Question about Mitsubishi L200

Open Question

My l200 animal 07 reg di-d engine loses power at 3000rpm

Loses power at around 3000 rpm

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

nickkerwin
  • 2 Answers

SOURCE: I have an L Reg

try replacing your fuel filter, or unblocking the vents on your fuel tank, had this problem with mine and this fixed it

Posted on Jan 30, 2009

  • 636 Answers

SOURCE: 1996 Triton GL serious motor surge 3000rpm

Could be the injection pump any black smoke or gray smoke? could also be an injector ?

Posted on Jul 27, 2009

  • 74 Answers

SOURCE: No power at 3000 rmp

Have the machanic check the catalyst converter.

Posted on Aug 04, 2009

planet-x
  • 232 Answers

SOURCE: p1613 fault code & engine will not rev over

Crank sensor or engine speed sensor is faulty.

Fault:
Irregular power loss on accelerating
The speed of the engine is limited till 2500rpm
Frequent loss of crankshaft position sensor signal

Cause:
It is caused due to leaking from thermostat housing into crankshaft position sensor harness multi-plug

Remedy:
Check and clean the crankshaft position sensor harness multi-plug contacts. Rectify the engine coolant leak from the thermostat housing if found. Take a note of the engine coolant level and monitor it for changes, showing a leak is indeed occurring.

Posted on Oct 24, 2009

Danniboi
  • 1098 Answers

SOURCE: mitsubishi l200 animal 2006 leaking oil from steering rack

Its most likely a seal on the power steering rack by the age it will most likely just be a seal they are about £7 in UK but possible the rack is goosed although I doubt it, please be careful using the car as it can lock the steering in position, and,,,, well you get it.

Posted on Jan 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

High emmisions loss of power at 3000 rpm diagnostics says no fault found


You didn't mention what sort of car you have.
You can try disconnecting the electrical lead on the MAP sensor. Then give the car a test drive.

A faulty MAP can cause high emissions, erratic running and high fuel consumption.

You can also try cleaning the EGR - the exhaust gas recycler valve.

It's strange that you have no fault codes. There is no check engine light illuminated?

Mar 15, 2016 | Cars & Trucks

1 Answer

2002 jaguar xj8 when I drive it won't go over 3000rpm


Jaguar wont rev 3000 rpm Questions & Answers - Fixya

www.fixya.com > Forum > Tags > wont rev 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... Wont go beyong 3000 Revs s type 2001, wont go beyond 3000 Revs and it' in limp ... Question about 2002 X-Type ... My jaguar xjr8 year 2000 battery went dead started car went for short drive back ...

Jaguar engine cuts 3000 rpm Questions & Answers - Fixya

www.fixya.com > Forum > Tags > engine cuts 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... engine cuts out and shudders at 3000 rpm won't accelerateobd code p0332 2002 jaguar x type 3.0 l P0332 - Knock ... Car is boging out in park and will not go over ... driving, don't worry about it.

Rev Won't go up

www.jaguarforum.com/showthread.php?t=14662

Dec 15, 2015 | Jaguar Cars & Trucks

1 Answer

Wont go over 3000 rpm


Any codes? Blocked fuel filter and/or damaged fuel lines?

Sep 13, 2013 | Toyota Land Cruiser Cars & Trucks

1 Answer

I have a 2008 mercury Milan with nearly 60k miles on it. When I come to a stop the rpm drops by 1000 then recovers quickly. What should I do to fix the problem? Any suggestions will be greatly appreciated.


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode? http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces? http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increases http://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000? http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills? http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPM http://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM? http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | Cars & Trucks

1 Answer

Driving on the road the RPM goes higher wituout speedind


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode?http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces?http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM?http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral?http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increaseshttp://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000?http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills?http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPMhttp://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM?http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | 2008 Toyota Avalon

1 Answer

Idels fine when driving it sometimes loses power and stalls if you rev the idel above 3000rpm it stops and runs fine till you stop or slow down the idel below 3000 rpm it shutters and...


If you don't have a check engine light, Start with the air and fuel filter, work your way up to a tune up. Clean the throttle body as best you can on the inside, behind the throttle plate/s

Feb 24, 2011 | Honda Accord Cars & Trucks

1 Answer

I just wanted to know the optimal shifting points to do 70mph comfortably. Should the car be at 2500-3000 rpm in 5th gear at 60-65 mph? I typically shift at or around 3k rpm in every gear, and the car...


How many gears does your car have? One of my cars has to do a little over 3000rpm to maintain 70-75 in 5th gear. My other car has to do about 3000rpm to maintain 65-70 in 5th gear.

It all depends on the number of gears your car has and the gearing ratio. The second car I have is geared more optimally for city driving and gets better fuel economy going slower than fast highway speeds.

Having driven several rental cars too I would say anywhere between 2500 to 3000 is reasonable for the average car. If you are driving a vehicle like say a porsche, bmw or audi they may have more gears and may be at a lower rpm at 70mph than your car.

Nov 04, 2009 | 2007 Suzuki Forenza Sedan

1 Answer

P1613 fault code & engine will not rev over 3000 rpm when you get to 3000rpm it then fluctutated between 2500 rpm & 3000 rpm causing the car to buckaroo


Crank sensor or engine speed sensor is faulty.

Fault:
Irregular power loss on accelerating
The speed of the engine is limited till 2500rpm
Frequent loss of crankshaft position sensor signal

Cause:
It is caused due to leaking from thermostat housing into crankshaft position sensor harness multi-plug

Remedy:
Check and clean the crankshaft position sensor harness multi-plug contacts. Rectify the engine coolant leak from the thermostat housing if found. Take a note of the engine coolant level and monitor it for changes, showing a leak is indeed occurring.

Oct 24, 2009 | 2005 Peugeot 405

1 Answer

WHICH IS MY # 4 PISTON ON MY 06 F150 TRITON 5.4? Also my motor clicks when I get past 3000 RPM's and I lose power. Any help please???


The # 4 piston is on the passenger side last one to the firewall. Your getting a misfire past 3000 RPM and the engine is detecting the knock and is powering down so you wont hurt the engine any more then it is. If there is an Auto Zone around your area, have them scan the truck for any DTC codes free of charge. This should help us address the issues so we can get your F150 running 100% again soon. Good luck and keep me posted. 

Sep 02, 2009 | 2006 Ford F-150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...