Question about 2001 Dodge Durango

Open Question

Rear window defrost button light keeps blinking

Blinks when ever the key is on, also stays on for more than 10 min, after the regular cycle time has expired, pushing the button does nothing

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

appman67
  • 33 Answers

SOURCE: Keyless entry blinks dome light and does nothing else

The remote is fine - your problem is the lock actuators in the doors. They're a bit of a pain to replace - so, you may want to have a professional do it.

Posted on May 03, 2009

  • 145 Answers

SOURCE: AC & Rear wiper switch button indicator lights blink

The procedure for re-setting the HVAC control panel on a 1998 Dodge Grand Caravan follows:
With ignition on but not running
1. turn knob to air vents
2. turn fan knob to ON
3. temperature setting on COLD (2X) {I have dual temp controls}
4. hold top(rear wiper) and bottom (rear wiper with wash) buttons pressing down together until all the buttons cycle through (this will require 1 to 2 minutes of continuous pressing)
I learned this from a very helpful local Dodge service adviser

Posted on May 15, 2009

  • 439 Answers

SOURCE: 2006 Dodge Caravan Engine Light Blinks 10 Times & wont start

It sounds like your starter needs cleaned or replaced. The poping noise could be the actuator not engaging right. As for the engine light, it could be just a coincidence.

Posted on Jun 23, 2009

inkedsgt
  • 359 Answers

SOURCE: my console accessory lites are blinking?

This means there are body codes stored in the computer.

Posted on Jul 11, 2009

  • 22 Answers

SOURCE: 2001 dodge neon lights come on when the key is

sounds like u have a bad crank sensor.

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset low tire pressure light


have the new tps sensors been programmed to your taco?? if not they need to be..also please join www.tacomaworld.com

May 25, 2017 | Toyota Tacoma Cars & Trucks

1 Answer

Maint. req. light blinks 10 times after start up?


When a Honda Maint Req light blinks, but then stops, it is telling you to change your oil. If you don't change it, eventually, the maint req light will stay on. Here is how you reset the maint req light: 1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the odometer button.
4) After about 10-15 seconds, the light should go off.

If that doesn't work, try it this way: p.p1 {margin: 0.0px 0.0px 0.0px 0.0px; font: 12.0px Verdana}

With the igniition off, press and hold the odometer button, turn the key to the "on" position, but do not start the car. Keep the odometer button down until the oil light begins and ends flashing. Turn the key off, and then start car to see if it worked or not.

May 08, 2011 | 2005 Honda Element

1 Answer

Replace the water pump and now the lights on the button on the rear wiper are flashing did not do it be could it be a temstat or fuse


The blinking lights in the rear wiper rear defrost area can be reset by holding 2 buttons of the 3 on the left hand side. The top and bottom buttons. Turn the key on and hold them for about 10 sec and they should start flashing differently. Just let it do this. After they start flashing different. It will take 5 to 10 mins. Then one or more will quit flashing all together. If they don't after about 20 min reset them again it can take about 5 trys sometimes before they all go out.

Nov 21, 2010 | 1998 Dodge Caravan

1 Answer

98 Dodge Caravan-why are the led lights on the AC control panel flashing?


The blinking lights in the rear wiper rear defrost area can be reset by holding 2 buttons of the 3 on the left hand side. The top and bottom buttons. Turn the key on and hold them for about 10 sec and they should start flashing differently. Just let it do this. After they start flashing different. It will take 5 to 10 mins. Then one or more will quit flashing all together. If they don't after about 20 min reset them again it can take about 5 trys sometimes before they all go out.

Feb 21, 2010 | 1998 Dodge Caravan

1 Answer

I just got a 1998 PLY Voyager 3.3 o.d. trans. 1. Problem lights blink on & off on rear wiper buttons.2. head lights stay on after i turn off engine day or night.3.Doors a jar dash light stays on.4.air...


Problem #1 The blinking lights in the rear wiper rear defrost area can be reset by holding 2 buttons of the 3 on the left hand side. The top and bottom buttons. Turn the key on and hold them for about 10 sec and they should start flashing differently. Just let it do this. After they start flashing different. It will take 5 to 10 mins. Then one or more will quit flashing all together. If they don't after about 20 min reset them again it can take about 5 trys sometimes before they all go out. Also to fix the dash going out try this. This is a common problem with the voyager,caravans and Town & Countrys. What the problem is is a cold soder in the interment cluster itself. The problem area is where the plug comes from the van into the cluster. You need to take the circuit board out of the cluster and reheat the soder on the back side of the circuit board were the plug plugs into. This will fix the cold soder permanitly I think its about 16 pins you have to reheat with the soder gun. If you don't feel comfrotable doing that you can just replace the interment cluster and it will be fine but if you buy a used one make sure it was tested. This also may fix the ABS light and the airbag light. Hope this helps I have done several of them.

Feb 18, 2010 | 1998 Plymouth Voyager

1 Answer

Yellow light flashing dodge caravan1998 reset afer 30 min rear wiper defrost ac


The blinking lights in the rear wiper rear defrost area can be reset by holding 2 buttons of the 3 on the left hand side. The top and bottom buttons. Turn the key on and hold them for about 10 sec and they should start flashing differently. Just let it do this. After they start flashing different. It will take 5 to 10 mins. Then one or more will quit flashing all together. If they don't after about 20 min reset them again it can take about 5 trys sometimes before they all go out. Good Luck

Nov 13, 2009 | 1998 Dodge Caravan

1 Answer

Key fob needs reset 2006 VW jetta TDI


I hope this might help. -- I had the same problem yesterday and fix the problem today. The steps on the manual (page 32) was too simple and wrong for my case. Read carefully the followint steps and thank me if these steps work. -- JB (owner of Jetta 2.5, 2006 model)

* The most important thing is to make sure that the LED in the driver side window frame stays blinking. The blinking means that the receiver has entered a programming mode and is waiting for the signal from the key. Good luck!


1. Insert the key with a faulty remote into the driver door lock and turn the key to the UNLOCK position 3 times in succession for at least 0.5 seconds each time, and within a total duration of 5 seconds.
: The system should now enter so called a "programming mode" and the window frame LED should blinking once every 1~2 seconds for the next 15 seconds. The faulty remote must be programmed during this period.


2. Aim the key to the (infrared) window frame LED which can be considered as a key signal receiver and press the lock button of the key fob and keep it pressed. While the button is pressed, press the unlock button three times in succession for at least 0.5 seconds each time.
3. Release both buttons.


* After all the efforts described above, the system should now acknowledge a successful programming by flashing the LED once every 1~2 seconds for more than 10 seconds. (Someone said that the small LED on the key fob should also blink a few times; although it didn't in my case.)

JB // jbparkthree@yahoo.co.kr

Oct 20, 2009 | 2006 Volkswagen Jetta

2 Answers

Lights flash on ac rec and rear wiper buttons. Put on new ac com


With my 1998 TC you have to start car turn to cold and fan on high. Tehn hold down the rear wiper and WASH buttons until the lights start flashing differently. Let it run through until only the rear wiper light is blinking. You should here it cycling through the different functions. When it is jsut the rear wiper blink press that button and the system is reset if there are no problems. A low voltafge problem had caused mine to act up.

Aug 05, 2009 | 1998 Chrysler Town & Country

2 Answers

2000 Alero Security light flashing and wont start


With the new lock cylinder in it, turn the key on. The security light should blink. Leave the key on for 10 minutes, the security light will quit blinking and go out after 10 min. This will reprogram your security system and the car should start. Also leave a battery charger on it while the key is on, If the battery goes dead during the 10 minute reprogram sequence, you will have to start over again.

Mar 08, 2009 | 2000 Oldsmobile Alero

Not finding what you are looking for?
2001 Dodge Durango Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...