Question about 2007 Suzuki Forenza Sedan

1 Answer

What's your problmy turn signal light and hazard lights went out on my 2007 suzuki forenza fuses are still good em?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Suzuki Master
  • 75,051 Answers

The Hazards and flashers both work off the same "combination relay, it is defective, replace it.

Posted on Feb 08, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

keeperoffire
  • 106 Answers

SOURCE: 2006 suzuki forenza low beam problem

You should check the dimmer switch.It is the switch that is totally in charge of high and low headlight functions.

Posted on Oct 06, 2009

roniecon
  • 6826 Answers

SOURCE: AC has freon (134a) pressure is good. Compressor

Have a code reader or scanner put on the car to erase all codes,this should reset the ac system circuit.Also check the low side clutch cycle switch,it may be the problem.

Posted on May 01, 2010

Testimonial: "Tried those but thanks for the fast responce"

SOURCE: my thermostat housing on 2007

Yes you must change it or have seals checked.

Posted on Dec 16, 2008

cj2176
  • 520 Answers

SOURCE: would you say suzuki forenza 06 is a good car to buy?

They have been doing well and there problems are fewer than most. Sounds like you have a pretty good car. Have those trouble codes checked and repaired though so it does'nt cause problems down the road. Good luck.

Posted on Jun 22, 2009

SOURCE: how much isa transmission range sensor for a 2007

Make sure to check for an adjustment,if there is one,before replacing it.

Posted on Mar 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My turn signal fuse blowed got new one now they dont work why


canada or USA, (diffr. laws, different wiring, even DRL up there)
station wagon or NOT?
THE TURNS FUSE BLEW OUT. 2nd time, 3rd,,,?????
that means the circuit is overloaded or shorted.! (prevents fire)
but did it blow a 2nd time, why not say so???

all 4 lamps dead. or stuck on, or flash odd. or what? dim?
does the cluster lamp flash, , in blink or emerg. mode?
wont work , means what, (dead or stuck on or dim)?????
do emergency flashers work? ,dead, stuck on what?
does car drive perfect day or night?
are any other things on car dead, of odd acting?
we see all this , 1st 5 min in a shop, zero here.
ive answered Forenza blinks here, many times.
ever search?

ill now answer by guessing USA non stationwagon and no DRL.
dash box fuse 4 kills blinkers

EF1 (engine fuse) 1 good?
dash fuse 14 and EF1 can kills emerg. flasher

so of Emergancy flash lamps blows fuse 14,(smaller of 2)
then the blinkers are in fact shorted.
does it?
if yes, then find out which side blows the fuse 3.
turns left blow or turns right blows.
so if say turns right blows, F4 fuse.
if true ?remove all bulbs front rear right bulbs.
does the fuse hold now,(means not blown)
then buy new lamps there. problem solved
bulbs can in fact short.
not just blow open.
Tell the full story and all this gets easy.
For sure emergency flash,

26123255-vhg5j1pxaeih5p05yacvrs2p-1-0.jpg

Mar 09, 2016 | 2007 Suzuki Forenza Sedan

1 Answer

Why aren't hazard lights or brake lights working?


Brake lights /rear hazard lights not working - Ford Truck ...

www.ford-trucks.com > ... > 1967 - 1972 F-100 & Larger F-Series Trucks
Jul 9, 2010 - After checking the brake lights I tried the emergency flashers and found that they are working in the front but not in the back. I do have rear turn ... 1995 F350 Brake Lights / Turn Signals not working
Jul 9, 2012
Turn Signals and Brake Lights Do Not Work
Mar 10, 2012
Turn Signal, Brake Lights, & Rear Hazard not working
Aug 3, 2010
Rear Turn Signals, Hazards and Brake Lights not working....
Aug 29, 200

Sep 30, 2015 | Cars & Trucks

1 Answer

2004 Forenza. Why are there no signal lights or four ways?


turns and hazards dead.
check the fuses. first. always for ever and ever all electrics.

Jun 12, 2015 | Suzuki Cars & Trucks

1 Answer

Turn signal flasher location 2003 suzuki XL-7


the FSM book covers this.
as does alldata.com, (USA cars)
checked fuses yet?
turn/back fuse.
feeds the.:
turnback relay & answer back relay (module)
a digital switch in the lever (combo) it just sends ground logic
level to the module.
so sound to me to be
one light is shorted. (or trailer wire hacks) "visual inspections!,"
or the module is bad.
if both sides are bad, seems bad module to me,
if all lights blink fully bright on hazard the lights should be good.

the module is just under the steering wheel , under those
plastic covers, the books shows simple access. to the combo
my book dont show module location
i use a rubber hose to my ear to find any relay, clicks.
if you find hazard click , (assuming it does) then same place
is the turn sigs.
its not in the fuse box, cab , i looked.


hope that helps.

alldata.com
has it.

Feb 20, 2014 | Suzuki XL7 Cars & Trucks

1 Answer

Rear lights not working on 2002 suzuki grand vitara


In the underdash fuse/relay box, the 15A TAIL fuse feeds power to the coil of headlight relay 2. When the combination switch is set to TAIL, the relay closes and the outer tail lamps light. In the same underdash fuse/relay box, the 20A STOP fuse feeds power to the brake light switch. When the brake pedal is pressed, the inner brake lamps light. The underdash fuse/relay box also contains the 10A TURN BACK fuse which feeds power to the hazard switch and the turn signal relay. Relay output is fed to the combination switch and turn signal power is applied to the selected middle tail light. The fourth fuse in the underdash fuse/relay box is the 15A HAZARD fuse which feeds power to the hazard switch and turn signal relay. When the hazard switch is set, the turn lamps on both sides begin flashing.

Sep 18, 2012 | 2002 Suzuki Grand Vitara

1 Answer

I changed the fuse as the turn lights and hazard lights were not working but all other light including brake and interior worked. Now the hazard light stays on and I cannot turn it off. can you Help p


if your hazard lights stay on, you may have a problem with the hazard switch on your stearing collum. try moving it back & forth several times, eg. on, off, on, off always ending @ off & see if that works. they do get sticky @ times. your brake lights will work but your turn signals won't work properly with the hazard switch turned on. let me know if problem persists & will see if i can help you more. good luck.

Nov 24, 2011 | 1999 Saab 9-5

3 Answers

Tire pressure senors will not turn off in my 2007 suzuki forenza what could it be is their a way to reset them


There is a way to reset all computer memory on most cars. First disconnect the negative terminal on the battery and then the positive. Touch both together and hold the for approximately 30 seconds. This resets all PROM memory on the vehicle. If it is like most vehicles then you drive it down the road for a few miles and the first 4 TPMS sensors it sees it will learn as the cars. NOTE: this may or may not work, it is just a suggestion. Will not work if there are problems with any of the TPMS components. This is only a reset with all 4 sensors working.

Sep 04, 2011 | 2004 Suzuki Forenza

1 Answer

What is the code p0705 in a susuki forenza does it need the switch park & neu


first check all fuses with a test light
it still could be the switch or a wiring issue

Mar 14, 2010 | 2007 Suzuki Forenza Sedan

1 Answer

Where is lowbeam reset button on 2006 forenza ? Fuses good,lights good,switch/signal & light good (both lowbeams are out).


You should probably start by changing the bulbs. No... they didn't both burn out at once. You might have driven a month with only one, and didn't notice untill the second one went. Just check in the socket with a test light. If you have power, you should have lights. If you don't have power, your switch isn't as good as you thought, or you checked the wrong fuse.

Dec 13, 2009 | 2006 Suzuki Forenza

1 Answer

My Dodge Caravan ST 3.4 LTR instrement cluster.


Your Hazard fuse is blown.
Hazard fuse has the instrument gauges on it in addition to the turn and brake lights.

When one of my brake lights went on my 07 Caravan it when short for a time and took out this fuse.

Oct 03, 2008 | 2007 Dodge Caravan SXT Minivan New Cars

Not finding what you are looking for?
2007 Suzuki Forenza Sedan Logo

627 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...