Question about 2007 Chrysler Sebring Sedan

Open Question

Red light flashes (under speedometer)

I just bought a 2007 Sebring, the entire time my car is on there is a red light that flashes (it is a circle under the speedometer) I took it back to my salesman he said it is for the anti theft why would it be flashing when the car is on and driving?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Anti-theft system seems to have been activated?

Some months ago I began starting the engine of my 2001 Chrysler 300M but turned it of before it really started "was sloppy with the key". The anti-theft system went on for some unknown reason. I disarmed it by disconnecting one of the battery connections under the hood with a wrench. I connected it again, the anti-theft system was off but the battery was dead. Battery was OK after recharging, I have had no trouble since then.

Posted on Apr 14, 2009

  • 46 Answers

SOURCE: 2001 sebring will turn over but will not start

Most Chrysler cars do have an anti-theft system that can cut out the engine.

I would call the service department, with your VIN handy, and see if yours was equipped with one, and what you need to reset it.

If that isn't the problem, your EGR valve might be bad, or the sensor for it. I've seen a lot of cars where if either the valve itself, or the sensor are malfunctioning, the car won't run properly.

I would also check your MAF and IAC, as those can cause the car to not run.

If you can, get an OBDII code scanner, and pull the codes from your car, they might give you a more specific place to look. (Most parts stores will let you take one home, you put a deposit down, and get it back when you bringthe scanner back to them)

Posted on Dec 04, 2008

  • 3 Answers

SOURCE: My 2000 Chrysler Sebring Convertible's fuel gauge

replace the sending unit

Posted on Feb 22, 2010

  • 12 Answers

SOURCE: I took my 2002 chrysler sebring in for a tune-up

The 1698 code means either that there is no digital data communication from the the transmission controller OR from the body controller that is being received at the powertrain control module. An analyzer that read "hex" codes would distinguish which, the former being a 60 the latter a 61 hex code.

Posted on Jul 19, 2010

  • 149 Answers

SOURCE: Need to reset the anti-theft system on 2001

turn the key on leave it on for 10 to 20 min.s after yo wait then turn key off and then try to start the car this shoud work. it will reboot the computer.

Posted on Sep 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The speedometers flutter up and down when car is on chrysler sebring 1997


there are two sets of fuses in the sebring.check both the under-hood fuses and also make sure to check the fuse located on the left side of the dashboard.

Apr 05, 2014 | 1997 Chrysler Sebring

1 Answer

2004 chrysler sebring sedan won't start


Hi Angela, when you try starting now, does the motor actually turn over, your extreme temps may have an effect also because so many of your motors in the US over the last month have become frozen internally and when tried to start have broken things that have never been a problem before, we can do this 1 at a time, cheaper and more reliable

Jan 13, 2014 | 2007 Chrysler Sebring Sedan

1 Answer

Interior lights went out


Check fuses, and then the bulb inside dash.

Aug 08, 2012 | 2007 Chrysler Sebring Sedan

1 Answer

Cannot disconnect electrical cable from brake light switch on 2007 Sebring. Moved the red latch as far as it will go, but connector will not release from switch.


those can be finicky when they get dirt in them, the best way to disconnect them is to remove the red clip entirely and then using a small screw driver insert it into the connecter and push the locking part in an upward direction (ie. away from the connector) and pull at the same time.

Zim.

Apr 24, 2011 | 2007 Chrysler Sebring Sedan

1 Answer

Sebring 2007 problems with the Electronic Thottle Control (ETC) Light flashes at dash panel car doesn't accelerates and goes to 20mph.


Had the same problem. Would be driving down the road and the red lightning bolt light would go on. Unable to accelerate and car started jerking. Would have to pull over and turn car off then turn back on to buy some more time. Needed to replace the Throttle Position Sensor, but you can't get that part by itself. You have to replace the Throttle Body.

Dec 22, 2010 | 2007 Chrysler Sebring Sedan

Not finding what you are looking for?
2007 Chrysler Sebring Sedan Logo

Related Topics:

832 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...