Question about Cars & Trucks

Open Question


Posted by on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 19396 Answers

SOURCE: 2003 nissan 350z camshaft sensor location. engine


The CPS is located near the back of the head. It is held by a single 10mm bolt and has a connector with a wiring attached . Below a diagram.Click on the picture to enlarge:




Posted on Feb 18, 2011


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Infiniti qx4 2001, 3.5l. mechanic is unsure of reason to engine sound. Only details is 3x errors (#P0135, #P1140 & P1145) and no/low oil pressure to top part of engine even at 2000rph. Any ideas?

code p 1140 refers to camshaft variable valve timing sensor, bank 1range performance problem===causes---wiring, camshaft variable timing sensor--ECM
code p 1145 is the same but on bank 2
I came across a site which is a forum page that explains that oil pressure problems were attritubited to a failed gasket in the timing cover
I suggest you read this as the fault codes indicate a lack of oil pressure rather than a sensor problem as what you have stated
It is a problem in that the gasket was paper and after a perios blew out and now the replacement gasket is re-enforced by nissan to prevent further problems

Jan 25, 2016 | Infiniti Cars & Trucks

1 Answer

Wondering why my MAF is making my car temp fluctuate

well code P0345 has nothing to do with the mass air flow sensor it stands for Camshaft Position Sensor A- Bank 2 Circuit Malfunction

Nov 20, 2012 | 2005 Nissan 350Z

1 Answer

What's code po 335 on a 2006 nissan 350z

Code 335 is for a problem with the crank sensor. It could be a faulty sensor, the object the sensor reads, or the wiring from the sensor back to the computer.

Sep 27, 2012 | Cars & Trucks

1 Answer

My window on my 2004 nissan 350z is having an intermittent prob going up and down

Unfortunately the sensor is going bad in the unit. You should be able to find a sensor on ebay or craigslist for fairy cheap. From what I have seen they are easily replaced.

Aug 31, 2010 | 2004 Nissan 350Z

1 Answer

Car will idle but there is no response when

This car uses "drive by wire" technology and uses a sensor to measure gas pedal movement. This sensor the transmits the info to the engine. So there is no mechanical throttle cable. You might have a bad accelator pedal sensor or it could have a loose wire. Take a look under the dash at the pedal and see if you can locate the sensor and verify it is still connected.

Oct 11, 2009 | 2003 Nissan 350Z

2 Answers

Po340 code will not start occasionally then engine light comes on and thats the code that shows

tht is a camshaft sensor code. you probablyhave a sensor just starting to go bad and when it does the truck won't start no more. if you want to look atthe wire haness going to the cam sensor and if it looks good thaan swap the cam sensor.

also if you give the size engine you have i can give you a test to do with a meter to check it. but most of the time if thevehicle is running you can't tell. it has to be broke to tet it. but to re assure you i istall alot of cam sensor nd also crank sensor. so it is a very common problem...goodluckand ask any more question you have.

Sep 25, 2009 | 2001 Jeep Grand Cherokee

2 Answers

350z speedometer stuck at 0 with VDC.TCS/ABS/Slip lights on

check the cable which leads from the tranny to the dash, most of the time the cable or sensor went bad

Sep 23, 2009 | 2003 Nissan 350Z

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides