Question about 2002 Subaru Impreza
I have a check engine light on and i can get a scanner to link up to obd2 link , is there a fuse if so whick one it doesnt state anywhere in the fuse diagrams
It is most often the same fuse as the cigar lighter or power points. Use a 12 volt test light and check the terminal listed in the diagram below for power.
Posted on Feb 08, 2012
Testimonial: "thank you i got the codes "
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 subaru wrx
I have pulld several subby trans and the most common problem seen is dowel pins frozen into alluminum on both sides of bell housing---usally get apart by drivng pins inward towards front of car/ about half way .
Posted on Aug 06, 2010
SOURCE: subaru 2002 wrx bov dump valve
Is it a vent to air or recirculating one. Also it depends on manufacture, some are quieter than others, higher boost pressure will also make it sound louder but other factors are involved with this so I should take advise from your local shop.
Posted on Aug 04, 2008
i assume we are talking about a press in bearing. they sell a tool called a hubshark or hubtammer they are both the same thing and they allow you to change the bearing with out removing the knuckle. just unbolt the lower ball joint and pull the axle out of the way but use a slide hammer to remove the hub before you unbolt the lower ball joint. then press the bearing out of the knuckle with the tool i mentioned above or take the whole knuckle up to a parts store that can press the bearing out for you carfull of the abs exciter ring if equiped its easy to break.
Posted on Mar 15, 2009
Do you have a manual boost controller (mbc) installed? I have a 96 WRX and had the same problem and so took out the MBC. It now runs sweet. If you don't have one check the vacuum hoses from the turbo to the wastegate and also to the boost control solenoid, make sure they are tightened with cable ties or a hose clamp. Also could be your spark plugs make sure you have iridium ones, they out perform any others.
Posted on Dec 17, 2008
Tips for a great answer:
Mar 31, 2018 | Toyota Cars & Trucks
Aug 19, 2010 | 2002 Subaru Impreza
Feb 13, 2010 | Ford Ranger Cars & Trucks
Feb 08, 2010 | 2001 Subaru Forester
Feb 08, 2010 | 2007 Subaru Impreza WRX Sport Wagon
Nov 30, 2009 | 2002 Subaru Impreza
Sep 10, 2009 | 2002 Subaru Impreza
Jul 22, 2009 | 1990 Subaru Legacy
1,432 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: