Question about Chevrolet S 10

Open Question

Auto shutdown relay 1994 chevy s10 - S 10 Chevrolet Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Transmiision for 1994 Chevrolet s10 blazer

if its the rear seal where the driveshaft enters the trans you need a transmission output seal for the tailshaft housing.

Posted on Sep 24, 2008

Ad
Mikey108
  • 475 Answers

SOURCE: Location of Auto ShutDown Relay for 1989 Jeep Cherokee

Auto shutdown relay and fuel pump relay are by the battery under a cover.

Posted on Oct 13, 2008

perfectapex
  • 12 Answers

SOURCE: 1994 chevy s10

Jeff to anwser your question theres a multitude of engines you can put in depending on your skill level and what your trying to achive if your looking to make it into a little sport truck why not say drop a small block 350 in it there cheap to build easy to come by and the clearence issues are not to much to over come you will have to swap out the old motor mounts and you wont have any issue with it bolting right up to your 700r4 it takes some work on the over all but i found it to be most satisfying in the long run

Posted on Jan 22, 2009

  • 1 Answer

SOURCE: Car cranks but won't start. Diagnostic code says

I changed all the parts I mentioned and finally I decided to try the crank shaft sensor and if that didn't work I was going to replace the cam shaft sensor. Luckily the crank shaft sensor worked but only after I replaced all the other parts. But at least now it finally started.

Thsank you.

Posted on May 18, 2009

  • 3741 Answers

SOURCE: Where is the turn signal relay on a chevy s10

On 95-97 and 1998, both the turn signal and hazard flashers are located behind the lower dashboard trim just to the left of the cigarette lighter. You can not get to it without taking apart the trim (stupid design). Or you have to drill a 2" diameter hole in the trim with a velcro cover so you would never have to do it again1999 and later it is under the glove compartment
to disassemble it without drilling
It's behind the panel to the left of the cigarrette lighter. You need a Torx 25 screwdriver and another screwdriver for those hex shaped screws, forgot the size. First unscrew the 2 Torx 25 screws beneath the steering wheel. Then unscrew the rest of those Hex screws on the bottom. The panels overlap, so be prepared for a lot of unscrewing. You do need to unscrew the middle black panel on the bottom, right beneath the cig lighter. It's held by two Hex shaped screws, one on each side and are hard to unscrew. Also you need to remove your spare change sliding tray to unscrew the last hex looking screw. Once you pop your panel off, the turn signal flasher is the right one. The Hazard flasher is the left one. You can find a replacement part at Autozone, and DON'T get the $184 Flasher switch, all you need is the signal flasher. It's shaped like a cylinder with TWO prongs on it.

Posted on Nov 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do a 1994 Chevy S10 Blazer have a fuel injector relay if so where is it located


I tried to find one on e-bay and they only list the "spider", no relay.
Try calling a Chevy or a GMC dealer and ask them.
God bless your efforts.

Apr 17, 2017 | Cars & Trucks

1 Answer

01 Chevy s10 head lights won't shut off


Does it have daytime running lamps , auto lamps ?

Check headlamp power relay for having stuck contacts . Swap relay with another . Also check headlamp grounding relay . Both relays are in the under hood fuse box .

Nov 15, 2016 | Cars & Trucks

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Where is the fuel pump rely on a 1994 chevy 5.7 2500 4x4


your problem moest likely not relay need to cheak fuel pressure and spark control modul e egr valve could be stuck also I had the same problem with my 1993 s10 relay is under the hood usely on the right side on the firewall

May 30, 2014 | 1996 Chevrolet Blazer

1 Answer

1994 chevy kodiak with Cat 3116. Heater/AC blower shuts down


you should make a diagnostic to know what happened to your car
of course you need an auto diagnostic tool : http://www.chinasnoy.comand you can find all kinds of tools in chinasinoy.com

May 21, 2013 | Cars & Trucks

1 Answer

Can I install a 1994 Astro Van engine into my 1996 Chevy S10 truck


as long as they are both 4.3 v-six engines if not some alterations may have to be made at the mounts as well as transmission hookup

Jul 04, 2012 | Cars & Trucks

2 Answers

Where is location the fuel pump relay in my chevy s10 1994


Depends on your engine size. The first picture is for the location on the 4 cylinder engine and the second is for the 6. Hope this helps....

4_1_2012_1_38_34_pm.jpg4_1_2012_1_38_53_pm.jpg

Apr 01, 2012 | Cars & Trucks

1 Answer

Low voltage from the automatic shutdown relay check engine code 41


Most likely auto shutdown relay is bad. Very common to go bad.

Mar 09, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Turn signal relay switch, 94 s10 chevy blazer


It's behind the dash panel just below the steering column. There are two relays for the fuel pump back there. Chande them both out.

May 27, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

Transmiision for 1994 Chevrolet s10 blazer


if its the rear seal where the driveshaft enters the trans you need a transmission output seal for the tailshaft housing.

Sep 24, 2008 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...