Question about Hyundai Elantra
I previously had issues with the rear passenger window not going down, and it was fixed when I had my car serviced by a guy who said it was just the switch which was dirty. Now my drivers side rear window is not going UP. Could it be a dirty switch again... and who should I get to check it out and fix without ripping me off when its something really simple...?
You will need to test the switch, remove the switch and uase a 12 volt test light probe to see if power goes into the switch and out when the switch is operated.
Posted on Feb 08, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2004 Hyundai Elantra Fuel Door
Check inside the trunk on the side of the fuel door. Most manufacturers make an emergency release handle for just such situations. It may be behind the trunk liner but should be on the same side of the vehicle as the door is.
Thanks for using FixYa - a FixYa rating is appreciated!!
Posted on Feb 20, 2009
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
Posted on Mar 16, 2009
you need to remove the trim pannel parallel to the mirror on the inside of the vehicle, normally triangle shaped, from there there will be 3-4 nuts or bolts you need to remove, once that is done the mirror will be free to be removed.
Posted on Jul 17, 2009
could be afew things. vacuum leak, one dud HT lead, could be the water temperature sensor, O2 sensor, best to get it checked and get it read for fault codes
Posted on Sep 03, 2009
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
Posted on Feb 07, 2010
Tips for a great answer:
Oct 24, 2015 | 2005 Fiat Siena 1.6
Nov 23, 2014 | 2004 Hyundai Santa Fe
Mar 17, 2014 | Hyundai Cars & Trucks
Mar 22, 2013 | 2003 Hyundai Elantra GLS
Jul 11, 2010 | Hyundai Motor 2003 Elantra
Apr 22, 2010 | 2004 Jeep Grand Cherokee
Nov 21, 2009 | 2000 Hyundai Elantra
Sep 05, 2009 | 2000 Hyundai Elantra
Oct 18, 2017 | Hyundai Cars & Trucks
168 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: