My bcm fuse blows no matter what amp I put in it.
SOURCE: 2006 chvy impala when idling dont blow hot air
1
Inspect
Cooling System Mix
Coolant level low or flow is restricted.
2
Inspect
Thermostat
Thermostat stuck closed
3
Inspect
Heater Control Valve
Leaking or defective heater control valve.
here something to help u
Here to help Shaun
SOURCE: My Impala lt 2006 power steering hose is blowing
is it the pressure hose or the return hose?
if its the pressure hose and your power steering is working fine before it blows then the releaf valve is bad in the pump and you would need too replace the pump also
if its the return hose then they are either not clamping it or its not strong enough too hold the pressure e.g. wrong one for it!!!
SOURCE: chevy silverado 2006 lights "service air bag"
First of all you need to get this problem fixed ASAP. While the airbag light is illuminated, your SDM (Sensing and Diagnostic Module aka: the brain of your airbag system) shuts of power to the airbags. In which, if you are in an accident your airbags will not deploy while this light is illuminated. You need to take your vehicle to a GM dealership. A Tech 2 scantool is needed to retrieve the code from the SDM. Hopefully it won't be a costly repair, but is something that defineatly needs to be corrected soon. Good luck and hope all works well.
Testimonial: "very fast and helpful, thanks"
SOURCE: Problem with 2006 Chevrolet Impala --Windshield washer fluid
Sounds like the fuse blew out again. Look at the wiring that goes to the washer fluid pump and check for any place where it might have rubbed against something causing it to short out. Fix this 'short' before you replace the fuse again or you will continue to have problems.
SOURCE: i need a serpentine belt assembly guide or diagram for a 2006 3.5 liter v6 chevrolet impala
Diagram 9-5 on this page:
http://www.daycoproducts.com/daycoweb.nsf/Serp%20Rout%20Guide%20Illus.pdf
659 views
Usually answered in minutes!
×