Question about 2006 Chevrolet Impala

Open Question

Is their a recalls on any thing on the 2006 chevy impalas?

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75797 Answers

SOURCE: How do I program my key for my 2006 Chevy Impala?

Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.
Originate New Master Key (PK3 or PK3+ key)

1. Insert new key into ignition cylinder and turn it to the ON (RUN) position.
The security light on the dash will illuminate and stay on for ten minutes.
2. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back to the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
3. When the security light goes out, you have one minute to start the next
step. Turn the ignition cylinder to OFF and then back on the ON (RUN)
position. The security light on the dash will illuminate and stay on for ten
more minutes.
4. After the security light has gone off the third time, the key has been programmed
into the vehicle’s computer and will operate the car. It has replaced ALL the
previous electronic key codes and is the ONLY key programmed into the
vehicle’s computer.

Add Duplicate Key (PK3 or PK3+ key)

1. Insert an existing key into the ignition cylinder.
2. Turn the ignition cylinder to ON (RUN) and back to OFF.
3. Remove the existing key and, within fifteen seconds, insert the new key
and turn it to ON (RUN).
4. The security light will light up for two seconds to indicate success in programming
the key into the vehicle.

Posted on May 20, 2009

motor1258
  • 6674 Answers

SOURCE: 2006 Chevy Impala reduced engine power

best bet is to stop in at a Pep Boys, Autozone, or similar big autoparts seller, and ask for free trouble code scan, which should pinpoint area causing problem. If not obvious by codes, what is necessary to repair the problem code, get back to us with those codes and we will be glad to assist you further. Better this way, takes away the guess work, and saves you money, as well as getting it right the first time.

Posted on Dec 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Directions on changing out the TCM in an chevy impala 2006


Try watching the educational videos on YouTube.com :
chevy impala 2006 , replace the TCM

I hope this helps you out!

Mar 31, 2017 | 2006 Chevrolet Impala

1 Answer

I have a 2006 Impala the engine is surging at idle and when I driving


Check the vacuum hoses for a leak.

2006 Chevy Impala LS 3.5L Surge Under Load - YouTube

? 3:09
www.youtube.com/watch?v=sD-swFhMORM
Jan 22, 2013 - Uploaded by Gary Castle, Jr
Surge while driving. ... 2006 Chevy Impala LS 3.5L Surge Under Load ... How To Fix Or Prevent Stalling, Surging Or Rough Idle, Cleaning ...

Oct 02, 2015 | Cars & Trucks

1 Answer

2002 chevy impala ls are the any recalls several problems only 100,000 miles on it


Put in your search engine , Recalls on a 2002 Chevy Impala LS it will bring up quite a few good sites to pick from. They were more recalls then I could put down here.

Oct 31, 2013 | 2002 Chevrolet Impala

2 Answers

2006 chevy impala temp gauge is reading cold but the car says the engine is hot turn off the A/C


After much research the only answer I found was to change the Heat Sensor. This is the problem we just had last week.

Dec 29, 2011 | 2006 Chevrolet Impala

1 Answer

2006 chevy impala rack and pinion changed


IF you had the rack replaced and did not align it is possible the wheels are so far out that tires are scrubbing road causing noise. other thing could be a wheel bearing i would recommend getting alignment and drive

Oct 28, 2011 | 2006 Chevrolet Impala

1 Answer

2006 Chevy Impala driver side visor will not stay up. What do I do???? Help.


You are not alone! I have the same thing with my '06 Impala. I may have to replace it since there is not a visible mechanism for adjusting the tension.

Sep 18, 2010 | 2006 Chevrolet Impala

1 Answer

2001 chevrolet impala hard to turn steering wheel


This is a common problem with the 2001 Impala. The intermediate shaft in the steering needs to be lubricated or replaced. There is also a recall on some Impala's. http://www-odi.nhtsa.dot.gov/recalls/results.cfm I suggest you take it to a trusted Chevy dealer and have this repaired.

Jul 15, 2010 | 2001 Chevrolet Impala

Not finding what you are looking for?
2006 Chevrolet Impala Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...