

1 Answer

Central locking stopped working on the passenger door quite some time ago then the drivers door stopped working moonths/year later. What could be the issue??

Posted by on

  • ponty_00 Nov 16, 2008

    I have just had the same problem

    Ive replaced hthe fuse and battery for the remote, still no good

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 63 Answers

Remove the central locking switch on driver side and check for 12volts and ground presents. probe if you have a good continuity when you push the switch to on. due to aging, some connectors needs cleanup, spray with electronic contact cleaner or wd40. this problem is usually cause by open connection or discontinuity to the actuator. best if you could activate each acuator by supplying it individually. it might have sockets, try to look for it so you can gain access to supply it manually. once its activated, when you hooked all, should work normally. if not then, the problem is on the cental locking system unit.

Posted on Apr 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can the immobilizer or central locking be switched off in a Nissan Almeria 2001 car?


you can remove the central locking fuse , this will stop the lock/unlock constantly , the problem is usually with the drivers door lock mechanism , that is perhaps why you cant lock/unlock with the key, lock from inside vehicle and get out passenger side, that lock should work with the key until you get the lock changed on drivers door

Jun 11, 2015 | Nissan Almera Cars & Trucks

1 Answer

My right side passenger door does not lock automatically anymore. Is there a fuse that operates this.


no all is related to one fuse you can remove the door internal controls and decore and remove center lock motor plug and test two connectors with multimeter with set on 12v and then lock un lock door and check the reading of the multimeter if it read signal then all plugs and wires from central lock control unit to the door central lock unit is okay it this cae you have to replace the door central lock unit with the same if no signal is readed while you lock unlock the door then you have to check central control unit and all wire plus out of it to the door plug

2- you can remove central control unit from driver door and test it in passenger door (usually the same unit ) if it works with lock unlock its then the replaced unit is faulty and needs to be replaced if it not work then check plugs wires from central lock unit (usually found inside driver door ) to the central lock unit in passenger door

3- check signal for said door fro the output of central door unit if no signal then it mean that faulty central lock control unit

Feb 23, 2015 | 2005 Honda Accord

1 Answer

Central locking 2005 subaru liberty stopped working on 2 doors


1. Replace battery in remote
2. Replace sensor at rhf door lock (it is inside of door)

Apr 30, 2014 | Cars & Trucks

1 Answer

My passenger door central locking has stopped


Method 1: Press lock or unlock button 4 times in succession. Method 2: Switch ignition ON and OFF. Within 10 seconds press lock and unlock button in succession.
This is the only manual reset
If this does not work go to your local auto electrician
The probable fault could be central locking activator passenger door

Jul 15, 2010 | 2002 Mini Cooper

1 Answer

Central door lock system not working


CHECK THE DOOR LOCKS MAIN FUSE.

May 03, 2010 | 2000 Honda Accord

1 Answer

Central locking


turn key twice when opening, ie turn right. once drivers door will unlock, turn twice passengers doors will unlock, and locking is turn anti clock wise once will lock all doors, turn twice will set door dead locks.dead locks will stop openand lock internal button working and handle from opening door. the same actions can be applied to the remote one press drivers door, two press passenger doors, press and hold unlock button for 5 seconds and rear window will open.

Apr 23, 2010 | 2003 Land Rover Freelander

1 Answer

1999 Audi A3 1.8T Electric Windows and Central Locking Won't work


will your passenger door open with the key and is it just one side that your windows are not working or both. if its just one side it might be your regulator motor in the door thats not working if its both it might be your central locking pump usually in the boot. however if both of them are working fine it could be that your key needs reprogrammed however i think the 1st 2 are more likely to be the problem.

Jun 24, 2009 | 2002 Audi A4

1 Answer

1998 Toyota Corolla Electric Door Lock Problem


You'll need to replace the solenoid (motor) that doesn't work. Not hard once you get the door panel off. I suggest you buy the correct part, not a universal one.

Jun 12, 2009 | 1998 Mitsubishi Eclipse

1 Answer

Central locking not working


does it work in the passenger door

Dec 27, 2008 | 2002 Volkswagen Golf

Not finding what you are looking for?
1992 Mitsubishi Mirage Logo

576 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...