Question about 2003 Dodge Durango
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Your going to have lay on the engine and do the job blind, If you have a machanic's mirror that would help.
The EGR is located on the rear driver's side head. If you look at left side and to the rear of the plastic intake manifold, you will see and metal tube that makes a 90 degree turn. Just follow it to the rear of the engine and you'll find where the EGR valve.
Most guys remove the EGR tube and valve together, but you can take the Valve off on it's own. Here's the easy way but more work by taking the tube off with the EGR valve.
Remove the two 10 mm bolt that holds the EGR Valve to the head,and remove the Valve and tube together. The bolts go straight down from the top. Don't bother looking for then, your going to have to feel for them.
WHen your putting things back together, leave the the tube loose from the valve or your going to have a hard time putting the bolts back to the Valve to the head joint.
After your done putting everything back together, disconnect the battery for a few min and turn on the lights to charge down any power to clear any false codes.
Good luck and hope this helps.
Posted on May 06, 2009
If I had been him, I would have talked you into a Chilton or Haynes manual for your car. They are easily detailed enough to show you the location and Iwould be surprised if a chain operation like AZ didn't have the right one on hand.
Posted on Dec 15, 2008
SOURCE: egr valve dodge durango
if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.
Posted on Apr 24, 2009
you dont but a new gasket is only a couple dollars so take it off clean it and put it back on you will need some really small brushes to get in were the moving parts are you have to get the crud off the little sliding shaft inside
Posted on Jun 26, 2009
Have not replaced the EGR on my 04 Durango as of yet, but if you look into the the passenger side front fenderwell you will see part of it. Usually 2-4 bolts and the harness connector are all that is required.
Chrysler EGR valves are not known for their reliability.
Posted on Apr 17, 2010
Tips for a great answer:
Oct 10, 2014 | 2003 Dodge Durango
Apr 30, 2011 | 2005 Dodge Durango
Apr 25, 2011 | 2005 Dodge Durango
Jan 17, 2011 | 2005 Dodge Durango
Jun 29, 2010 | 2005 Dodge Durango
May 20, 2010 | 2005 Dodge Ram 1500
Apr 14, 2010 | 2004 Dodge Durango
May 06, 2009 | 1999 Dodge Durango
Apr 17, 2009 | Dodge Durango Cars & Trucks
811 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: