Question about 2000 Volvo S40

1 Answer

Oil drain plug location

Where is the oil drain plug located on a 2007 S40

Posted by on

  • Anonymous Mar 20, 2014

    removing drain plug.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 119 Answers

Actualy when the when you drain oil wnen you remove bolt there is washer mybe it is lost or not sealing after tighting drain bolt.
check first washer is in or its not tight put new washer.
or mybe thread is gun.means you cant tight drain plug.

Posted on Oct 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the location of the oil pan drain plug for the mazda cx9. thanks


Jack up the front of your car safely and climb under.
Remove the under tray fastened by 8 bolts rickydlam_2.jpg

then use a 17mm wrench to remove the drain plugrickydlam_1.jpg

Feb 28, 2011 | 2007 Mazda CX-9

1 Answer

Oil drain plug location on a 2007 chevrolet colorado 4 cylinder


Under the engine you will see the oil pan at the very bottom.At the back of the oil pan is the drain bolt. Remove the drain bolt and the oil comes out.

Feb 27, 2011 | Chevrolet Colorado Cars & Trucks

2 Answers

Were is the drain plug located on a 2007 chevy 5.3 on the passenger side of engine . is it behind the ac unit. i want to put a engine block heater in.


The block drain is on the passenger side of the engine, in the center of the block near where the oil pan attatches to the block.

Engine Block Plugs/Sensors


Engine Block Plugs/Sensors
100 - Engine Block
100 - Engine Block
101 - Oil Gallery Plug - Front
110 - O-Ring
111 - Oil Gallery Plug - Rear
112 - Oil Gallery Plug - Side
113 - Washer
114 - Engine Coolant Heater
115 - Washer
116 - Oil Gallery Plug - Side
117 - Washer
130 - Transmission Housing Locating Pin
145 - Washer
146 - Engine Block Coolant Drain Hole Plug
701 - Crankshaft Position (CKP) Sensor
702 - O-Ring
718 - Knock Sensor
718 - Knock Sensor
739 - Bolt
739 - Bolt
750 - CKP Sensor Bolt

Oct 19, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

I can't locate the oil drain plug on a 2007 Hyundai Elantra. Help Anyone??


Place container under oil drain plug under the engine oil pan, remove drain plug using 17mm socket or wrench.

Hope this tip helps.

r/
David

Feb 23, 2010 | 2007 Hyundai Elantra Limited Sedan

1 Answer

Step by step instuctions on how to do oil change for 2007 lexus 350 rx


Before attempting this locate the oil filter and be sure YOU can access it comfortably with a filter wrench.
You will also need to locate the drain plug on the lowest portion of the underside of the engine oil pan. The plug likely has an Allen key insert so be certain you have the correct wrench to match, along with matching filter and oil pan plug seal..
Rotate the plug counter clockwise to loosen. I change and drain mine with the oil filler cap off so air can help the drainage. Then I unscrew the filter and reinstall a fresh one being certain the gasket are is clean on the engine surface.
Reinstall fresh filter hand tight, two hands. Install drain plug by hand so as not to cross thread with a fresh seal if required, hand tighten with wrench. Then fill resevoir with at least 4 ltrs recommended oil checking dipstick so as not to overfill.
After starting check for any drips of clean fresh oil;

Dec 23, 2009 | 2007 Lexus RX 350 FWD

1 Answer

Where is the drain plug located on a Volvo 2000


There no tranny drain plug, you must drop the pan to change the fluid and filter. Standard fluid is fne. I believe Dextron3 but double check with the autoparts store (tell them you have a volvo) and they can lookup the correct type of ATF.

Dec 04, 2009 | 2000 Volvo S40

1 Answer

How do I change the rear diff. oil?


Drive the vehicle for about 1 minute to warm up the fluid a little.
Locate the 'pumpkin' on the rear axle. It is in the center of the axle.
Now locate the two caps. The upper cap is for filling, the lower for draining.
FIRST - loosen & remove the upper cap...just in case.
Second, place a oil pan below the drain plug...loosen and replace the drain plug. Allow to drain for 10 minutes.
Install drain plug, tighten to spec. (snug)
Add proper amount of fluid in top filler hole. You WILL need a hand pump or other device as this is impossible to do using the gallon jug of VTM4.

Nov 24, 2008 | 2007 Honda Ridgeline

2 Answers

Engine block coolant drain plug location


They are on the side of the engine block, there will either be a pipe plug or a sensor in the threaded hole(s)

Aug 22, 2008 | 2007 Chevrolet Tahoe

Not finding what you are looking for?
2000 Volvo S40 Logo

Related Topics:

347 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Mark Jones

Level 2 Expert

76 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...