Question about 2007 Nissan Murano 3.5
Nissan Murano 2007 model year, after three repairs, the engine was replaced and not correcting faults.The computer showed a fault in a cylinder, disassembly showed that the exhaust valve burned out after valve replacement and installation of the cylinder head, the day the malfunction indicator light up again and continued engine roughness, bylili replaced lambda meters. What do you think about it, and that suggest?
What are the fault codes you now have, do not assume it is the same problem causing the rough run. I suspect that something was not done right during the overhaul/rebuid.
Posted on Feb 09, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
most likely is abad a/f sensor b2.however make sure no exhaust leaks near sensor that can effect operation of sensor.most importantly....after replacement self learning values MUST be cleared.
Posted on Jan 17, 2011
tats the engine management light mate usally comes on when u have low oil or antthing to do with the engine bring it to nissan dealer if its not low oil they will hook it up to a machine and bingo they have your problem.
Posted on Feb 24, 2010
p0325 is, ignition system or misfire, could be plugs, wires, or a bad coil. p1126 throttle control motor relay curcuit open.P1126 Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery voltage is provided to the ECM. When the ignition switch is turned OFF, the ECM sends an OFF signal to throttle control motor relay and battery voltage is not provided to the ECM. possible cause, Harness or connectors (Throttle control motor relay circuit is open Throttle control motor relay.
Posted on May 07, 2010
Tips for a great answer:
Jan 02, 2017 | 2009 Nissan Murano
Dec 17, 2016 | Nissan Cars & Trucks
Feb 10, 2016 | 2003 Nissan Murano
Nov 14, 2012 | 2007 Nissan Murano S
May 06, 2012 | 2007 Nissan Murano SE
Feb 14, 2011 | Nissan Versa Cars & Trucks
Jan 03, 2011 | 2007 Nissan Murano SE
Feb 21, 2010 | 2006 Nissan Murano
Oct 30, 2009 | 2003 Nissan Murano
530 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: