Question about Chevrolet Monte Carlo
Torque specs for front & rear wheel bearings
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There isn't a torque spec since those bearing are pre-loaded. You place the unit on a good known vic and get a breaker bar and you might even have to put an extention on that and you begin to tighten unitil you fell the bearing start to load...a little extra short turn wouldn't hurt at that point.
Posted on Oct 05, 2009
To adjust wheel bearing torque. Tighten the nut fully until the wheel wont turn then unscrew slightly until the wheel turns freely. Replace the locking plate and its set.
Posted on Nov 17, 2009
i read your report. It 155 to 210 foot lbs. I recommend start off your lowest settings. I wouldn't any higher then 195 foot lbs. hope this info helps you.TY you for writing to fix ya.
Best Regards Richard
Posted on Dec 03, 2009
Tips for a great answer:
Aug 01, 2014 | 2003 Chevrolet Silverado 1500
Aug 27, 2013 | 2004 GMC Envoy
Dec 03, 2009 | 2003 Chevrolet Silverado 1500
Oct 11, 2009 | 2002 Ford Mustang
Oct 05, 2009 | 2003 Dodge Dakota Club Cab
May 07, 2009 | 1977 Chevrolet Silverado 2500
Apr 24, 2009 | 2003 Chevrolet Silverado 1500
Jan 14, 2009 | 2002 GMC Envoy
1,518 people viewed this question
Usually answered in minutes!