Question about Dodge Caravan
Bottom front left side of transmission just above pan gasket. Just inside and ahead of the left wheel. A wired connector attaches to it. You don't need to jack the car up to get to it but it helps to get a bit more room. Disconnect connector. With appropriate box end wrench OR deep socket, remove switch. Replace switch. Haynes says 24 ft-lb torque. You should probably have a drip pan in case some fluid leaks out. With the front jacked up some, there was no leakage. The connector fit is tight. You can rotate it C and CCW a tiny bit safely.
Posted on Feb 10, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
have you recently put on new plug wires code 12 is battery disconnected at one time code 55 is code check is done code 43 is interference from plug wires on electrical circuits from bleeding through .
Posted on Feb 28, 2009
If your shifting lever cable is a little stretched the lights will come on, but go out again when in reverse. Shift car while looking out the back window or have a friend help by looking from behind. If The lights come on but go back out once in reverse, the cable needs to be tighted. The adjustment is usually under the dash, or on top of the transmisson on front wheel drive models. If the lights do not come on at all, then it is electrical.
Posted on Jun 24, 2009
You should have two plastic nuts on each headlamp assembly, one will be for your high beams and one will be for your low beams.
The nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail (might see holes in your rail above the headlamp unit where the screws are hidden)
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
Posted on Sep 21, 2009
Tips for a great answer:
Oct 13, 2016 | 1997 Dodge Grand Caravan
May 18, 2015 | Dodge Caravan Cars & Trucks
Sep 18, 2011 | 2000 Dodge Caravan
Oct 03, 2010 | 1999 Dodge Caravan
Jun 23, 2009 | Dodge Caravan Cars & Trucks
Mar 03, 2009 | 2004 Dodge Caravan
Feb 28, 2009 | 1996 Dodge Caravan
Jan 11, 2009 | 1997 Dodge Caravan
Dec 04, 2008 | 1996 Dodge Caravan
171 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: