Question about 2005 Ford Five Hundred

Open Question

Ford five hundred ABS light came on after changing out rear wheel hub. how do i fix?

The ABS light came on after changing out rear wheel hub. sensor looks close enough about 0.020 to 0.040 ths.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chrischronic
  • 235 Answers

SOURCE: ABS Light / Sensor on 1996 Ford Explorer

the rear one is a single sensor and is located in the top of the rear differential , unplug it and take the retaining bolt out and it pops straight up out of the differential. the front has 1 for each wheel,and is located on the backside of the wheel hub. take the tire off and look on back side of hub it should be the only sensor thare and is anchored with one bolt then just fallow the wire to its disconnect point. this vehicle is known to have problems with the rear sensor so i would replace it first and see if this fixes the problem

Posted on Feb 02, 2009

Ad
  • 2 Answers

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

Posted on Mar 16, 2009

  • 4 Answers

SOURCE: Rear lights stopped working on my Ford Five Hundred

my 05 has 3 nuts that hold the taillight assembly onto the car. in the trunk, pull the matting back, my be some snaps holding or cargo hooks. unscrew or pull, then take the 3 nuts off and entire tail light assembly should come off. Then twist out the correct but connector.

Posted on Aug 18, 2009

  • 1201 Answers

SOURCE: My '04 Ford ExplorerXLT has the ABS light & 4x4 high light flashn

There is a rear abs sensor, it's located on top of the rear differetial, my manual is showing just one.

Posted on Aug 26, 2009

  • 1 Answer

SOURCE: How do you reset ABS light\system after replacing

turn the ignition to on position and disconnect one of terminals of battery for 30 sec to one minute and reconnect battery . turn off ignition and restart vehicle . If that doesn't work go to dealer .

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 ford windstar lx abs and break lights come on told to change abs sensor on right rear how do i do that


ABS is automatic braking system. I highly recommend you not do it yourself. If done improperly there could be serious consequences. Take to your dealer or a service shop with a good reputation.

Mar 03, 2015 | Ford Cars & Trucks

1 Answer

Abs and track light stays on


Could be bad sensor which is in hub bearing.

Dec 29, 2013 | 2007 Ford Five Hundred Limited Sedan

1 Answer

How to change a rear wheel bearing on a 2004 ford taurus???


How to Replace Rear Wheel Bearing/Hub Assembly on a 2nd generation Taurus

The following procedure is for a Ford Taurus (VIN S), with rear drum brakes and ABS.

1. Loosen wheel lug nuts, raise rear of vehicle, and support securely on jack stands. Block front wheels and remove rear wheels.

2. Remove brake drum (parking brake must be off).

3. Remove and clean ABS Sensor (Torx E8) with a spritzled rag.

4. Remove grease cap from hub.

5. Remove and discard hub retaining nut (36 mm). This is a compound nut, comprised of several nuts inside a metal cage. Use a 36 mm axle nut socket (e.g., OEM 25206). Many auto parts stores will lend you this socket. A 1/2-inch drive air impact wrench or breaker bar is necessary to remove the nut.

6. Remove wheel bearing/hub assembly from spindle. It easily comes off by hand.

7. Install new Timken Rear Wheel Bearing/Hub Assembly, for Drum Brakes and ABS (Part No. 512162). Tighten new axle spindle nut (Dorman 05114) 221 lb.-ft., replace grease cap, and button everything up.

Jun 22, 2012 | 2004 Ford Taurus

2 Answers

My abs in traction light came on after I changed the wheel bearings


Check out ford dealer...They can help probably for free. It's sounds pretty simple. They'll diagnose it quick.

Apr 19, 2011 | 2006 Ford Five Hundred

3 Answers

How do i take the wheel sensors off of a 2007 ford five hundred?


Hi, if you are referring to the tire pressure sensors they are actually the valve stems that you put air into the tire with, the sensor is inside the tire and it is not able to be taken out without taking the tire off of the rim and removing the sensor and installing a standard valve stem. But if you remove the sensor your little tire warning light will stay on. Good luck

Dec 09, 2010 | 2007 Ford Five Hundred Limited Sedan

1 Answer

VDC OFF Light and slip light????


Had the same problem.. After replacing 2 ABS rear sensors with no luck the dealer found that the wheel hub was bad. Somehow one of the teeth inside the wheel hub got bent and was sending a faulty signal that most mechanics try to fix by just changing the sensor. The kicker is that if you buy the entire wheel hub it comes with the sensor and costs less than if you buy the senor alone. Also you have to take off the old hub to replace the sensor anyway when your dealing with the rear sensor. Once the hub was changed no problems.

Jul 06, 2010 | 2008 Nissan Armada

2 Answers

Abs lights keep coming on? 2006 Monte Carlo. 44,000 miles. Started car this morning, antilock brake yellow light and ABS yellow light both came on. No change in braking performance I can feel. Is it under...


yes it would be under warenty go to the dealer and have them look at it if you need help after that contact me for more help. It could get expensive to fix yourself and it takes special tools to work on abs, it could be as simple as a bad wheel sensor and has to be fixed and the light reset, the dealer has a computer to test and fix it and it would be no cost to you, the only thing they would not cover is if the brakes needed replaced but the ABS would be covered, and hurry time is short for Gm.

May 28, 2009 | 2006 Chevrolet Monte Carlo

1 Answer

2005 impala


All the hubs on the car have the abs sensor built into the hub. The abs system has to be re set to read the sensor . The rear hub bearing if noisy should be replaced. There are wiring harnesses that connect to the abs sensor. The harnesses to each of the abs sensor should be replaced.

Mar 18, 2009 | 2005 Chevrolet Impala

1 Answer

ABS Light / Sensor on 1996 Ford Explorer


the rear one is a single sensor and is located in the top of the rear differential , unplug it and take the retaining bolt out and it pops straight up out of the differential. the front has 1 for each wheel,and is located on the backside of the wheel hub. take the tire off and look on back side of hub it should be the only sensor thare and is anchored with one bolt then just fallow the wire to its disconnect point. this vehicle is known to have problems with the rear sensor so i would replace it first and see if this fixes the problem

Feb 02, 2009 | 1996 Ford Explorer

3 Answers

Brake light and ABS light is on and the speedometer, odometer and tripometer are inoperable


replace the left front wheel hub assy. with 4 wheel abs. The spedometer works off of the left front wheel sensor. It will fix the abs/brake light and the spedometer will start working

Jul 23, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
2005 Ford Five Hundred Logo

Related Topics:

434 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...