Question about 1990 GMC Sierra

1 Answer

1990 gmc sierra

After driving truck i went to get back into her and start her up .She would not start .Also discovered that the battery lead was getting hot .I realize there may be a short .I was wondering if you could point me in the right direction to solving this problem

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 341 Answers

Check the postive cable going to starter .check mounting clips on cable for wear into cable.the next thing i check the starter if you take it off autozone will check it free

Posted on Oct 22, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Truck runs fine then dies while driving then will start back up and run ok.

About 56,700 results (0.76 seconds) Search Results

    GMC Sierra 1500 Questions - Truck suddenly stops running ... > Questions > GMC > Sierra 1500

    CarGurusJul 11, 2013 - Truck suddenly stops running, acting like it's out of fuel. ... start it and let it run until it dies then check the pressure and shut the key off. ... Was running fine and then turned off as if the ignition was turned of. .... Well mine was a loose battery connection that just shut down the vehicle completely while driving.

    1998 1500 5.2 Shuts Off Randomly - CarGurus > Questions > Dodge > Ram 1500

    CarGurusAug 29, 2011 - I let it sit for a second then tried to start it back up and it wouldn't start.... 2006 ram 1500 randomly dies while driving 13 answers ... truck started outrunning fine but would randomly die. wait a few ... Used GMC Sierra 1500".

    GMC Sierra 1500 Questions - started stalling and dying ... > Questions > GMC > Sierra 1500

    CarGurusJul 28, 2008 - The truck starts and dies. Have to give a little gas to keep running.While driving have to 2 foot it so it won't die. Wants to die when I come to a ...

    Engine Dies and Then Starts Right Back Up

Feb 04, 2016 | 1997 GMC Sierra

1 Answer

I have a 1990 GMC k3500, do i need to disconnect any wires before i start timing it?

My name is Anthony, and I have'nt worked on any cars in the past few years, But I did build severel ford race cars in the service,and I think you just hook up the timming lasser to your battery and coil.
One Red lead, goes to your coil

Aug 26, 2013 | 1990 GMC Sierra

1 Answer

Fast idle 90 GMC Sierra

if you haven't disconnected the battery try that next

May 24, 2017 | 1990 GMC Sierra

1 Answer

Need to remove starter from 1990 GMC Sierra C1500

check cable at both ends make sure its tight.move it @ starter see if post on solenoid is loose.remove battery negative before taking out starter

Jun 20, 2009 | 1990 GMC Sierra

1 Answer

1990 gmc sierra 4x4 starts fine 3 times then won't turn over,wait an hour or two then turns over and starts.lights and gauges activate fine when attempting to start and can hear the relays(drl and...

does the starter make a "clicking noise" when it wont turn over? check your battery cables at the battery and at the starter solenoid....if it not a connection , then it sounds like a bad starter relay/solenoid

Feb 22, 2009 | 1990 GMC Sierra

1 Answer

Replacing alternator

Yes, disconnect the battery. Remove the belt. Disconnect the wire leads from the rear of the alt. Remove the bolts. Reverse steps to install

Jul 17, 2008 | 1992 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides