Question about Jeep Cars & Trucks

Open Question

Where is body control module on a 1996 jeep grand cherokee?

Body control module on a 1996 jeep grand cherokee

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 20 Answers

SOURCE: 2001 Jeep Grand Cherokee which fuse controls heated seats?

Fuse # 20, located in the Junction Block (interior, drivers side). This is a ten amp fuse.

CLICK_HERE

Read the information at the above site. The TSB (technical service bulletin) may be of interest to you.

Posted on Nov 20, 2008

Ad
motor1258
  • 6674 Answers

SOURCE: heated seat 1996 jeep grand cherokee

C1 & C2 in your panel are most likely one of the culprits, if no power at heater at seat. Sounds like testing for power at seat switch is easier to do than get at these circuit breakers in the panel. If you have power at switch at seat, then it's not the fuse/circuit breaker. Good reading at this link for you.


http://www.wjjeeps.com/seats/seats.htm#HEATED

Posted on Dec 29, 2008

whispers76
  • 55 Answers

SOURCE: serpintine belt

This link will take you to a picture of the diagram. If the link doesn't work contact me and I can email you the picture directly.

http://autorepair.about.com/library/illustrations/bl506a-lib.htm

Posted on Jan 10, 2009

Mikey108
  • 475 Answers

SOURCE: 2002 Jeep Grand Cherokee Lardo misfiring

You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.

Posted on Feb 24, 2009

  • 154 Answers

SOURCE: LOCATION OF LIGHTER FUSE FOR 1996 JEEP GRAND

If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?

Posted on Apr 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep grand cherokee alarm system


The 1995 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Nov 25, 2011 | 1995 Jeep Grand Cherokee

1 Answer

1996 Jeep Cherokke 5.2 grand laredo, missing on acceleration found loose distributer need to set timing.


Base (initial) ignition timing is NOT adjustable. Do not attempt to adjust ignition timing by rotating the distributor. All ignition timing functions are controlled by the Powertrain Control Module.Adjusting the timing on a Jeep Grand Cherokee requires special tools and an understanding of engine mechanics. Changing the timing on a Jeep Grand Cherokee with distributor-less ignition requires professional reprogramming of the powertrain control module. This guide covers Jeep Grand Cherokee models with distributed ignition only. you can go to this site and it will explain it. www.ehow.com/how_4521340_adjust-timing-jeep have a good day !!

Jun 07, 2011 | Jeep Cherokee Cars & Trucks

2 Answers

1996 jeep grand cherokee- while driving all gauges stopped working and all dash light were flickering on and off. then all went back to normal but since then passenger side windows and door locks will not...


I would start by scanning the engine control module and the body control module and the antilock brake control module and the transmission control module and the airbag module to see if there are any fault codes that indicate a loss of power to the modules. It may tell me which circuit malfunctioned. If that does not give me a clue, I would then start to diagnose the window circuits by first checking for power at the master switch and move to the rest of the power window system from there.

As for fuses or where to start...I think you should probably read these articles before doing anything:

Where's The Fuse?

What Else Could Be Wrong?

May 08, 2011 | 1996 Jeep Grand Cherokee

2 Answers

How to disarm or reset an alarm system for a 1996 Jeep Cherokee?


Hope this helps:- Factory Disarm Purple/Yellow (-) Driver's Kick Panel Black Connector at ECM -slice into this wire, & wire it to ground, this disables the alarm.
Cavity/Fuse Diagram (1996 Grand Cherokee, passenger side kick plate to find, Owner's Manual pgs 205-206): 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Row 1: 1-6 (left to right) Row 2: 7-12 Row 3: 13-18 Row 4: 19-22
1996 Jeep Grand Cherokee Fuse Panel (Passenger Side kick panel) Reply

CAVITY FUSE DESCRIPTION 1 -10 amp (RED) Radio 2 -15 amp (Lt Blue) Cigarette Lighter 3 -10 amp (RED) Rear Washer Switch, Body Controller 4 -10 amp (RED) Airbag 5 -10 amp (RED) Lamp Out Module, Overdrive Switch, OBD II 6 -15 amp (Lt Blue) Vehicle Information Center/Graphic Display Module Park & Side Lamps, Overhead Console Lighted Visor, Automatic Dimming Mirror 7 -20 amp (Yellow) Body Amp, Cluster, Body Controller 8 -20 amp (Yellow) Rear Wiper Motor, Flipper Glass Solenoid, Cargo Lamp, Trailer Tow 9 -15 amp (Lt Blue) Brake Switch 10- 10 amp (RED) Rear Window Defroster 11 -10 amp (RED) ABS Module 12 -10 amp (RED) Heater-Ventilation-A/C Control & Recirculation Motor 13 -15 amp (Lt Blue) Hazard Switch, Turn Signal Switch 14 -15 amp (Lt Blue) Spare 15 -15 amp (Lt Blue) Spare 16 -10 amp (RED) Right & Left Courtesy Lamp, Glove Box Lamp, Halo Lamp Cargo Lamp, Underhood Lamp, Dome/Read Lamp Right & Left Visor, Automatic Dimming Mirror 17 -15 amp (Lt Blue) Radio Illumination, Tail Lamp, Graphic Display Module, Park & Side Lamps, Headlamp Switch, Body Controller 18 -20 amp (Yellow) Spare 19 -15 amp (Lt Blue) Passing Light 20 -15 amp (Lt Blue) Radio, Heater-Ventilation-A/C, Vehicle Information Center 21 -15 amp (Lt Blue) Power Outlet 22 -10 amp (Blue) Airbag Module -------------------------------------------------------------------------------------
1996 Jeep Grand Cherokee Alarm, Remote Starter, Keyless Entry Wiring Information Constant 12V+ Pink/Black Ignition Switch Harness Starter Yellow Ignition Switch Harness Ignition Dark Blue/Gray Ignition Switch Harness Ignition 2 Red/Black Ignition Switch Harness (for AC) Accessory Black/Orange Ignition Switch Harness Tach Gray/White Coil Brake Switch White/Tan Brake Switch Trunk Pin n/a Works with Dome Light Parking Lights Blue/Red (+) Left of Steering Column or Light Switch Head Lamp Tan/Black Light Switch Factory Disarm Purple/Yellow (-) Driver's Kick Panel Black Connector at ECM -slice into this wire, & wire it to ground, this disables the alarm. Door Trigger Yellow (-) Driver's Kick Panel see notes Door Lock 5/Wire in Driver's Inside Driver's Door Orange/Purple Lock Pink/Black Unlock Door Unlock and Passenger's Doors Inside Passenger's Door Black/White L Pink/Black Unlock Horn Wire Gray/Orange (-) Steering Column Windows Up LF=Light Blue, RF=Brown/White, LR=Blue/White, RR=Gray/Black Doors Windows Down LF=White, RF=Purple/White, LR=Red/Black, RR=Green/White
• Cruise Control Information • Stereo Information • View all Jeep Vehicles

Dec 18, 2010 | 1996 Jeep Grand Cherokee

1 Answer

1999 Grand Cherokee Limited Jeep anti-theft system had shut all electronics down and engine will not start. what can I do to reset the system....


The 1996 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE.

Also, remember that here can find the Jeep Grand Cherokee Service & Repair Manual.
Hope help with this.

May 03, 2010 | 1999 Jeep Grand Cherokee

1 Answer

Where is the computer on a 1996 jeep grand cherokee laredo


Powertrain Control Module: Locations
The Powertrain Control Module (PCM) is located in the right-rear side of the engine compartment.


ad195d1.jpg

Oct 01, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Alarm sets itself with doors unlocked


you can`t it is part of the body control module

Mar 16, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...