Question about 1999 Lexus RX 300
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Check out the Homelink Website. I found instructions for my wife's GS300 there. I haven't tried it yet, so I'm not 100% sure this will work.
Posted on Jul 13, 2008
Open the deck lid (trunk) to better access the lights. There will be 2 of them. Recommend replacing both at the same time even if only one has failed. Generally sold in pairs anyway.
Directly above the license plate will be mounted 2 clear light covers. On the right side of each light cover you can see a small plastic rivet. Push in the center 1/4 inch with a small screwdriver then you will be able to pry out and remove the rivet without damaging it. This will save you from buying replacement plastic rivets for re-installation. Remove the light cover with the bulb harness attached.
The bulb harness requires a short turn counter clockwise to remove it from the light cover and the new bulbs snap into the harness. No twisting or screwing. Replace the bulb harness the same way and fasten the light cover back into place using the plastic rivet.
Saves time because both bulbs and light covers are exactly the same style, there is no left or right. Cheers!
Posted on May 11, 2009
P1130 Air/Fuel Ratio Sensor Circuit Range/Performance Malfunction (Bank 1 Sensor 1)
This sensor is the hardest to get at. It is between the cat and the cylinder block on the bank of cylinders closest to the firewall. Not much wiggle room back there.
Sensor will run you about $225 from Toyota, $275 from Lexus, but you may be able to get a Denso sensor on line.
Good luck and hope this helps. keep me posted.
Posted on Jun 26, 2009
This is a lenghty job!! You would have to remove the plastic engine cover to locate the plugs (cover that has the lexus symbol). There are 3 coils(black squarish units) on the front head and another three in the rear head. You must remove these to access the sprakplugs. Front is very easy!! The rear is difficult, you would have to remove the intake(special tools are needed) to access the rear coils and sparkplugs. hopefully this helps
Posted on Jul 24, 2009
Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.
Posted on Aug 18, 2009
Tips for a great answer:
Aug 13, 2012 | 2000 Toyota Camry
Apr 12, 2012 | 2007 Audi A4 Convertible
Mar 07, 2011 | 2000 Volkswagen Beetle
Feb 28, 2011 | 2000 Lexus RX 300
Sep 27, 2010 | 2000 Chevrolet Suburban
Jun 25, 2010 | 2000 Lexus RX 300
Sep 12, 2009 | 2000 Lexus RX 300
Jul 25, 2009 | 2000 Lexus RX 300
Dec 24, 2008 | 1998 Lexus Gs 300
95 people viewed this question
Usually answered in minutes!