Question about Cars & Trucks

Open Question

07 TK BARINA NOT STARTING. NO COMMUNICATION WITH ECU. NO CHECK ENGINE LIGHT

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: '07 Tahoe; check engine light on steady. Just came

Have a dealer or garage check your Oxygen (O2) sensor. As a quick fix, try disconnecting and reconnecting your car battery. Sometimes this will reset the check engine light.Good Luck!

Posted on Aug 01, 2009

  • 1 Answer

SOURCE: Check engine light is on and ECU blings 12 times.

you use the button that resets your trip odometer to reset the maintenance light.

with the key in the ignition but not turned on, hold the trip reset button in with one hand. then, while holding the button in, turn the ignition key to the ON position so that the lights on the dash come on.

continue to hold the reset button in and watch the maintenance light. it will take about 15 seconds for the light to go out

when the light goes out, turn the ignition key OFF and then release the trip reset button.

your light will be reset and come on in about another 5000 miles to remind you of the next service

hope that helps

Posted on Sep 10, 2009

  • 225 Answers

SOURCE: Audi a4 ABS light on

ensure the ecu connection is good the plug for those sometimes need a good amount of pressure to put on abs light i would check the sensors next to your brake caliper to ensure its not broken or disconnect it or if you dont feel like checking it buy new ones and replace them

Posted on Nov 03, 2009

  • 118 Answers

SOURCE: my grand cherokee 1994 engine not starting no

I assume your speaking of a automomtive scanner when you mentioned no communication. Check the fuse for you PCM, its thats good your cars computer or PCM may have failed.

Posted on Apr 21, 2010

no_signal_sw
  • 273 Answers

SOURCE: 2006 TK Holden Barina Manual

Make sure that you are getting a clean, blue, spark. Not an orange spark. And also it could be off time.

Posted on May 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Chevy Lumina 3.1. How can I tell if the computer has failed?


Patrick: According to ECU Doctors.com: "

Here are the most common symptoms of a bad ECU:

  1. Check Engine Light stays on after resetting
  2. Car was jump started on reverse polarity
  3. Engine turning off for no reason
  4. Water Damage or Fire Damage on the ECU
  5. Apparent loss of spark
  6. Apparent loss of injection pulse or fuel pump
  7. If your alternator overcharged the battery
  8. Intermittent starting problems
  9. Overheating ECU
  10. ECU has Broken Pins
  11. Loss of communication between the ECU and the Scanner
  12. A control module memory checksum error"
  13. ----------------

There is a really good article all about crankshaft positioning sensors: http://www.doityourself.com/stry/warning-signs-of-a-bad-crankshaft-position-sensor
I hope that helps you out!

May 11, 2015 | Chevrolet Chevy Cars & Trucks

1 Answer

Holden barina tk 2007 engine won't start. ?


run the fault codes
check that the cam shaft is turning ( broken timing belt)
check immobiliser for correct operation Check fob battery condition.

Feb 22, 2015 | Holden Cars & Trucks

1 Answer

Holden barina manual


If all else fails, test with a test light or a multimeter set to VDC.

Aug 10, 2014 | Holden Barina Cars & Trucks

1 Answer

Holden barina problems


Hi There,
I have a Holden Barina year 2007 and There is problem of ABS.I have found some issues with the TK Barina. I was driving the other day when the ABS light came on. When coming to a stand still I hear a grauncing noise and sometimes an electrical tick when the brakes engage.Now the noise coming in every brakes, is this car is Re call or can i fix this problem , please help i am very stress, because many mechanics cant find the code in their scaners.Thanks in Advance.Tarlo or Please advise e-mail tarlochan-singh@hotmail.com

Jan 05, 2014 | Cars & Trucks

1 Answer

2006 Tk barina - won't start!!! :(


these had issues of not starting when cold and missfiring only when cold
this was due to valves sticking due to carbon build up
head of and get valve guides modified as per holden info (scrapper counter sunk guides)

May 28, 2013 | Holden Barina Cars & Trucks

2 Answers

2006 TK Holden Barina Manual 3 Door Hatch - Engine Will Turn Over, But Will Not Start, Plenty Of Fuel & Spark To Plugs


Make sure that you are getting a clean, blue, spark. Not an orange spark. And also it could be off time.

May 17, 2011 | Daewoo Lanos Cars & Trucks

1 Answer

Check Engine Light CODE 2716 Toyota Corrolla 05


You have a bad engine ECU just bring your car to your local toyota dealer and and they will replaced it for free if your vehicle has less than 80,000 miles.

See Toyota TSB TC 015-07
TC015-07
TC015-07

Oct 02, 2009 | 2005 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...