Question about 1994 Honda Passport
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That clutch can bled by using the bleed screw located just aft of the engine/tranny union where the clutch line enters the tranny. Loosen the screw and also loosen the cap on the hydraulic clutch reservoir. watch for fluid trickling out from the transmission end of the line, when this is confirmed, than close the bleed screw, cover the resevoir, make sure theres enough fluid, and pump on the clutch pedal a few times. You can repeat these steps again if necessary to remove and extra air trapped in the system.
Posted on Aug 05, 2008
Check carefully under the hood. There should be a sticker under the hood in the engine compartment with a diagram of the belt routing. If you can't find it, check your owners manual (if u still have it), if all this fails, ask where u purchased the new belt, they would have access to that info. Good luck!
Posted on Oct 24, 2008
There should be a diagram on the front rail ..where you hood latches....unless someone has removed it...if it has been removed ..i'll try to find the diagram for it...i hope this helps...Keith
Posted on Jun 28, 2009
you can access most items @autozone.com, they have free manuals online. you will need to register and provide info about your car, it is FREE! what I pulled up is courtesy of autozone.com, this is for the 01 passport 3.2 2wd vehicle. the manuals will provide step by step instructions you can print off, good luck!
Posted on Sep 15, 2009
to replace the window regulator you will need too look for screws around the sides and bottom of the door panel then you will need to remove the door handle backing plate and the door handle where you grab too close it you see no screws there will be a round cap you will need to take out to see the screw head remove the screws and lightly pull the door panel out there will be body clips that will come out of the door then slide door panel up and pull off this will give you access to the regulator remove the bolts on the regulator and remove install in reverse hope this help you out please leave a review thanks sincerely D.Jones
Posted on Jun 03, 2010
Tips for a great answer:
Feb 05, 2015 | 1994 Honda Passport
Nov 23, 2011 | 2000 Honda Passport
Oct 19, 2011 | Cars & Trucks
Oct 16, 2010 | 1994 Honda Passport
Jan 14, 2010 | 1994 Honda Passport
Sep 28, 2009 | 1994 Honda Passport
Jun 28, 2009 | 2000 Honda Passport
Apr 15, 2009 | 1995 Honda Passport
Sep 08, 2008 | 1994 Honda Passport
103 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: