Question about 1999 BMW 323 Series

1 Answer

Code wait bmw 323i conv. how do i get the code i have my vin# and s.n.#

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 117 Answers

Hello There.

There are many websites that offer an unlocking service for a few £/$ . here is one that I found>

http://www.unlockmycarradio.info/?gclid=CKGGt9PSkZkCFYh_3godalAGYg

Hope this helps.

If my answer has helped you, please rayte me on Fixya.

Many Thanks

ILikeBMW

Posted on Mar 07, 2009

6 Suggested Answers

  • 38 Answers

SOURCE: 1997 bmw 328i conv.

If you're talking about the Anti-Theft Security code for your radio, I'm fairly sure that only a BMW Dealership would be able to retrieve and reset the radio.

You could also try disconnecting the battery terminals for 10-20 minutes, and see if it resets.

Posted on May 16, 2008

moparownr
  • 667 Answers

SOURCE: 1999 bmw 323i dashboard reads S and car wont turn over

check for power on the small wire on the starter with the key in the start position, if you have power, replace the starter

Posted on Mar 23, 2009

alicantecoli
  • 21949 Answers

SOURCE: 2000 bmw 323i service engine soon light code =

you can buy a cheap scanner that will put this light out,i have a mechanic working for me that stands on the roof ,tweeks the radio and has one foot on the brake whilst turning on the lights and he puts out nearly every service light you can think of but he wont show anyone least of all me,but if it its a 99 model iam sure you can put the light out by using a 12v electrical screwdriver with the light inside and a cable comes out the end with a clip .then going across the pins on the special BMW connector block it will go out with the resistance of the bulb across it ,but ??big but ?does it have an OBDII connector or the round BMW type because we dont have OBDII on pre 2005 cars here in spain .Now we do and guess what ??its all encrypted software used ...makes me a dinasaur

Posted on Aug 14, 2009

  • 31 Answers

SOURCE: flashing headlights in a 2000 bmw 323i

lose wire or lose ground wire

Posted on Aug 29, 2009

  • 54 Answers

SOURCE: BMW 323i Fan Belt

u find the tensional roller n remove the cap. inside it has the nut commonly 16mm. rotate the nut clockwise and u ll see the belt wold be untension.
hold the nut n remove the belt.tq

Posted on Mar 28, 2010

  • 81 Answers

SOURCE: Where is the oil filter located on a99 BMW 323I

top of the engine you will see a 36mm hex fitting, if you are changing the oil you must undo all the way first before drainnig oil as if not oil will not compleatly drain

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are all the definitions to OEM codes on 2000 BMW 323i


there is over 100 answers for the codes so it will ,be best if you get a workshop manual and get them all at once

Feb 13, 2016 | 2000 BMW 323i

1 Answer

Location of oil filter


It is located on the driver's side of the engine. To see what it looks like, go to REALOEM.com and enter the last seven digits of your VIN or month and year of production from the car's name plate.
Select Main Group 11 Engine, Subgroup 11 30 Lubrication System, then select diagram "E93 323i Lubricat.syst.-oil filter, heat exchanger"
For example a 2009 323i uses part numbers
11427548032 for aluminum housing, 11427525334 for the oil filter cover (usually plastic) which uses a special wrench for removal, and 11427566327 for the cartridge type oil filter and o-rings.

Aug 11, 2013 | 1999 BMW 323 Series

1 Answer

00 bmw 323i chekc engine light is on and it's giving me codes for all 4 O2 sensors i replaced them and light comes on with the same codes when you turn off the car and turn it back on. possible fu


You need to inspect the spark plugs to see i the engine is running lean or rich. I have seen cars set codes or the O2 sensors instead o setting rich/ lean codes.

Dec 12, 2012 | 1999 BMW 323 Series

1 Answer

How do i repair code P1509 on my 2000 BMW 323i


No repair for any fault code is cut and dry you must do the diagnostics listed in the factory service manual to pin down the cause. Here are some possibilities.
P1509 - BMWTypePowertrain - Manufacturer Controlled DTC - Manufacturer ControlledDescriptionIdle speed control (ISC) actuator - malfunction
CauseWiring, ISC actuator

Oct 04, 2012 | 2000 BMW 323i

1 Answer

Ownes manual for 1998 bmw 318i


BMW Owners manual. 1998 BMW 318i 4DR E36 BMW 318i CONV E36 BMW 318is 2DR E36 BMW 323i 4DR E36 BMW 323i CONV E36 BMW 323is 2DR E36 ... data.bmrparts.com/bmwparts/1610.html
have just checked this site out and the have a manual for yr bmw - hope this will help-

Feb 13, 2012 | Cars & Trucks

1 Answer

I had the battery in my 1999 bmw 323i changed. I entered the wrong radio code, and it says"code wait" since yesterday. How do I rest this to enter the code again?


ive had the same problem on my 1998 Bmw 323i when i took my battery cable off what you have to do is leave your key in the ignition position 1 so the radio is on and says code wait. you have to leave the key in the ignition in that position for about 30- 1 hour long then it should reset back to where you enter your radio code. you only have about 3 trys to get the code right then it will say code wait again. you need to find out what your radio code is. my radio code was 46661 but we could have different radios. you can either bring your car to the dealer or just take out your radio and get the serieal number off of it which is what i did and i typed bmw radio code in online hope this helps !!

Mar 20, 2011 | 1999 BMW Z3

1 Answer

I recently purchased a e36 1997 bmw 323i.i am trying to find out where exactly is the chassis and engine number under the hood of the vehicle.


The VIN number is the same as the chassis number of your car. The VIN number is found on the left driver's door jam B pillar. It is also found under the hood (bonnet) on the right side usually on the firewall. The engine number is found on the right side of the engine , forward, close to the timing chain (belt), down at the junction of the engine block and oil pan, is this information helped you? please vote me and give me a comment.

Oct 15, 2010 | 1997 BMW 3 Series

1 Answer

My top won't fully come down 1999 323i conv.


there is sensors in your boot and on under the flap that hides the roof if one of them is faulty you come stuck. the sensors are there so you dont try and drop the roof why the boot is open

May 14, 2009 | 1998 BMW 3 Series

1 Answer

BMW E90 323I, ABS resetting.


hey hassa, if you swapped an ABS control unit from another vehicle, it needs to be coded to your vehicle. If your vehicle does not recognize the replacement vin, it will set a fault. also, make sure to have the ABS sensors calibrated after the control unit is coded. most dealers charge about 1hr labor to perform coding and sensor calibration.

Apr 02, 2009 | 2001 BMW Z3

Not finding what you are looking for?
1999 BMW 323 Series Logo

Related Topics:

196 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Fred Sops

Level 2 Expert

271 Answers

Al Clark

Level 2 Expert

290 Answers

Doberman

Level 2 Expert

246 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...