Question about 2004 Toyota Tacoma
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Here is your Solution!
You will need to Locate the Belt Tensioner. It has a Large Pulley on a Bracket that Has a Bolt in the Middle and a Smaller Pulley that Goes Under the Belt and Holds Tension on it. You will need to get a Wratchet, Socket, and Cheater Bar. Turn the Bolt On the Top Large Pulley with the Wratchet and Cheater Bar. This will Lower the Smaller Pulley So that you will be Able to Remove the Belt. Please Rate My Response! Thanks! P.S. the link below is for the Belt Routing Diagram.
Posted on Feb 06, 2009
On my 2005 Tacoma with the 4.0L V6, I found it easier to change the belt from under the truck. Just remove the skid pan. Plenty of room to install the belt. The tensioner pulley is the one at about 2-o'clock from the crankshaft with the belt nearly all the way around it.
Posted on May 19, 2009
Just make sure the timing belt is on properlyy, lining up the cam and crank in proper position to each other. The engine willstart when fully assembled because the electrical has not be altered. If it has a crank position sensor , be sure to put it back on after cleaning it and the connector.
Posted on Nov 14, 2009
You're going to lose some coolant, so have a bucket or other container ready. Follow the upper radiator hose to the point where it's connected to the engine. The hose is clamped to a metal housing which is bolted to the engine. Remove the bolts (not the hose) and lift the housing to expose the thermostat (may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the housing and the engine. Install the new thermostat and gasket, replace the bolts, add coolant as necessary, and you're done.
Posted on Jan 04, 2010
Tips for a great answer:
Aug 26, 2014 | 1998 Toyota Tacoma
Feb 28, 2013 | 1998 Toyota Tacoma
Jul 04, 2012 | 1998 Toyota Tacoma
Below is the master help link
provided to go through belt routing diagram:---Timing belt, drive belt,
serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all
types of car models?
Click the link below: ----
----------This will help. Thanks.
Jan 30, 2012 | 1998 Toyota Tacoma
Dec 29, 2009 | 2004 Toyota Tacoma
Nov 22, 2009 | 1998 Toyota Tacoma
Oct 09, 2009 | 1998 Toyota Tacoma
106 people viewed this question
Usually answered in minutes!