Question about 1994 Buick LeSabre

Open Question

1994 buick lesabre coolant fan won't come on

Used jumper wire fans work,installed temp.sensor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 73 Answers

SOURCE: 1995 Buick LeSabre cooling fans not working

check the fan relay swich or the fuse

Posted on Mar 13, 2009

sodeep
  • 3267 Answers

SOURCE: 94 buick roadmaster over heating changed waterpump

I feel there is a sort somewhere in the fan circuitry, check its fuse unit. Also ensure proper level of engine oil is present in the engine. Actually your car might be overheating because the respective fans are not powering on at the correct time, but you mentioned that these fans are in working condition so it has to on something in this circuit that is preventing completion of this circuit by their respective sensors which you have recently changed...............sodeep

Posted on May 04, 2009

alicantecoli
  • 22156 Answers

SOURCE: Where is the heater fan blower resistor on a 1994

its built into the the blower motor body

Posted on Oct 20, 2009

Testimonial: "Thank you very much. It will save a lot of money on a repair if I can do it myself. God bless you."

  • 306 Answers

SOURCE: 89 buick lesabre electric cooling fans

You are off to a good start by testing the fans. Get a repair manual from your nearest autoparts store. I find them invaluable. Most temperature sensors can be tested with an Ohm meter. Or short the two wires together to trigger fans. If it has only one wire then ground it to the frame/body (negative side of battery). If none of that works (with ignition on / car off) then relay is bad. Also turning on the A/C should make the fans come on. Car does not have to be running, key in on position. This would eliminate bad relays or not.

Posted on Mar 04, 2010

  • 13 Answers

SOURCE: where is the coolant temp

Hi there,

you have two ECTs on this car on the right side of the block and other close to the water pump. I would suggest replacing both of them while you at it. Good luck

Posted on Dec 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 buick century over heats unless ac is running. I changed antifreeze, thermostat, temperature sensor, coolant level sensor, and all hoses. Also coolant light won't come off even though its full. I...


Sounds like the computer is not powering the fan relay when the engine reaches 220 degrees. You might want to jumper the temp sensor to see it it will trigger the relay. You may need a scanner to monitor the data signal from the temp sensor.
As for the brake warning light, it can be from low brake fluid or the parking brake not being released. Either sensor or switch could have failed.

Jun 29, 2013 | Cars & Trucks

1 Answer

Car won't start after starting it with coolant temp sensor disconnected


Try a boost first before taking things apart,sound like low voltage.
Now about the fans.Sometimes it's easier (if the fans will work with voltage applied) just to install a relay and fire it off the switched power wire at the A/C compressor.Use this relay supply to voltage to the fans when the compressor runs.Want fans when not using A/C?Run a "in rad hose" temp switch and run that wire to the same relay to run fans when temp rises.Think after market hot rod stuff and keep it easy and simple,

Apr 10, 2017 | Cars & Trucks

1 Answer

Wiring for 88 cadi fan


Well I'm sure there are kits to wire up electric fans on cars that are not designed for one.
You would need a relay and something to turn the relay on. A coolant sensor won't do the trick, the sensor is what tells the computer the engine temp, and the computer decides when to ground the fan relay.
You would need a temp switch that is designed to close at say 220 degrees to ground or power the fan relay.
The fan motor would have ground and power wires.

Sep 30, 2012 | 1988 Cadillac Sedan DeVille

2 Answers

1994 Chevy Cavalier fan won't come on


Sounds like the sensor is not reading the coolant temp, or the computer is not accepting the data from the sensor.
Its possible you have air in the cooling system, or you have a problem with the computer.

Aug 28, 2012 | 1994 Chevrolet Cavalier

1 Answer

1990 Buick LaSabre, limited V-6 3.8 overheating, replaced fan, & thermostat & cooling temp sensor. runs rich and fan won't come on?


on that motor they are prone to blowen head gaskets you need to do pressure check of the cooling system

Jul 26, 2012 | 2000 Buick LeSabre

1 Answer

Cooling fans on 94 buick lesabre are coming on at about 100 degrees engine temp when A/C is not running.


Yes, it could. But there might be another little module or device at play here, tricking the relay for the fan to come on (wrong temp). Certainly the ECT sensor, if you experience other driveability symptoms or issues especially in that time between the fans coming on and the engine reaching normal operating temperature.
Well, maybe this is a little help on your way to solve it. A wiring diagram of the circuit is another option besides the engine CTS.. Good luck.

Dec 01, 2011 | 1994 Buick LeSabre

1 Answer

Sometimes stalls or surges when hot, runs hot


Clean the temperature sensor wire connector.
Replace the temp sensor near the thermostat hosing.

Check the condition of the sensor wire cut(s) or short onto the engine block.

Monitor the fan operation with the hood open during warm up (0-15 minutes.) It should ran after the engine coolant temp get above 195F +.

Test fan relay.

Feb 10, 2010 | 1993 Buick LeSabre

1 Answer

Niether fan on my 95 lesabre won't turn on


usually always hot. the fans sometimes run for a while even after leaving the car. look for voltage. if there then it/s the heat sensor or it's wiring. if not its the wire,fuse,relay or fusible link as i am not familar with your model

Jul 28, 2009 | 1993 Buick LeSabre

1 Answer

2005 buick allure temp guage shows 0 and both cooling fans run


coolant temp sensor defective. look through manual for location of this sensor.

Jan 05, 2009 | 2003 Buick LeSabre

Not finding what you are looking for?
1994 Buick LeSabre Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8201 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...